1. |
|
|
2. |
|
|
3. |
|
|
4. |
|
|
5. |
- Dubruille, R, et al.
(author)
-
Drosophila regulatory factor X is necessary for ciliated sensory neuron differentiation
- 2002
-
In: Development. - : The Company of Biologists. - 0950-1991 .- 1477-9129. ; 129:23, s. 5487-5498
-
Journal article (peer-reviewed)abstract
- Ciliated neurons play an important role in sensory perception in many animals. Modified cilia at dendrite endings serve as sites of sensory signal capture and transduction. We describe Drosophila mutations that affect the transcription factor RFX and genetic rescue experiments that demonstrate its central role in sensory cilium differentiation. Rfx mutant flies show defects in chemosensory and mechanosensory behaviors but have normal phototaxis, consistent with Rfx expression in ciliated sensory neurons and neuronal precursors but not in photoreceptors. The mutant behavioral phenotypes are correlated with abnormal function and structure of neuronal cilia, as shown by the loss of sensory transduction and by defects in ciliary morphology and ultrastructure. These results identify Rfx as an essential regulator of ciliated sensory neuron differentiation in Drosophild.
|
|
6. |
- Harada, A., et al.
(author)
-
Mechanical and microstructural properties of ultra-translucent dental zirconia ceramic stabilized with 5 mol% yttria
- 2020
-
In: Journal of the Mechanical Behavior of Biomedical Materials. - : Elsevier BV. - 1751-6161. ; 111
-
Journal article (peer-reviewed)abstract
- Monolithic dental prostheses fabricated from 3 mol.% yttria-stabilized zirconia (3YZ) are becoming increasingly popular. Recently, 5 mol.% yttria-stabilized zirconia (5YZ) which significantly improves the translucency of 3YZ has been prepared. However, its mechanical and microstructural properties, especially those affected by low-temperature degradation (LTD), have not been fully elucidated yet. The objective of the present study was to establish the relationship between the flexural strength of 5YZ with or without autoclave-induced LTD and its microstructural properties. For this purpose, a total of 320 bar-shaped specimens were cut from 5YZ and 3YZ blocks, and half of the specimens in each group were autoclaved at 134 °C for 50 h. Their flexural strengths were determined by conducting three-point bending tests, and the obtained results were analyzed by the Weibull statistical method. Grain sizes and crystalline structures of the specimens were analyzed by scanning electron microscopy (SEM) and X-ray diffraction, respectively. Additionally, the LTD-induced phase transformation was examined by Raman microscopy and cross-sectional surface analysis. The characteristic strengths of 5YZ and 3YZ were approximately 620 and 950 MPa, respectively, and 5YZ was found to be more resistant to LTD in terms of phase transformation than 3YZ. However, a low amount of the monoclinic phase was detected even in 5YZ after 50 h of autoclaving, which significantly decreased its flexural strength and reliability. The results of SEM analysis revealed that 5YZ was composed of two distinct regions: a dominant matrix with large grains (median size: 0.8 μm) and scattered areas with small grains (median size: 0.4 μm). Phase transformation analysis and fractography data indicated that the small-grain region was strongly affected by LTD and likely represented a fracture origin. The described properties should be considered during the clinical application of monolithic 5YZ dental prostheses. © 2020 Elsevier Ltd
|
|
7. |
|
|
8. |
|
|