| 11. |
- Ahmadi Moghaddam, Elham, et al.
(author)
-
Exploring the potential for biomethane production by willow pyrolysis using life cycle assessment methodology
- 2019
-
In: Energy, Sustainability and Society. - : Springer Science and Business Media LLC. - 2192-0567. ; 9
-
Journal article (peer-reviewed)abstract
- BackgroundBiomethane, as a potential substitute for natural gas, reduces the use of fossil-based sources, promoting bioenergy applications. Biomethane for energy use can be produced using a variety of biomass types and technologies. Biomethane from farmland crops is currently produced by anaerobic digestion (AD) of energy crops, which is a biological treatment of organic material resulting in biomethane and digestate. Recently, thermochemical conversion technologies of biomass to biomethane have gained attention. Pyrolysis is a thermochemical process whereby woody biomass is converted to fuel gas and biochar. This study assessed the land use efficiency of producing biomethane through a maize-based AD system compared with switching to a willow-based biomethane system using pyrolysis as an emerging technology. The energy performance and climate impact of the two pathways were assessed from a land use perspective, using life cycle assessment methodology. The entire technical system, from biomass production to delivery of biomethane as the end product, was included within the analysis. The study also investigated how the climate impact was affected when biochar was applied to soil to act as a soil amendment and carbon sequestration agent or when biochar was used as an energy source.ResultsPyrolysis of willow had a higher external energy ratio and climate mitigation effect than maize-based AD as a result of lower primary energy inputs and lower methane loss in the pyrolysis process and upgrading units. Furthermore, the biochar from willow pyrolysis, when used as a soil amendment or energy source, contributed significantly to the climate impact mitigation potential in both cases. Substituting fossil gas with biomethane gave a considerable reduction in climate impact in all scenarios, especially in the case of willow pyrolysis. The willow pyrolysis system acted as a carbon sink, resulting in a negative climate impact, counteracting global warming.ConclusionFrom a land use perspective, the transition from maize-based AD to a willow-based pyrolysis system for biomethane production could be beneficial regarding the energy performance and climate impact. Application of biochar to the soil in the willow scenario contributed significantly to counteracting emissions of greenhouse gases.
|
|
| 12. |
- Aho-Mantila, L., et al.
(author)
-
Assessment of SOLPS5.0 divertor solutions with drifts and currents against L-mode experiments in ASDEX Upgrade and JET
- 2017
-
In: Plasma Physics and Controlled Fusion. - : IOP PUBLISHING LTD. - 0741-3335 .- 1361-6587. ; 59:3
-
Journal article (peer-reviewed)abstract
- The divertor solutions obtained with the plasma edge modelling tool SOLPS5.0 are discussed. The code results are benchmarked against carefully analysed L-mode discharges at various density levels with and without impurity seeding in the full-metal tokamaks ASDEX Upgrade and JET. The role of the cross-field drifts and currents in the solutions is analysed in detail, and the improvements achieved by fully activating the drift and current terms in view of matching the experimental signals are addressed. The persisting discrepancies are also discussed.
|
|
| 13. |
- Andersson, J. Y., et al.
(author)
-
Quantum structure based infrared detector research and development within Acreo's centre of excellence IMAGIC
- 2010
-
In: Infrared physics & technology. - : Elsevier BV. - 1350-4495 .- 1879-0275. ; 53:4, s. 227-230
-
Journal article (peer-reviewed)abstract
- Acreo has a long tradition of working with quantum structure based infrared (IR) detectors and arrays. This includes QWIP (quantum well infrared photodetector), QDIP (quantum dot infrared photodetector), and InAs/GaInSb based photon detectors of different structure and composition. It also covers R&D on uncooled microbolometers. The integrated thermistor material of such detectors is advantageously based on quantum structures that are optimised for high temperature coefficient and low noise. Especially the SiGe material system is preferred due to the compatibility with silicon technology. The R&D work on IR detectors is a prominent part of Acreo's centre of excellence "IMAGIC" on imaging detectors and systems for non-visible wavelengths. IMAGIC is a collaboration between Acreo, several industry partners and universities like the Royal Institute of Technology (KTH) and Linkoping University. (C) 2010 Elsevier B.V. All rights reserved.
|
|
| 14. |
- Andersson, Lena, 1965-, et al.
