1. |
- Ekman, Jörgen, et al.
(author)
-
Retention of Pb isotopes in glass surfaces for retrospective assessment of radon exposure
- 2006
-
In: Nuclear Instruments and Methods in Physics Research Section B. - : Elsevier. - 0168-583X .- 1872-9584. ; 249:1-2, s. 544-547
-
Journal article (peer-reviewed)abstract
- In recent years there has been increasing interest in radio-epidemiological techniques to retrospectively measure the radon dose exposure by determining the activity of 210Pb, the longest-lived 222Rn progeny, in glass surface layers. In this study the diffusion of 39 keV 209Pb+ ions implanted into glass using the IGISOL facility has been studied under conditions that mimic the recoil implantation of 210Pb from 222Rn. The resulting depth distributions of 209Pb were then measured after heat treatment in vacuum at different temperatures by a sputter erosion technique. The diffusion coefficient could be described by an Arrhenius equation D = D0exp(−H/kT) where and H = 2.81 ± 0.11 eV. No statistically significant loss of 209Pb from the sample was observed for annealing between 470 and 600 °C.
|
|
2. |
- Al-Adili, Ali, et al.
(author)
-
Simulations of the fission-product stopping efficiency in IGISOL
- 2015
-
In: European Physical Journal A. - : Springer Science and Business Media LLC. - 1434-6001 .- 1434-601X. ; 51:59, s. 1-7
-
Journal article (peer-reviewed)abstract
- At the Jyväskylä Ion Guide Isotope Separator On-Line (IGISOL) facility, independent fission yields are measured employing the Penning-trap technique. Fission products are produced, e.g. by impinging protons on a uranium target, and are stopped in a gas-filled chamber. The products are collected by a flow of He gas and guided through a mass separator to a Penning trap, where their masses are identified. This work investigates how fission-product properties, such as mass and energy, affect the ion stopping efficiency in the gas cell. The study was performed using the Geant4 toolkit and the SRIM code. The main results show a nearly mass-independent ion stopping with regard to the wide spread of ion masses and energies, with a proper choice of uranium target thickness. Although small variations were observed, in the order of 5%, the results are within the systematic uncertainties of the simulations. To optimize the stopping efficiency while reducing the systematic errors, different experimental parameters were varied; for instance material thicknesses and He gas pressure. Different parameters influence the mass dependence and could alter the mass dependencies in the ion stopping efficiency.
|
|
3. |
- Anthony, Niklas, et al.
(author)
-
Laser processing of minerals common on asteroids
- 2021
-
In: Optics and Laser Technology. - : Elsevier. - 0030-3992 .- 1879-2545. ; 135
-
Journal article (peer-reviewed)abstract
- Asteroid mining and redirection are two trends that both can utilize lasers, one to drill and cut, the other to ablate and move. Yet little is known about what happens when a laser is used to process the types of materials we typically expect to find on most asteroids. To shed light on laser processing of asteroid material, we used a 300-W, pulsed Ytterbium fiber laser on samples of olivine, pyroxene, and serpentine, and studied the process with a high-speed camera and illumination laser at 10 000 frames per second. We also measure the sizes of the resulting holes using X-ray micro-tomography to find the pulse parameters which remove the largest amount of material using the least amount of energy. We find that at these power densities, all three minerals will melt and chaotically throw off spatter. Short, low-power pulses can efficiently produce thin, deep holes, and long, high-power pulses are more energy efficient at removing the most amount of material.
|
|
4. |
- Gao, Zhihao, et al.
(author)
-
New design and simulation of the ion guide for neutron-induced fission products at the IGISOL facility
- 2023
-
In: EPJ Web of Conferences. - : EDP Sciences. - 2100-014X. ; 284
-
Journal article (peer-reviewed)abstract
- Measurements of independent fission yield distributions in neutron-induced fission at high neutron energies are important for our fundamental understanding of the fission process, and are also relevant for reactor physics applications. So far, measurements of independent fission yields in proton-induced fission have been performed at the IGISOL facility at the University of Jyväskylä, using the Penning trap as a high resolving-power mass-filter. In order to also facilitate measurements of neutron-induced fission, a dedicated ion guide and a proton-to-neutron converter was developed. However, the first measurement indicates that fewer fission products than expected reach the Penning trap. To explore potential reasons and possible improvements, a simulation model was also developed and benchmarked. The benchmark showed that the model is able to reproduce the performance of the ion guide remarkably well and that the main reason for the low yield of fission products is the low collection efficiency of the ion guide.Based on the benchmark, a new ion guide is being designed. In the new design, the positions of the uranium targets and volume of the ion guide have been changed to increase the collection of fission products. This results in a five-fold increase of the yield. However, the collection efficiency of the new ion guide still needs to be improved in order to achieve intensities of the extracted fission products that are large enough to allow for reasonable measurement times.Because the volume of the ion guide is increased significantly, the extraction time of the ions is expected to be longer than that from the previous ion guide. Therefore, an electric field guidance system that consists of a combination of a stationary electric field and an RF-carpet is considered to be deployed. The stationary field, produced from a set of DC-ring electrodes, accelerates the ions towards the RF-carpet at end plate of the ion guide. The RF-carpet consists of a time-dependent field, produced from a radio-frequent structure of concentric rings, with a DC-component that guides the ions towards the exit hole in the center of the end plate. In this paper we present the current status of the simulations and design of the new ion guide.
|
|
5. |
- Lantz, Mattias, 1971-, et al.
