1. |
|
|
2. |
|
|
3. |
|
|
4. |
- Klionsky, Daniel J., et al.
(author)
-
Guidelines for the use and interpretation of assays for monitoring autophagy
- 2012
-
In: Autophagy. - : Informa UK Limited. - 1554-8635 .- 1554-8627. ; 8:4, s. 445-544
-
Research review (peer-reviewed)abstract
- In 2008 we published the first set of guidelines for standardizing research in autophagy. Since then, research on this topic has continued to accelerate, and many new scientists have entered the field. Our knowledge base and relevant new technologies have also been expanding. Accordingly, it is important to update these guidelines for monitoring autophagy in different organisms. Various reviews have described the range of assays that have been used for this purpose. Nevertheless, there continues to be confusion regarding acceptable methods to measure autophagy, especially in multicellular eukaryotes. A key point that needs to be emphasized is that there is a difference between measurements that monitor the numbers or volume of autophagic elements (e.g., autophagosomes or autolysosomes) at any stage of the autophagic process vs. those that measure flux through the autophagy pathway (i.e., the complete process); thus, a block in macroautophagy that results in autophagosome accumulation needs to be differentiated from stimuli that result in increased autophagic activity, defined as increased autophagy induction coupled with increased delivery to, and degradation within, lysosomes (in most higher eukaryotes and some protists such as Dictyostelium) or the vacuole (in plants and fungi). In other words, it is especially important that investigators new to the field understand that the appearance of more autophagosomes does not necessarily equate with more autophagy. In fact, in many cases, autophagosomes accumulate because of a block in trafficking to lysosomes without a concomitant change in autophagosome biogenesis, whereas an increase in autolysosomes may reflect a reduction in degradative activity. Here, we present a set of guidelines for the selection and interpretation of methods for use by investigators who aim to examine macroautophagy and related processes, as well as for reviewers who need to provide realistic and reasonable critiques of papers that are focused on these processes. These guidelines are not meant to be a formulaic set of rules, because the appropriate assays depend in part on the question being asked and the system being used. In addition, we emphasize that no individual assay is guaranteed to be the most appropriate one in every situation, and we strongly recommend the use of multiple assays to monitor autophagy. In these guidelines, we consider these various methods of assessing autophagy and what information can, or cannot, be obtained from them. Finally, by discussing the merits and limits of particular autophagy assays, we hope to encourage technical innovation in the field.
|
|
5. |
|
|
6. |
|
|
7. |
|
|
8. |
- Ruysen, Harriet, et al.
(author)
-
Uterotonics for prevention of postpartum haemorrhage: EN-BIRTH multi-country validation study.
- 2021
-
In: BMC pregnancy and childbirth. - : Springer Science and Business Media LLC. - 1471-2393. ; 21:Suppl 1
-
Journal article (peer-reviewed)abstract
- Postpartum haemorrhage (PPH) is a leading cause of preventable maternal mortality worldwide. The World Health Organization (WHO) recommends uterotonic administration for every woman after birth to prevent PPH. There are no standardised data collected in large-scale measurement platforms. The Every Newborn Birth Indicators Research Tracking in Hospitals (EN-BIRTH) is an observational study to assess the validity of measurement of maternal and newborn indicators, and this paper reports findings regarding measurement of coverage and quality for uterotonics.The EN-BIRTH study took place in five hospitals in Bangladesh, Nepal and Tanzania, from July 2017 to July 2018. Clinical observers collected tablet-based, time-stamped data. We compared observation data for uterotonics to routine hospital register-records and women's report at exit-interview survey. We analysed the coverage and quality gap for timing and dose of administration. The register design was evaluated against gap analyses and qualitative interview data assessing the barriers and enablers to data recording and use.Observed uterotonic coverage was high in all five hospitals (>99%, 95% CI 98.7-99.8%). Survey-report underestimated coverage (79.5 to 91.7%). "Don't know" replies varied (2.1 to 14.4%) and were higher after caesarean (3.7 to 59.3%). Overall, there was low accuracy in survey data for details of uterotonic administration (type and timing). Register-recorded coverage varied in four hospitals capturing uterotonics in a specific column (21.6, 64.5, 97.6, 99.4%). The average coverage measurement gap was 18.1% for register-recorded and 6.0% for survey-reported coverage. Uterotonics were given to 15.9% of women within the "right time" (1min) and 69.8% within 3min. Women's report of knowing the purpose of uterotonics after birth ranged from 0.4 to 64.9% between hospitals. Enabling register design and adequate staffing were reported to improve routine recording.Routine registers have potential to track uterotonic coverage - register data were highly accurate in two EN-BIRTH hospitals, compared to consistently underestimated coverage by survey-report. Although uterotonic coverage was high, there were gaps in observed quality for timing and dose. Standardisation of register design and implementation could improve data quality and data flow from registers into health management information reporting systems, and requires further assessment.
