1. |
- Romanelli, F, et al.
(author)
-
Overview of the JET results
- 2011
-
In: Nuclear Fusion. - : IOP Publishing. - 1741-4326 .- 0029-5515. ; 51:9
-
Journal article (peer-reviewed)abstract
- Since the last IAEA Conference JET has been in operation for one year with a programmatic focus on the qualification of ITER operating scenarios, the consolidation of ITER design choices and preparation for plasma operation with the ITER-like wall presently being installed in JET. Good progress has been achieved, including stationary ELMy H-mode operation at 4.5 MA. The high confinement hybrid scenario has been extended to high triangularity, lower ρ*and to pulse lengths comparable to the resistive time. The steady-state scenario has also been extended to lower ρ*and ν*and optimized to simultaneously achieve, under stationary conditions, ITER-like values of all other relevant normalized parameters. A dedicated helium campaign has allowed key aspects of plasma control and H-mode operation for the ITER non-activated phase to be evaluated. Effective sawtooth control by fast ions has been demonstrated with3He minority ICRH, a scenario with negligible minority current drive. Edge localized mode (ELM) control studies using external n = 1 and n = 2 perturbation fields have found a resonance effect in ELM frequency for specific q95values. Complete ELM suppression has, however, not been observed, even with an edge Chirikov parameter larger than 1. Pellet ELM pacing has been demonstrated and the minimum pellet size needed to trigger an ELM has been estimated. For both natural and mitigated ELMs a broadening of the divertor ELM-wetted area with increasing ELM size has been found. In disruption studies with massive gas injection up to 50% of the thermal energy could be radiated before, and 20% during, the thermal quench. Halo currents could be reduced by 60% and, using argon/deuterium and neon/deuterium gas mixtures, runaway electron generation could be avoided. Most objectives of the ITER-like ICRH antenna have been demonstrated; matching with closely packed straps, ELM resilience, scattering matrix arc detection and operation at high power density (6.2 MW m-2) and antenna strap voltages (42 kV). Coupling measurements are in very good agreement with TOPICA modelling. © 2011 IAEA, Vienna.
|
|
2. |
- Abel, I, et al.
(author)
-
Overview of the JET results with the ITER-like wall
- 2013
-
In: Nuclear Fusion. - : IOP Publishing. - 1741-4326 .- 0029-5515. ; 53:10, s. 104002-
-
Journal article (peer-reviewed)abstract
- Following the completion in May 2011 of the shutdown for the installation of the beryllium wall and the tungsten divertor, the first set of JET campaigns have addressed the investigation of the retention properties and the development of operational scenarios with the new plasma-facing materials. The large reduction in the carbon content (more than a factor ten) led to a much lower Z(eff) (1.2-1.4) during L- and H-mode plasmas, and radiation during the burn-through phase of the plasma initiation with the consequence that breakdown failures are almost absent. Gas balance experiments have shown that the fuel retention rate with the new wall is substantially reduced with respect to the C wall. The re-establishment of the baseline H-mode and hybrid scenarios compatible with the new wall has required an optimization of the control of metallic impurity sources and heat loads. Stable type-I ELMy H-mode regimes with H-98,H-y2 close to 1 and beta(N) similar to 1.6 have been achieved using gas injection. ELM frequency is a key factor for the control of the metallic impurity accumulation. Pedestal temperatures tend to be lower with the new wall, leading to reduced confinement, but nitrogen seeding restores high pedestal temperatures and confinement. Compared with the carbon wall, major disruptions with the new wall show a lower radiated power and a slower current quench. The higher heat loads on Be wall plasma-facing components due to lower radiation made the routine use of massive gas injection for disruption mitigation essential.
|
|
3. |
|
|
4. |
- Korenblik, R., et al.
(author)
-
Dragon 1 Protocol Manuscript : Training, Accreditation, Implementation and Safety Evaluation of Portal and Hepatic Vein Embolization (PVE/HVE) to Accelerate Future Liver Remnant (FLR) Hypertrophy
- 2022
-
In: Cardiovascular and Interventional Radiology. - : Springer. - 0174-1551 .- 1432-086X. ; 45, s. 1391-1398
-
Journal article (peer-reviewed)abstract
- Study Purpose The DRAGON 1 trial aims to assess training, implementation, safety and feasibility of combined portal- and hepatic-vein embolization (PVE/HVE) to accelerate future liver remnant (FLR) hypertrophy in patients with borderline resectable colorectal cancer liver metastases. Methods The DRAGON 1 trial is a worldwide multicenter prospective single arm trial. The primary endpoint is a composite of the safety of PVE/HVE, 90-day mortality, and one year accrual monitoring of each participating center. Secondary endpoints include: feasibility of resection, the used PVE and HVE techniques, FLR-hypertrophy, liver function (subset of centers), overall survival, and disease-free survival. All complications after the PVE/HVE procedure are documented. Liver volumes will be measured at week 1 and if applicable at week 3 and 6 after PVE/HVE and follow-up visits will be held at 1, 3, 6, and 12 months after the resection. Results Not applicable. Conclusion DRAGON 1 is a prospective trial to assess the safety and feasibility of PVE/HVE. Participating study centers will be trained, and procedures standardized using Work Instructions (WI) to prepare for the DRAGON 2 randomized controlled trial. Outcomes should reveal the accrual potential of centers, safety profile of combined PVE/HVE and the effect of FLR-hypertrophy induction by PVE/HVE in patients with CRLM and a small FLR.
|
|
5. |
- Zuberbier, T., et al.