(author)
-
Design of a neutron converter for fission studies at the IGISOL facility
- 2012
-
In: Physica Scripta. - he Royal Swedish Academy of Sciences. - 0031-8949 .- 1402-4896. ; T150, s. 014020-
-
Conference paper (peer-reviewed)abstract
- The upgraded IGISOL facility with JYFLTRAP, at the accelerator laboratory of the University of Jyväskylä, has been supplied with a new cyclotron which will provide proton or deuteron beams of the order of 100 μA with up to 30 MeV energy. This makes it an ideal place for measurements of neutron-induced fission fragments from various actinides, in view of proposed future nuclear fuel cycles. In the present paper, some considerations for the design ofa neutron converter, based on simulations with the Monte Carlo codes MCNPX and FLUKA,are described.
|
|
6. |
|
|
7. |
- Mattera, Andrea, 1985-, et al.
(author)
-
Characterization of a Be(p,xn) neutron source for fission yields measurements
- 2014
-
In: Nuclear Data Sheets. - : Elsevier BV. - 0090-3752 .- 1095-9904. ; 119, s. 416-418
-
Journal article (peer-reviewed)abstract
- We report on measurements performed at The Svedberg Laboratory (TSL) to characterize a proton-neutron converter for independent fission yield studies at the IGISOL-JYFLTRAP facility (Jyväskylä, Finland). A 30-MeV proton beam impinged on a 5 mm water-cooled Beryllium target. Two independent experimental techniques have been used to measure the neutron spectrum: a Time-of-Flight (TOF) system to estimate the high-energy contribution, and a Bonner Sphere Spectrometer to provide precise results from thermal energies up to 20 MeV. An overlap between the energy regions covered by the two systems will permit a cross-check of the results from the different techniques. In this paper, the measurement and the analysis technique will be presented together with some preliminary results.
|
|
8. |
|
|
9. |
- Mattera, Andrea, 1985-, et al.
(author)
-
Production of Sn and Sb isotopes in high-energy neutron induced fission of natU
- 2018
-
In: European Physical Journal A. - : Springer Science and Business Media LLC. - 1434-6001 .- 1434-601X. ; 54
-
Journal article (peer-reviewed)abstract
- The first systematic measurement of neutron-induced fission yields has been performed at the upgraded IGISOL-4 facility at the University of Jyvaskyla, Finland. The fission products from high-energy neutron-induced fission of U-nat were stopped in a gas cell filled with helium buffer gas, and were online separated with a dipole magnet. The isobars, with masses in the range A = 128-133, were transported to a tape-implantation station and identified using gamma-spectroscopy. We report here the relative cumulative isotopic yields of tin (Z = 50) and the relative independent isotopic yields of antimony (Z = 51). Isomeric yield ratios were also obtained for five nuclides. The yields of tin show a staggered behaviour around A = 131, not observed in the ENDF/B-VII. 1 evaluation. The yields of antimony also contradict the trend from the evaluation, but are in agreement with a calculation performed using the GEF model that shows the yield increasing with mass in the range A = 128-133.
|
|
10. |
- Rakopoulos, Vasileios, et al.
(author)
-
Isomeric fission yield ratios for odd-mass Cd and In isotopes using the phase-imaging ion-cyclotron-resonance technique
- 2019
-
In: Physical Review C. - 2469-9985 .- 2469-9993. ; 99:1
-
Journal article (peer-reviewed)abstract
- Isomeric yield ratios for the odd-A isotopes of Cd119-127 and In119-127 from 25-MeV proton-induced fission on natural uranium have been measured at the JYFLTRAP double Penning trap, by employing the phase-imaging ion-cyclotron-resonance technique. With the significantly improved mass resolution of this novel method isomeric states separated by 140 keV from the ground state, and with half-lives of the order of 500 ms, could be resolved. This opens the door for obtaining new information on low-lying isomers, which are important for nuclear structure, fission, and astrophysics. In the present work the experimental isomeric yield ratios are used for the estimation of the root-mean-square angular momentum J(rms) of the primary fragments. The results show a dependency on the number of unpaired protons and neutrons, where the odd-Z In isotopes carry larger angular momenta. The deduced values of J(rms) display a linear relationship when compared with the electric quadrupole moments of the fission products.
|
|