1. |
- Gusenbauer, Claudia, et al.
(author)
-
Differences in surface chemistry of regenerated lignocellulose fibers determined by chemically sensitive scanning probe microscopy
- 2020
-
In: International Journal of Biological Macromolecules. - : Elsevier BV. - 0141-8130 .- 1879-0003. ; 165, s. 2520-2527
-
Journal article (peer-reviewed)abstract
- Tuning the composition of regenerated lignocellulosic fibers in the production process enables targeting of specific material properties. In composite materials, such properties could be manipulated by controlled heterogeneous distribution of chemical components of regenerated fibers. This attribute requires a visualization method to show their inherent chemical characteristics. We compared complementary microscopic techniques to analyze the surface chemistry of four differently tuned regenerated lignocellulosic fibers. Adhesion properties were visualized with chemical force microscopy and showed contrasts towards hydrophilic and hydrophobic atomic force microscopy tips. Fibers containing xylan showed heterogeneous adhesion properties within the fiber structure towards hydrophilic tips. Additionally, peak force infrared microscopy mapped spectroscopic contrasts with nanometer resolution and provided point infrared spectra, which were consistent to classical infrared microscopy data. With this setup, infrared signals with a spatial resolution below 20 nm reveal chemical gradients in specific fiber types.
|
|
2. |
- Rezaei, Fatemeh, et al.
(author)
-
Anatomical and morphological characteristics of beech wood after CO2-laser cutting
- 2022
-
In: Wood Material Science & Engineering. - : Taylor & Francis Group. - 1748-0272 .- 1748-0280. ; 17:6, s. 459-468
-
Journal article (peer-reviewed)abstract
- This study aimed to characterize the surface quality of beech wood (Fagus sylvatica L.) cut by a CO2-laser. Boards were conditioned to a low (about 8% moisture content), 12% and a high, (about 18% moisture content). Laser cutting was performed at varying processing parameters, i.e. cutting speed, gas pressure and focal-point position. A confocal microscope was used to determine the average surface roughness perpendicular to the grain. The anatomical structures of the laser-cut surfaces were examined with scanning electron microscope. The result showed that smoother surfaces were obtained at the low moisture content when processed at a gas pressure of 21 bar. Focal-point positioning did only have an effect on the surface roughness at 12% moisture content whereas the value was substantially lower for focal-point positioned on the surface. The surfaces cut at 18% moisture content, and at a cutting speed of 3.5 m/min generated a rougher surface than cut at low moisture content and at a lower speed. Laser cutting produced a rougher surface as compared to sawn surface (circular saw). The structural integrity of the laser-cut surface was more intact when the wood was having high moisture content and processed at a high cutting speed.
|
|