1. |
- Niemi, MEK, et al.
(author)
-
- 2021
-
swepub:Mat__t
|
|
2. |
- Kanai, M, et al.
(author)
-
- 2023
-
swepub:Mat__t
|
|
3. |
|
|
4. |
- Wang, HD, et al.
(author)
-
Global, regional, national, and selected subnational levels of stillbirths, neonatal, infant, and under-5 mortality, 1980-2015: a systematic analysis for the Global Burden of Disease Study 2015
- 2016
-
In: Lancet (London, England). - : Elsevier. - 1474-547X .- 0140-6736. ; 388:10053, s. 1725-1774
-
Journal article (peer-reviewed)
|
|
5. |
|
|
6. |
|
|
7. |
|
|
8. |
|
|
9. |
|
|
10. |
|
|
11. |
- Abel, I, et al.
(author)
-
Overview of the JET results with the ITER-like wall
- 2013
-
In: Nuclear Fusion. - : IOP Publishing. - 1741-4326 .- 0029-5515. ; 53:10, s. 104002-
-
Journal article (peer-reviewed)abstract
- Following the completion in May 2011 of the shutdown for the installation of the beryllium wall and the tungsten divertor, the first set of JET campaigns have addressed the investigation of the retention properties and the development of operational scenarios with the new plasma-facing materials. The large reduction in the carbon content (more than a factor ten) led to a much lower Z(eff) (1.2-1.4) during L- and H-mode plasmas, and radiation during the burn-through phase of the plasma initiation with the consequence that breakdown failures are almost absent. Gas balance experiments have shown that the fuel retention rate with the new wall is substantially reduced with respect to the C wall. The re-establishment of the baseline H-mode and hybrid scenarios compatible with the new wall has required an optimization of the control of metallic impurity sources and heat loads. Stable type-I ELMy H-mode regimes with H-98,H-y2 close to 1 and beta(N) similar to 1.6 have been achieved using gas injection. ELM frequency is a key factor for the control of the metallic impurity accumulation. Pedestal temperatures tend to be lower with the new wall, leading to reduced confinement, but nitrogen seeding restores high pedestal temperatures and confinement. Compared with the carbon wall, major disruptions with the new wall show a lower radiated power and a slower current quench. The higher heat loads on Be wall plasma-facing components due to lower radiation made the routine use of massive gas injection for disruption mitigation essential.
|
|
12. |
- Aebi, S, et al.
(author)
-
Differential efficacy of three cycles of CMF followed by tamoxifen in patients with ER-positive and ER-negative tumors: Long-term follow up on IBCSG Trial IX
- 2011
-
In: ANNALS OF ONCOLOGY. - 0923-7534. ; 22:9, s. 1981-1987
-
Journal article (peer-reviewed)abstract
- Abstract: Background: The benefit of adjuvant chemotherapy in postmenopausal patients with estrogen receptor (ER)positive lymph node-negative breast cancer is being reassessed. Patients and methods: After stratification by ER status, 1669 postmenopausal patients with operable lymph nodenegative breast cancer were randomly assigned to three 28-day courses of 'classical' CMF (cyclophosphamide, methotrexate, 5-fluorouracil) chemotherapy followed by tamoxifen for 57 months (CMF/tamoxifen) or to tamoxifen alone for 5 years. Results: ERs were positive in 81% of tumors. At a median follow-up of 13.1 years, patients with ER-positive breast cancers did not benefit from CMF [13-year disease-free survival (DFS) 64% CMF/tamoxifen, 66% tamoxifen; P = 0.99], whereas CMF substantially improved the prognosis of patients with ER-negative breast cancer (13-year DFS 73% versus 57%, P = 0.001). Similarly, breast cancer-free interval (BCFI) was identical in the ER-positive cohort but significantly improved by chemotherapy in the ER-negative cohort (13-year BCFI 80% versus 63%, P = 0.001). CMF had no influence on second nonbreast malignancies or deaths from other causes. Conclusion: CMF is not beneficial in postmenopausal patients with node-negative ER-positive breast cancer but is highly effective within the ER-negative cohort. In the future, other markers of chemotherapy response may define a subset of patients with ER-positive tumors who may benefit from adjuvant chemotherapy.
|
|
13. |
|
|
14. |
|
|
15. |
|
|
16. |
|
|
17. |
|
|
18. |
- Kellerborg, K, et al.