(author)
-
Respiratory Health and Inflammatory Markers : Exposure to Cobalt in the Swedish Hard Metal Industry
- 2020
-
In: Journal of Occupational and Environmental Medicine. - : Lippincott Williams & Wilkins. - 1076-2752 .- 1536-5948. ; 62:10, s. 820-829
-
Journal article (peer-reviewed)abstract
- OBJECTIVE: To study the relationship between inhalable dust and cobalt and respiratory symptoms, lung function, exhaled nitric oxide in expired air and CC16 in the Swedish hard metal industry.METHODS: Personal sampling of inhalable dust and cobalt, medical examination including blood sampling was performed for 72 workers. Exposure-response relationships was determined using logistic, linear and mixed model analysis.RESULTS: The average inhalable dust and cobalt concentrations were 0.079 and 0.0017 mg/m, respectively. Statistically significant increased serum levels of CC16 were determined when the high and low cumulative exposures for cobalt were compared. Non-significant exposure-response relationships was observed between cross-shift inhalable dust or cobalt exposures and asthma, nose dripping and bronchitis.CONCLUSIONS: Our findings suggest an exposure-response relationship between inhalable cumulative cobalt exposure and CC16 levels in blood, which may reflect an injury or a reparation process in the lungs.
|
|
| 15. |
- Andersson Sundén, Erik, et al.
(author)
-
An assessment of nitrogen concentrations from spectroscopic measurements in the JET and ASDEX upgrade divertor
- 2019
-
In: Nuclear Materials and Energy. - : Elsevier. - 2352-1791. ; 18, s. 147-152
-
Journal article (peer-reviewed)abstract
- The impurity concentration in the tokamak divertor plasma is a necessary input for predictive scaling of divertor detachment, however direct measurements from existing tokamaks in different divertor plasma conditions are limited. To address this, we have applied a recently developed spectroscopic N II line ratio technique for measuring the N concentration in the divertor to a range of H-mode and L-mode plasma from the ASDEX Upgrade and JET tokamaks, respectively. The results from both devices show that as the power crossing the separatrix, P-sep, is increased under otherwise similar core conditions (e.g. density), a higher N concentration is required to achieve the same detachment state. For example, the N concentrations at the start of detachment increase from approximate to 2% to approximate to 9% as P-sep, is increased from approximate to 2.5 MW to approximate to 7 MW. These results tentatively agree with scaling law predictions (e.g. Goldston et al.) motivating a further study examining the parameters which affect the N concentration required to reach detachment. Finally, the N concentrations from spectroscopy and the ratio of D and N gas valve fluxes agree within experimental uncertainty only when the vessel surfaces are fully-loaded with N.
|
|
| 16. |
|
|
| 17. |
- Angioni, C., et al.
(author)
-
Dependence of the turbulent particle flux on hydrogen isotopes induced by collisionality
- 2018
-
In: Physics of Plasmas. - : American Institute of Physics (AIP). - 1070-664X .- 1089-7674 .- 1070-6631 .- 1089-7666. ; 25:8
-
Journal article (peer-reviewed)abstract
- The impact of the change of the mass of hydrogen isotopes on the turbulent particle flux is studied. The trapped electron component of the turbulent particle convection induced by collisionality, which is outward in ion temperature gradient turbulence, increases with decreasing thermal velocity of the isotope. Thereby, the lighter is the isotope, the stronger is the turbulent pinch, and the larger is the predicted density gradient at the null of the particle flux. The passing particle component of the flux increases with decreasing mass of the isotope and can also affect the predicted density gradient. This effect is however subdominant for usual core plasma parameters. The analytical results are confirmed by means of both quasi-linear and nonlinear gyrokinetic simulations, and an estimate of the difference in local density gradient produced by this effect as a function of collisionality has been obtained for typical plasma parameters at mid-radius. Analysis of currently available experimental data from the JET and the ASDEX Upgrade tokamaks does not show any clear and general evidence of inconsistency with this theoretically predicted effect outside the errorbars and also allows the identification of cases providing weak evidence of qualitative consistency.
|
|
| 18. |
- Angioni, C., et al.
