| 1. |
|
|
| 2. |
- Niemi, MEK, et al.
(author)
-
- 2021
-
swepub:Mat__t
|
|
| 3. |
|
|
| 4. |
|
|
| 5. |
|
|
| 6. |
|
|
| 7. |
|
|
| 8. |
- Glasbey, JC, et al.
(author)
-
- 2021
-
swepub:Mat__t
|
|
| 9. |
- Kanai, M, et al.
(author)
-
- 2023
-
swepub:Mat__t
|
|
| 10. |
|
|
| 11. |
- Abel, I, et al.
(author)
-
Overview of the JET results with the ITER-like wall
- 2013
-
In: Nuclear Fusion. - : IOP Publishing. - 1741-4326 .- 0029-5515. ; 53:10, s. 104002-
-
Journal article (peer-reviewed)abstract
- Following the completion in May 2011 of the shutdown for the installation of the beryllium wall and the tungsten divertor, the first set of JET campaigns have addressed the investigation of the retention properties and the development of operational scenarios with the new plasma-facing materials. The large reduction in the carbon content (more than a factor ten) led to a much lower Z(eff) (1.2-1.4) during L- and H-mode plasmas, and radiation during the burn-through phase of the plasma initiation with the consequence that breakdown failures are almost absent. Gas balance experiments have shown that the fuel retention rate with the new wall is substantially reduced with respect to the C wall. The re-establishment of the baseline H-mode and hybrid scenarios compatible with the new wall has required an optimization of the control of metallic impurity sources and heat loads. Stable type-I ELMy H-mode regimes with H-98,H-y2 close to 1 and beta(N) similar to 1.6 have been achieved using gas injection. ELM frequency is a key factor for the control of the metallic impurity accumulation. Pedestal temperatures tend to be lower with the new wall, leading to reduced confinement, but nitrogen seeding restores high pedestal temperatures and confinement. Compared with the carbon wall, major disruptions with the new wall show a lower radiated power and a slower current quench. The higher heat loads on Be wall plasma-facing components due to lower radiation made the routine use of massive gas injection for disruption mitigation essential.
|
|
| 12. |
|
|
| 13. |
- Driscoll, T, et al.
(author)
-
Global and regional burden of disease and injury in 2016 arising from occupational exposures: a systematic analysis for the Global Burden of Disease Study 2016
- 2020
-
In: Occupational and environmental medicine. - : BMJ. - 1470-7926 .- 1351-0711. ; 77:3, s. 133-141
-
Journal article (peer-reviewed)abstract
- This study provides an overview of the influence of occupational risk factors on the global burden of disease as estimated by the occupational component of the Global Burden of Disease (GBD) 2016 study.MethodsThe GBD 2016 study estimated the burden in terms of deaths and disability-adjusted life years (DALYs) arising from the effects of occupational risk factors (carcinogens; asthmagens; particulate matter, gases and fumes (PMGF); secondhand smoke (SHS); noise; ergonomic risk factors for low back pain; risk factors for injury). A population attributable fraction (PAF) approach was used for most risk factors.ResultsIn 2016, globally, an estimated 1.53 (95% uncertainty interval 1.39–1.68) million deaths and 76.1 (66.3–86.3) million DALYs were attributable to the included occupational risk factors, accounting for 2.8% of deaths and 3.2% of DALYs from all causes. Most deaths were attributable to PMGF, carcinogens (particularly asbestos), injury risk factors and SHS. Most DALYs were attributable to injury risk factors and ergonomic exposures. Men and persons 55 years or older were most affected. PAFs ranged from 26.8% for low back pain from ergonomic risk factors and 19.6% for hearing loss from noise to 3.4% for carcinogens. DALYs per capita were highest in Oceania, Southeast Asia and Central sub-Saharan Africa. On a per capita basis, between 1990 and 2016 there was an overall decrease of about 31% in deaths and 25% in DALYs.ConclusionsOccupational exposures continue to cause an important health burden worldwide, justifying the need for ongoing prevention and control initiatives.
|
|
| 14. |
|
|
| 15. |
- Khatri, C, et al.
(author)
-
Outcomes after perioperative SARS-CoV-2 infection in patients with proximal femoral fractures: an international cohort study
- 2021
-
In: BMJ open. - : BMJ. - 2044-6055. ; 11:11, s. e050830-
-
Journal article (peer-reviewed)abstract
- Studies have demonstrated high rates of mortality in people with proximal femoral fracture and SARS-CoV-2, but there is limited published data on the factors that influence mortality for clinicians to make informed treatment decisions. This study aims to report the 30-day mortality associated with perioperative infection of patients undergoing surgery for proximal femoral fractures and to examine the factors that influence mortality in a multivariate analysis.SettingProspective, international, multicentre, observational cohort study.ParticipantsPatients undergoing any operation for a proximal femoral fracture from 1 February to 30 April 2020 and with perioperative SARS-CoV-2 infection (either 7 days prior or 30-day postoperative).Primary outcome30-day mortality. Multivariate modelling was performed to identify factors associated with 30-day mortality.ResultsThis study reports included 1063 patients from 174 hospitals in 19 countries. Overall 30-day mortality was 29.4% (313/1063). In an adjusted model, 30-day mortality was associated with male gender (OR 2.29, 95% CI 1.68 to 3.13, p<0.001), age >80 years (OR 1.60, 95% CI 1.1 to 2.31, p=0.013), preoperative diagnosis of dementia (OR 1.57, 95% CI 1.15 to 2.16, p=0.005), kidney disease (OR 1.73, 95% CI 1.18 to 2.55, p=0.005) and congestive heart failure (OR 1.62, 95% CI 1.06 to 2.48, p=0.025). Mortality at 30 days was lower in patients with a preoperative diagnosis of SARS-CoV-2 (OR 0.6, 95% CI 0.6 (0.42 to 0.85), p=0.004). There was no difference in mortality in patients with an increase to delay in surgery (p=0.220) or type of anaesthetic given (p=0.787).ConclusionsPatients undergoing surgery for a proximal femoral fracture with a perioperative infection of SARS-CoV-2 have a high rate of mortality. This study would support the need for providing these patients with individualised medical and anaesthetic care, including medical optimisation before theatre. Careful preoperative counselling is needed for those with a proximal femoral fracture and SARS-CoV-2, especially those in the highest risk groups.Trial registration numberNCT04323644
|
|
| 16. |
- Millar, IL, et al.
