1. |
- Abel, I, et al.
(author)
-
Overview of the JET results with the ITER-like wall
- 2013
-
In: Nuclear Fusion. - : IOP Publishing. - 1741-4326 .- 0029-5515. ; 53:10, s. 104002-
-
Journal article (peer-reviewed)abstract
- Following the completion in May 2011 of the shutdown for the installation of the beryllium wall and the tungsten divertor, the first set of JET campaigns have addressed the investigation of the retention properties and the development of operational scenarios with the new plasma-facing materials. The large reduction in the carbon content (more than a factor ten) led to a much lower Z(eff) (1.2-1.4) during L- and H-mode plasmas, and radiation during the burn-through phase of the plasma initiation with the consequence that breakdown failures are almost absent. Gas balance experiments have shown that the fuel retention rate with the new wall is substantially reduced with respect to the C wall. The re-establishment of the baseline H-mode and hybrid scenarios compatible with the new wall has required an optimization of the control of metallic impurity sources and heat loads. Stable type-I ELMy H-mode regimes with H-98,H-y2 close to 1 and beta(N) similar to 1.6 have been achieved using gas injection. ELM frequency is a key factor for the control of the metallic impurity accumulation. Pedestal temperatures tend to be lower with the new wall, leading to reduced confinement, but nitrogen seeding restores high pedestal temperatures and confinement. Compared with the carbon wall, major disruptions with the new wall show a lower radiated power and a slower current quench. The higher heat loads on Be wall plasma-facing components due to lower radiation made the routine use of massive gas injection for disruption mitigation essential.
|
|
2. |
- Romanelli, F, et al.
(author)
-
Overview of the JET results
- 2011
-
In: Nuclear Fusion. - : IOP Publishing. - 1741-4326 .- 0029-5515. ; 51:9
-
Journal article (peer-reviewed)abstract
- Since the last IAEA Conference JET has been in operation for one year with a programmatic focus on the qualification of ITER operating scenarios, the consolidation of ITER design choices and preparation for plasma operation with the ITER-like wall presently being installed in JET. Good progress has been achieved, including stationary ELMy H-mode operation at 4.5 MA. The high confinement hybrid scenario has been extended to high triangularity, lower ρ*and to pulse lengths comparable to the resistive time. The steady-state scenario has also been extended to lower ρ*and ν*and optimized to simultaneously achieve, under stationary conditions, ITER-like values of all other relevant normalized parameters. A dedicated helium campaign has allowed key aspects of plasma control and H-mode operation for the ITER non-activated phase to be evaluated. Effective sawtooth control by fast ions has been demonstrated with3He minority ICRH, a scenario with negligible minority current drive. Edge localized mode (ELM) control studies using external n = 1 and n = 2 perturbation fields have found a resonance effect in ELM frequency for specific q95values. Complete ELM suppression has, however, not been observed, even with an edge Chirikov parameter larger than 1. Pellet ELM pacing has been demonstrated and the minimum pellet size needed to trigger an ELM has been estimated. For both natural and mitigated ELMs a broadening of the divertor ELM-wetted area with increasing ELM size has been found. In disruption studies with massive gas injection up to 50% of the thermal energy could be radiated before, and 20% during, the thermal quench. Halo currents could be reduced by 60% and, using argon/deuterium and neon/deuterium gas mixtures, runaway electron generation could be avoided. Most objectives of the ITER-like ICRH antenna have been demonstrated; matching with closely packed straps, ELM resilience, scattering matrix arc detection and operation at high power density (6.2 MW m-2) and antenna strap voltages (42 kV). Coupling measurements are in very good agreement with TOPICA modelling. © 2011 IAEA, Vienna.
|
|
3. |
- Dieleman, J., et al.
