| 1. |
|
|
| 2. |
|
|
| 3. |
|
|
| 4. |
|
|
| 5. |
- Andersson, Cristina, 1969, et al.
(author)
-
Thermal cycling of lead-free Sn-3.8Ag-0.7Cu 388PBGA packages
- 2009
-
In: Soldering and Surface Mount Technology. - : Emerald. - 1758-6836 .- 0954-0911. ; 21:2, s. 28-38
-
Journal article (peer-reviewed)abstract
- Purpose - The purpose of this paper is to assess the effect of different temperature cycling profiles on the reliability of lead-free 388 plastic ball grid array (PBGA) packages and to deeply understand crack initiation and propagation.Design/methodology/approach - Temperature cycling of Sn-3.8Ag-0.7Cu PBGA packages was carried out at two temperature profiles, the first ranging between - 55 degrees C and 100 degrees C (TC1) and the second between 0 degrees C and 100 degrees C (TC2). Crack initiation and propagation was analyzed periodically and totally 7,000 cycles were run for TO and 14,500 for TC2. Finite element modeling (FEM), for the analysis of strain and stress, was used to corroborate the experimental results.Findings - The paper finds that TC1 had a characteristic life of 5,415 cycles and TC2 of 14,094 cycles, resulting in an acceleration factor of 2.6 between both profiles. Cracks were first visible for TC1, after 2,500 cycles, and only after 4,000 cycles for TC2. The crack propagation rate was faster for TC1 compared to TC2, and faster at the package side compared to the substrate side. The difference in crack propagation rate between the package side and substrate side was much larger for TC1 compared to TC2. Cracks developed first at the package side, and were also larger compared to the substrate side. The Cu tracks on the substrate side affected the crack propagation sites and behaved as SMD. All cracks propagated through the solder and crack propagation was mainly intergranular. Crack propagation was very random and did not follow the distance to neutral point (DNP) theory. FEM corroborated the experimental results, showing both the same critical location of highest creep strain and the independence of DNP.Originality/value - Such extensive work on the reliability assessment of Pb-free 388 PBGA packages has never been performed. This work also corroborates the results from other studies showing the difference in behavior between Pb-free and Pb-containing alloys.
|
|
| 6. |
- Renders, B., et al.
(author)
-
Distributed generation and the voltage profile on distribution feeders during voltage dips
- 2010
-
In: Electric power systems research. - : Elsevier BV. - 0378-7796 .- 1873-2046. ; 80:12, s. 1452-1458
-
Journal article (peer-reviewed)abstract
- The presence of distributed generators in the distribution network results in an increase of the voltage magnitude close to these generators, during a fault elsewhere in the distribution system or in the transmission system. This voltage dip mitigation capability of converter-connected distributed generation (DG) units is dependent on the control strategy of the converter. To compare the influence of different types of converter-connected distributed generators on the voltage profile along distribution feeders during a fault, the quantity,"voltage ratio" is used. This voltage ratio is obtained by division of the voltage during the voltage dip by the voltage just before the voltage dip. The different converter types are modelled, and the influence on the voltage ratio is analysed.
|
|