(author)
-
Proposal of 0.5 mg of protein/100 g of processed food as threshold for voluntary declaration of food allergen traces in processed food-A first step in an initiative to better inform patients and avoid fatal allergic reactions: A GA(2)LEN position paper
- 2022
-
In: Allergy. - : Wiley. - 0105-4538 .- 1398-9995. ; 77:6, s. 1736-1750
-
Journal article (peer-reviewed)abstract
- Background Food anaphylaxis is commonly elicited by unintentional ingestion of foods containing the allergen above the tolerance threshold level of the individual. While labeling the 14 main allergens used as ingredients in food products is mandatory in the EU, there is no legal definition of declaring potential contaminants. Precautionary allergen labeling such as "may contain traces of" is often used. However, this is unsatisfactory for consumers as they get no information if the contamination is below their personal threshold. In discussions with the food industry and technologists, it was suggested to use a voluntary declaration indicating that all declared contaminants are below a threshold of 0.5 mg protein per 100 g of food. This concentration is known to be below the threshold of most patients, and it can be technically guaranteed in most food production. However, it was also important to assess that in case of accidental ingestion of contaminants below this threshold by highly allergic patients, no fatal anaphylactic reaction could occur. Therefore, we performed a systematic review to assess whether a fatal reaction to 5mg of protein or less has been reported, assuming that a maximum portion size of 1kg of a processed food exceeds any meal and thus gives a sufficient safety margin. Methods MEDLINE and EMBASE were searched until 24 January 2021 for provocation studies and case reports in which one of the 14 major food allergens was reported to elicit fatal or life-threatening anaphylactic reactions and assessed if these occurred below the ingestion of 5mg of protein. A Delphi process was performed to obtain an expert consensus on the results. Results In the 210 studies included, in our search, no reports of fatal anaphylactic reactions reported below 5 mg protein ingested were identified. However, in provocation studies and case reports, severe reactions below 5 mg were reported for the following allergens: eggs, fish, lupin, milk, nuts, peanuts, soy, and sesame seeds. Conclusion Based on the literature studied for this review, it can be stated that cross-contamination of the 14 major food allergens below 0.5 mg/100 g is likely not to endanger most food allergic patients when a standard portion of food is consumed. We propose to use the statement "this product contains the named allergens in the list of ingredients, it may contain traces of other contaminations (to be named, e.g. nut) at concentrations less than 0.5 mg per 100 g of this product" for a voluntary declaration on processed food packages. This level of avoidance of cross-contaminations can be achieved technically for most processed foods, and the statement would be a clear and helpful message to the consumers. However, it is clearly acknowledged that a voluntary declaration is only a first step to a legally binding solution. For this, further research on threshold levels is encouraged.
|
|
6. |
- Latacz, Emily, et al.
(author)
-
Histopathological growth patterns of liver metastasis : updated consensus guidelines for pattern scoring, perspectives and recent mechanistic insights
- 2022
-
In: British Journal of Cancer. - : Springer Nature. - 0007-0920 .- 1532-1827. ; 127:6, s. 988-1013
-
Research review (peer-reviewed)abstract
- The first consensus guidelines for scoring the histopathological growth patterns (HGPs) of liver metastases were established in 2017. Since then, numerous studies have applied these guidelines, have further substantiated the potential clinical value of the HGPs in patients with liver metastases from various tumour types and are starting to shed light on the biology of the distinct HGPs. In the present guidelines, we give an overview of these studies, discuss novel strategies for predicting the HGPs of liver metastases, such as deep-learning algorithms for whole-slide histopathology images and medical imaging, and highlight liver metastasis animal models that exhibit features of the different HGPs. Based on a pooled analysis of large cohorts of patients with liver-metastatic colorectal cancer, we propose a new cut-off to categorise patients according to the HGPs. An up-to-date standard method for HGP assessment within liver metastases is also presented with the aim of incorporating HGPs into the decision-making processes surrounding the treatment of patients with liver-metastatic cancer. Finally, we propose hypotheses on the cellular and molecular mechanisms that drive the biology of the different HGPs, opening some exciting preclinical and clinical research perspectives.
|
|
7. |
|
|
8. |
- Loarer, T., et al.
(author)
-
Fuel retention in L and H mode experiments in JET
- 2007
-
In: 34th EPS Conference on Plasma Physics 2007, EPS 2007 - Europhysics Conference Abstracts. - 9781622763344 ; , s. 13-16
-
Conference paper (peer-reviewed)abstract
- The fuel retention has been studied out in JET in L mode, Type III and Type I ELMy H-modes using gas balance in series of repetitive pulses with an overall accuracy of about 1.2%. The short term (dynamic) retention is important for both L mode and Type III ELMy H-mode over the heating phases (respectively 13 and 17 sec) but decreases already significantly during the pulse. It becomes small already after 6 sec for the Type I ELMy H-mode conditions. In all the cases, the recovery after the pulse contributes for a weak part in the gas balance and in the overall fuel retention. The absolute long term fuel retention (on the time basis of typically 5 hours) for the different plasma conditions is between 1.3 and 2.8 1021Ds-1 (averaged over the plasma heating time) and in reasonable agreement with the value deduced from post mortem tile analysis of about 5 1020Ds-1 considering the additional long term outgassing, conditioning and disruptions included in the post mortem analysis. The increase of the long term retention observed from L mode to Type I ELMy H-mode is associated to the increase of the recycling flux and the ELM energy. This larger long term retention is attributed to an enhanced carbon erosion and transport in the SOL leading to stronger carbon deposition and fuel codeposition. The results confirm the strong concerns about fuel retention in a carbon clad tokamak and a possible full carbon wall ITER which could reach the T-inventory limit in only a small number of high performance shots. A reasonable ITER operation time depends thus on a significant reduced T codeposition under the different ITER material conditions (which has to be confirmed in a relevant tokamak experiment such as the JET ILW project) and an effective routine T removal technique.
|
|