(author)
-
Evolution and patterns of global health financing 1995-2014 : Development assistance for health, and government, prepaid private, and out-of-pocket health spending in 184 countries
- 2017
-
In: The Lancet. - : Lancet Publishing Group. - 0140-6736 .- 1474-547X. ; 389:10083, s. 1981-2004
-
Journal article (peer-reviewed)abstract
- Background: An adequate amount of prepaid resources for health is important to ensure access to health services and for the pursuit of universal health coverage. Previous studies on global health financing have described the relationship between economic development and health financing. In this study, we further explore global health financing trends and examine how the sources of funds used, types of services purchased, and development assistance for health disbursed change with economic development. We also identify countries that deviate from the trends. Methods: We estimated national health spending by type of care and by source, including development assistance for health, based on a diverse set of data including programme reports, budget data, national estimates, and 964 National Health Accounts. These data represent health spending for 184 countries from 1995 through 2014. We converted these data into a common inflation-adjusted and purchasing power-adjusted currency, and used non-linear regression methods to model the relationship between health financing, time, and economic development. Findings: Between 1995 and 2014, economic development was positively associated with total health spending and a shift away from a reliance on development assistance and out-of-pocket (OOP) towards government spending. The largest absolute increase in spending was in high-income countries, which increased to purchasing power-adjusted $5221 per capita based on an annual growth rate of 3.0%. The largest health spending growth rates were in upper-middle-income (5.9) and lower-middle-income groups (5.0), which both increased spending at more than 5% per year, and spent $914 and $267 per capita in 2014, respectively. Spending in low-income countries grew nearly as fast, at 4.6%, and health spending increased from $51 to $120 per capita. In 2014, 59.2% of all health spending was financed by the government, although in low-income and lower-middle-income countries, 29.1% and 58.0% of spending was OOP spending and 35.7% and 3.0% of spending was development assistance. Recent growth in development assistance for health has been tepid; between 2010 and 2016, it grew annually at 1.8%, and reached US$37.6 billion in 2016. Nonetheless, there is a great deal of variation revolving around these averages. 29 countries spend at least 50% more than expected per capita, based on their level of economic development alone, whereas 11 countries spend less than 50% their expected amount. Interpretation: Health spending remains disparate, with low-income and lower-middle-income countries increasing spending in absolute terms the least, and relying heavily on OOP spending and development assistance. Moreover, tremendous variation shows that neither time nor economic development guarantee adequate prepaid health resources, which are vital for the pursuit of universal health coverage. © The Author(s). Published by Elsevier Ltd.
|
|
4. |
- Dey, Lankeswar, et al.
(author)
-
Authenticating the Presence of a Relativistic Massive Black Hole Binary in OJ 287 Using Its General Relativity Centenary Flare : Improved Orbital Parameters
- 2018
-
In: Astrophysical Journal. - : American Astronomical Society. - 0004-637X .- 1538-4357. ; 866:1
-
Journal article (peer-reviewed)abstract
- Results from regular monitoring of relativistic compact binaries like PSR 1913+16 are consistent with the dominant (quadrupole) order emission of gravitational waves (GWs). We show that observations associated with the binary black hole (BBH) central engine of blazar OJ 287 demand the inclusion of gravitational radiation reaction effects beyond the quadrupolar order. It turns out that even the effects of certain hereditary contributions to GW emission are required to predict impact flare timings of OJ 287. We develop an approach that incorporates this effect into the BBH model for OJ 287. This allows us to demonstrate an excellent agreement between the observed impact flare timings and those predicted from ten orbital cycles of the BBH central engine model. The deduced rate of orbital period decay is nine orders of magnitude higher than the observed rate in PSR 1913+16, demonstrating again the relativistic nature of OJ 287's central engine. Finally, we argue that precise timing of the predicted 2019 impact flare should allow a test of the celebrated black hole no-hair theorem at the 10% level.
|
|
5. |
- Scholz, Marek, et al.
(author)
-
Conceptual design of the high resolution neutron spectrometer for ITER
- 2019
-
In: Nuclear Fusion. - 0029-5515 .- 1741-4326. ; 59:6
-
Journal article (peer-reviewed)abstract
- A high resolution neutron spectrometer (HRNS) system has been designed as a neutron diagnostic tool for ITER. The HRNS is dedicated to measurements of time resolved neutron energy spectra for both deuterium and deuterium-tritium (DT) plasmas. The main function of the HRNS is to determine the fuel ion ratio n(t)/n(d) in the plasma core with 20% uncertainty and a time resolution of 100ms for a range of ITER operating scenarios from 0.5 MW to 500 MW in fusion power. Moreover, neutron spectroscopy measurements should also be possible in the initial deuterium phase of ITER experiments. A supplementary function of the HRNS is to provide information on the fuel ion temperature. Furthermore, the HRNS can be used as an additional line-of-sight (LOS) for the radial neutron camera. To meet these requirements, a set of four spectrometers positioned after each other along a single LOS has been designed. The detector techniques employed include a thin foil proton recoil spectrometer (TPR), a neutron diamond detector (NDD), a back-scattering time-of-flight system (bToF) and a forward timeof-flight system (fToF). The TPR system, positioned closest to the plasma, provides data at high fusion powers. For plasma conditions producing intermediate fusion power two neutron spectrometers are installed: NDD and bToF. The NDD is installed as the second instrument along the HRNS LOS after the TPR. The fToF spectrometer is dedicated for low tritium densities and pure deuterium operation. The paper summarizes the current state of the art of neutron spectroscopy useful in plasma diagnostics and the possibility of installing a dedicated HRNS for ITER in the designated diagnostic port. We conclude that the proposed HRNS system can fulfil the ITER measurement requirements over a broad range of plasma operational scenarios, including full power DT, start-up, ramp-down and pure D operations.
|
|