(author)
-
Disease burden attributed to alcohol: How methodological advances in the Global Burden of Disease 2013 study have changed the estimates in Sweden
- 2016
-
In: Scandinavian journal of public health. - : SAGE Publications. - 1651-1905 .- 1403-4948. ; 44:6, s. 604-610
-
Journal article (peer-reviewed)abstract
- Aim: The Global Burden of Disease (GBD) study continuously refines its estimates as new data and methods become available. In the latest iteration of the study, GBD 2013, changes were made related to the disease burden attributed to alcohol. The aim of this study was to briefly present these changes and to compare the disease burden attributed to alcohol in Swedish men and women in 2010 using previous and updated methods. Methods: In the GBD study, the contribution of alcohol to the burden of disease is estimated by theoretically assessing how much of the disease burden can be avoided by reducing the consumption of alcohol to zero. The updated methods mainly consider improved measurements of alcohol consumption, including less severe alcohol dependence, assigning the most severe injuries and removing the protective effect of drinking on cardiovascular diseases if combined with binge drinking. Results: The overall disease burden attributed to alcohol in 2010 increased by 14% when using the updated methods. Women accounted for this overall increase, mainly because the updated methods led to an overall higher alcohol consumption in women. By contrast, the overall burden decreased in men, one reason being the lower overall alcohol consumption with the new methods. In men, the inclusion of less severe alcohol dependence resulted in a large decrease in the alcohol attributed disease burden. This was, however, evened out to a great extent by the increase in cardiovascular disease and injuries. Conclusions: When using the updated GBD methods, the overall disease burden attributed to alcohol increased in women, but not in men.
|
|
19. |
|
|
20. |
|
|
21. |
|
|
22. |
- Romanelli, F, et al.
(author)
-
Overview of the JET results
- 2011
-
In: Nuclear Fusion. - : IOP Publishing. - 1741-4326 .- 0029-5515. ; 51:9
-
Journal article (peer-reviewed)abstract
- Since the last IAEA Conference JET has been in operation for one year with a programmatic focus on the qualification of ITER operating scenarios, the consolidation of ITER design choices and preparation for plasma operation with the ITER-like wall presently being installed in JET. Good progress has been achieved, including stationary ELMy H-mode operation at 4.5 MA. The high confinement hybrid scenario has been extended to high triangularity, lower ρ*and to pulse lengths comparable to the resistive time. The steady-state scenario has also been extended to lower ρ*and ν*and optimized to simultaneously achieve, under stationary conditions, ITER-like values of all other relevant normalized parameters. A dedicated helium campaign has allowed key aspects of plasma control and H-mode operation for the ITER non-activated phase to be evaluated. Effective sawtooth control by fast ions has been demonstrated with3He minority ICRH, a scenario with negligible minority current drive. Edge localized mode (ELM) control studies using external n = 1 and n = 2 perturbation fields have found a resonance effect in ELM frequency for specific q95values. Complete ELM suppression has, however, not been observed, even with an edge Chirikov parameter larger than 1. Pellet ELM pacing has been demonstrated and the minimum pellet size needed to trigger an ELM has been estimated. For both natural and mitigated ELMs a broadening of the divertor ELM-wetted area with increasing ELM size has been found. In disruption studies with massive gas injection up to 50% of the thermal energy could be radiated before, and 20% during, the thermal quench. Halo currents could be reduced by 60% and, using argon/deuterium and neon/deuterium gas mixtures, runaway electron generation could be avoided. Most objectives of the ITER-like ICRH antenna have been demonstrated; matching with closely packed straps, ELM resilience, scattering matrix arc detection and operation at high power density (6.2 MW m-2) and antenna strap voltages (42 kV). Coupling measurements are in very good agreement with TOPICA modelling. © 2011 IAEA, Vienna.
|
|
23. |
|
|