| 1. |
- Aad, G., et al.
(author)
-
- 2014
-
In: The European Physical Journal C. - : Springer Science and Business Media LLC. - 1434-6052. ; 74:11
-
Journal article (peer-reviewed)
|
|
| 2. |
- Aad, G., et al.
(author)
-
- 2014
-
Journal article (peer-reviewed)
|
|
| 3. |
- Aad, G., et al.
(author)
-
- 2015
-
Journal article (peer-reviewed)
|
|
| 4. |
- Aad, G., et al.
(author)
-
- 2015
-
In: Physical Review D (Particles, Fields, Gravitation and Cosmology). - 1550-2368 .- 1550-7998. ; 91:5
-
Journal article (peer-reviewed)
|
|
| 5. |
- Aad, G., et al.
(author)
-
- 2011
-
swepub:Mat__t (peer-reviewed)
|
|
| 6. |
- Aad, G., et al.
(author)
-
- 2015
-
Journal article (peer-reviewed)
|
|
| 7. |
- Aad, G., et al.
(author)
-
Studies of the performance of the ATLAS detector using cosmic-ray muons
- 2011
-
In: European Physical Journal C. Particles and Fields. - : Springer Science and Business Media LLC. - 1434-6044 .- 1434-6052. ; 71:3
-
Journal article (peer-reviewed)abstract
- Muons from cosmic-ray interactions in the atmosphere provide a high-statistics source of particles that can be used to study the performance and calibration of the ATLAS detector. Cosmic-ray muons can penetrate to the cavern and deposit energy in all detector subsystems. Such events have played an important role in the commissioning of the detector since the start of the installation phase in 2005 and were particularly important for understanding the detector performance in the time prior to the arrival of the first LHC beams. Global cosmic-ray runs were undertaken in both 2008 and 2009 and these data have been used through to the early phases of collision data-taking as a tool for calibration, alignment and detector monitoring. These large datasets have also been used for detector performance studies, including investigations that rely on the combined performance of different subsystems. This paper presents the results of performance studies related to combined tracking, lepton identification and the reconstruction of jets and missing transverse energy. Results are compared to expectations based on a cosmic-ray event generator and a full simulation of the detector response.
|
|
| 8. |
|
|
| 9. |
- Aaltonen, T., et al.
(author)
-
Observation of s-Channel Production of Single Top Quarks at the Tevatron
- 2014
-
In: Physical Review Letters. - 0031-9007 .- 1079-7114. ; 112:23
-
Journal article (peer-reviewed)abstract
- We report the first observation of single-top-quark production in the s channel through the combination of the CDF and D0 measurements of the cross section in proton-antiproton collisions at a center-of-mass energy of 1.96 TeV. The data correspond to total integrated luminosities of up to 9.7 fb(-1) per experiment. The measured cross section is sigma(s) = 1.29(-0.24)(+0.26) pb. The probability of observing a statistical fluctuation of the background to a cross section of the observed size or larger is 1.8 x 10(-10), corresponding to a significance of 6.3 standard deviations for the presence of an s-channel contribution to the production of single-top quarks.
|
|
| 10. |
- Praena, J., et al.
(author)
-
Preparation and characterization of 33S samples for 33S(n,alpha)30Si cross-section measurements at the n_TOF facility at CERN
- 2018
-
In: Nuclear Instruments and Methods in Physics Research Section A. - : Elsevier BV. - 0168-9002 .- 1872-9576. ; 890, s. 142-147
-
Journal article (peer-reviewed)abstract
- Thin 33S samples for the study of the 33S(n,alpha)30Si cross-section at the n_TOF facility at CERN were made by thermal evaporation of 33S powder onto a dedicated substrate made of kapton covered with thin layers of copper, chromium and titanium. This method has provided for the first time bare sulfur samples a few centimeters in diameter. The samples have shown an excellent adherence with no mass loss after few years and no sublimation in vacuum at room temperature. The determination of the mass thickness of 33S has been performed by means of Rutherford backscattering spectrometry. The samples have been successfully tested under neutron irradiation.
|
|
| 11. |
- Leal-Cidoncha, E., et al.
(author)
-
Fission Fragment Angular Distribution measurements of 235U and 238U at CERN n_TOF facility
- 2016
-
In: EPJ Web of Conferences. - : EDP Sciences. - 2100-014X.
-
Conference paper (peer-reviewed)abstract
- Neutron-induced fission cross sections of U-238 and U-235 are used as standards in the fast neutron region up to 200 MeV. A high accuracy of the standards is relevant to experimentally determine other neutron reaction cross sections. Therefore, the detection efficiency should be corrected by using the angular distribution of the fission fragments (FFAD), which are barely known above 20 MeV. In addition, the angular distribution of the fragments produced in the fission of highly excited and deformed nuclei is an important observable to investigate the nuclear fission process. In order to measure the FFAD of neutron-induced reactions, a fission detection setup based on parallel-plate avalanche counters (PPACs) has been developed and successfully used at the CERN-n_TOF facility. In this work, we present the preliminary results on the analysis of new U-235(n,f) and U-238(n,f) data in the extended energy range up to 200 MeV compared to the existing experimental data.
|
|
| 12. |
- Wilson, J. A., et al.
(author)
-
The optical links of the ATLAS SemiConductor tracker
- 2007
-
In: Journal of Instrumentation. - 1748-0221. ; 2, s. 1-28
-
Journal article (peer-reviewed)abstract
- Optical links are used for the readout of the 4088 silicon microstrip modules that make up the SemiConductor Tracker of the ATLAS experiment at the CERN Large Hadron Collider (LHC). The optical link requirements are reviewed, with particular emphasis on the very demanding environment at the LHC. The on-detector components have to operate in high radiation levels for 10 years, with no maintenance, and there are very strict requirements on power consumption, material and space. A novel concept for the packaging of the on-detector optoelectronics has been developed to meet these requirements. The system architecture, including its redundancy features, is explained and the critical on-detector components are described. The results of the extensive Quality Assurance performed during all steps of the assembly are discussed.
|
|
| 13. |
|
|
| 14. |
- Farah, Joseph, et al.
(author)
-
Selective Dynamical Imaging of Interferometric Data
- 2022
-
In: Astrophysical Journal Letters. - : American Astronomical Society. - 2041-8213 .- 2041-8205. ; 930:2
-
Journal article (peer-reviewed)abstract
- Recent developments in very long baseline interferometry (VLBI) have made it possible for the Event Horizon Telescope (EHT) to resolve the innermost accretion flows of the largest supermassive black holes on the sky. The sparse nature of the EHT's (u, v)-coverage presents a challenge when attempting to resolve highly time-variable sources. We demonstrate that the changing (u, v)-coverage of the EHT can contain regions of time over the course of a single observation that facilitate dynamical imaging. These optimal time regions typically have projected baseline distributions that are approximately angularly isotropic and radially homogeneous. We derive a metric of coverage quality based on baseline isotropy and density that is capable of ranking array configurations by their ability to produce accurate dynamical reconstructions. We compare this metric to existing metrics in the literature and investigate their utility by performing dynamical reconstructions on synthetic data from simulated EHT observations of sources with simple orbital variability. We then use these results to make recommendations for imaging the 2017 EHT Sgr A* data set.
|
|
