| 1. |
- Chen, Zhe, et al.
(author)
-
Effect of Cooling and Shot Peening on Residual Stresses and Fatigue Performance of Milled Inconel 718
- 2017
-
In: Residual Stresses 2016 ICRS 10. - : Materials Research Forum LLC. - 9781945291166 ; , s. 13-18
-
Conference paper (peer-reviewed)abstract
- The present study highlights the effect of cooling and post-machining surface treatment of shot peening on the residual stresses and corresponding fatigue life of milled superalloy Inconel 718. It was found that tensile residual stresses were created on the milled surface, regardless of the use of coolant, however, the wet milling operation led to a lower surface tension and a reduced thickness of the tensile layer. The shot peening performed on the dry-milled specimens completely annihilated the surface tensile residual tresses and introduced a high level of surface compression. A comparable fatigue life for the wet-milled specimens was obtained as compared with the specimens prepared by dry milling. This is very likely attributed to that the milling-induced surface damage with respect to cracked non-metallic inclusions is the predominant cause of the fatigue failure. The presence of the compressive layer induced by shot peening resulted in a significant increase of the fatigue life and strength, while the extent to which the lifetime was prolonged was decreased as the applied load was increased.
|
|