|
|
9. |
- Schwellnus, F., et al.
(author)
-
Study of low work function materials for hot cavity resonance ionization laser ion sources
- 2009
-
In: Nuclear Instruments and Methods in Physics Research Section B. - : Elsevier BV. - 0168-583X .- 1872-9584. ; 267:10, s. 1856-1861
-
Journal article (peer-reviewed)abstract
- The selectivity of a hot cavity resonance ionization laser ion source (RILIS) is most often limited by contributions from competing surface ionization of the hot walls of the ionization cavity. In this article we present investigations on the properties of designated high temperature, low work function materials regarding their performance and suitability as cavity material for RILIS. Tungsten test cavities, impregnated with a mixture of barium oxide and strontium oxide (BaOSrO on W), or alternatively gadolinium hexaboride (GdB6) were studied in comparison to a standard tungsten RILIS cavity as being routinely used for hot cavity laser ionization at ISOLDE. Measurement campaigns took place at the off-line mass separators at ISOLDE/CERN, Geneva and RISIKO/University of Mainz.
|
|
10. |
- Shamba, Donat, et al.
(author)
-
Barriers and enablers to routine register data collection for newborns and mothers: EN-BIRTH multi-country validation study.
- 2021
-
In: BMC pregnancy and childbirth. - : Springer Science and Business Media LLC. - 1471-2393. ; 21:Suppl 1
-
Journal article (peer-reviewed)abstract
- Policymakers need regular high-quality coverage data on care around the time of birth to accelerate progress for ending preventable maternal and newborn deaths and stillbirths. With increasing facility births, routine Health Management Information System (HMIS) data have potential to track coverage. Identifying barriers and enablers faced by frontline health workers recording HMIS source data in registers is important to improve data for use.The EN-BIRTH study was a mixed-methods observational study in five hospitals in Bangladesh, Nepal and Tanzania to assess measurement validity for selected Every Newborn coverage indicators. We described data elements required in labour ward registers to track these indicators. To evaluate barriers and enablers for correct recording of data in registers, we designed three interview tools: a) semi-structured in-depth interview (IDI) guide b) semi-structured focus group discussion (FGD) guide, and c) checklist assessing care-to-documentation. We interviewed two groups of respondents (January 2018-March 2019): hospital nurse-midwives and doctors who fill ward registers after birth (n = 40 IDI and n = 5 FGD); and data collectors (n = 65). Qualitative data were analysed thematically by categorising pre-identified codes. Common emerging themes of barriers or enablers across all five hospitals were identified relating to three conceptual framework categories.Similar themes emerged as both barriers and enablers. First, register design was recognised as crucial, yet perceived as complex, and not always standardised for necessary data elements. Second, register filling was performed by over-stretched nurse-midwives with variable training, limited supervision, and availability of logistical resources. Documentation complexity across parallel documents was time-consuming and delayed because of low staff numbers. Complete data were valued more than correct data. Third, use of register data included clinical handover and monthly reporting, but little feedback was given from data users.Health workers invest major time recording register data for maternal and newborn core health indicators. Improving data quality requires standardised register designs streamlined to capture only necessary data elements. Consistent implementation processes are also needed. Two-way feedback between HMIS levels is critical to improve performance and accurately track progress towards agreed health goals.
|
|
11. |
|
|