(author)
-
Hyperbaric Oxygen for Lower Limb Trauma (HOLLT): an international multi-centre randomised clinical trial
- 2022
-
In: Diving and hyperbaric medicine. - : Diving and Hyperbaric Medicine Journal. - 1833-3516 .- 2209-1491. ; 52:3, s. 164-174
-
Journal article (peer-reviewed)abstract
- Introduction: Hyperbaric oxygen treatment (HBOT) is sometimes used in the management of open fractures and severe soft tissue crush injury, aiming to reduce complications and improve outcomes. Methods: Patients with open tibial fractures were randomly assigned within 48 hours of injury to receive standard trauma care or standard care plus 12 sessions of HBOT. The primary outcome was the incidence of necrosis or infection or both occurring within 14 days of injury. Results: One-hundred and twenty patients were enrolled. Intention to treat primary outcome occurred in 25/58 HBOT assigned patients and 34/59 controls (43% vs 58%, odds ratio (OR) 0.55, 95% confidence interval (CI) 0.25 to 1.18, P = 0.12). Tissue necrosis occurred in 29% of HBOT patients and 53% of controls (OR 0.35, 95% CI 0.16 to 0.78, P = 0.01). There were fewer late complications in patients receiving HBOT (6/53 vs 18/52, OR 0.22, 95% CI 0.08 to 0.64, P = 0.007) including delayed fracture union (5/53 vs 13/52, OR 0.31, 95% CI 0.10 to 0.95, P = 0.04). Quality of life measures at one and two years were superior in HBOT patients. The mean score difference in short form 36 was 2.90, 95% CI 1.03 to 4.77, P = 0.002, in the short musculoskeletal function assessment (SMFA) was 2.54, 95% CI 0.62 to 4.46, P = 0.01; and in SMFA daily activities was 19.51, 95% CI 0.06 to 21.08, P = 0.05. Conclusions: In severe lower limb trauma, early HBOT reduces tissue necrosis and the likelihood of long-term complications, and improves functional outcomes. Future research should focus on optimal dosage and whether HBOT has benefits for other injury types.
|
|
| 17. |
|
|
| 18. |
|
|
| 19. |
|
|
| 20. |
- Romanelli, F, et al.
(author)
-
Overview of the JET results
- 2011
-
In: Nuclear Fusion. - : IOP Publishing. - 1741-4326 .- 0029-5515. ; 51:9
-
Journal article (peer-reviewed)abstract
- Since the last IAEA Conference JET has been in operation for one year with a programmatic focus on the qualification of ITER operating scenarios, the consolidation of ITER design choices and preparation for plasma operation with the ITER-like wall presently being installed in JET. Good progress has been achieved, including stationary ELMy H-mode operation at 4.5 MA. The high confinement hybrid scenario has been extended to high triangularity, lower ρ*and to pulse lengths comparable to the resistive time. The steady-state scenario has also been extended to lower ρ*and ν*and optimized to simultaneously achieve, under stationary conditions, ITER-like values of all other relevant normalized parameters. A dedicated helium campaign has allowed key aspects of plasma control and H-mode operation for the ITER non-activated phase to be evaluated. Effective sawtooth control by fast ions has been demonstrated with3He minority ICRH, a scenario with negligible minority current drive. Edge localized mode (ELM) control studies using external n = 1 and n = 2 perturbation fields have found a resonance effect in ELM frequency for specific q95values. Complete ELM suppression has, however, not been observed, even with an edge Chirikov parameter larger than 1. Pellet ELM pacing has been demonstrated and the minimum pellet size needed to trigger an ELM has been estimated. For both natural and mitigated ELMs a broadening of the divertor ELM-wetted area with increasing ELM size has been found. In disruption studies with massive gas injection up to 50% of the thermal energy could be radiated before, and 20% during, the thermal quench. Halo currents could be reduced by 60% and, using argon/deuterium and neon/deuterium gas mixtures, runaway electron generation could be avoided. Most objectives of the ITER-like ICRH antenna have been demonstrated; matching with closely packed straps, ELM resilience, scattering matrix arc detection and operation at high power density (6.2 MW m-2) and antenna strap voltages (42 kV). Coupling measurements are in very good agreement with TOPICA modelling. © 2011 IAEA, Vienna.
|
|
| 21. |
|
|
| 22. |
- Bravo, L, et al.
(author)
-
- 2021
-
swepub:Mat__t
|
|
| 23. |
- Tabiri, S, et al.
(author)
-
- 2021
-
swepub:Mat__t
|
|