(author)
-
Gyrokinetic study of turbulent convection of heavy impurities in tokamak plasmas at comparable ion and electron heat fluxes
- 2017
-
In: Nuclear Fusion. - : IOP PUBLISHING LTD. - 0029-5515 .- 1741-4326. ; 57:2
-
Journal article (peer-reviewed)abstract
- In tokamaks, the role of turbulent transport of heavy impurities, relative to that of neoclassical transport, increases with increasing size of the plasma, as clarified by means of general scalings, which use the ITER standard scenario parameters as reference, and by actual results from a selection of discharges from ASDEX Upgrade and JET. This motivates the theoretical investigation of the properties of the turbulent convection of heavy impurities by nonlinear gyrokinetic simulations in the experimentally relevant conditions of comparable ion and electron heat fluxes. These conditions also correspond to an intermediate regime between dominant ion temperature gradient turbulence and trapped electron mode turbulence. At moderate plasma toroidal rotation, the turbulent convection of heavy impurities, computed with nonlinear gyrokinetic simulations, is found to be directed outward, in contrast to that obtained by quasi-linear calculations based on the most unstable linear mode, which is directed inward. In this mixed turbulence regime, with comparable electron and ion heat fluxes, the nonlinear results of the impurity transport can be explained by the coexistence of both ion temperature gradient and trapped electron modes in the turbulent state, both contributing to the turbulent convection and diffusion of the impurity. The impact of toroidal rotation on the turbulent convection is also clarified.
|
|
| 19. |
- Angioni, C., et al.
(author)
-
The impact of poloidal asymmetries on tungsten transport in the core of JET H-mode plasmas
- 2015
-
In: Physics of Plasmas. - : AMER INST PHYSICS. - 1070-664X .- 1089-7674. ; 22:5
-
Journal article (peer-reviewed)abstract
- Recent progress in the understanding and prediction of the tungsten behaviour in the core of JET H-mode plasmas with ITER-like wall is presented. Particular emphasis is given to the impact of poloidal asymmetries of the impurity density. In particular, it is shown that the predicted reduction of temperature screening induced by the presence of low field side localization of the tungsten density produced by the centrifugal force is consistent with the observed tungsten behaviour in a JET discharge in H-mode baseline scenario. This provides first evidence of the role of poloidal asymmetries in reducing the strength of temperature screening. The main differences between plasma parameters in JET baseline and hybrid scenario discharges which affect the impact of poloidally asymmetric density on the tungsten radial transport are identified. This allows the conditions by which tungsten accumulation can be avoided to be more precisely defined.
|
|
| 20. |
- Appel, L. C., et al.
(author)
-
Equilibrium reconstruction in an iron core tokamak using a deterministic magnetisation model
- 2018
-
In: Computer Physics Communications. - : ELSEVIER. - 0010-4655 .- 1879-2944. ; 223, s. 1-17
-
Journal article (peer-reviewed)abstract
- In many tokamaks ferromagnetic material, usually referred to as an iron-core, is present in order to improve the magnetic coupling between the solenoid and the plasma. The presence of the iron core in proximity to the plasma changes the magnetic topology with consequent effects on the magnetic field structure and the plasma boundary. This paper considers the problem of obtaining the free-boundary plasma equilibrium solution in the presence of ferromagnetic material based on measured constraints. The current approach employs, a model described by O'Brien et al. (1992) in which the magnetisation currents at the iron-air boundary are represented by a set of free parameters and appropriate boundary conditions are enforced via a set of quasi-measurements on the material boundary. This can lead to the possibility of overfitting the data and hiding underlying issues with the measured signals. Although the model typically achieves good fits to measured magnetic signals there are significant discrepancies in the inferred magnetic topology compared with other plasma diagnostic measurements that are independent of the magnetic field. An alternative approach for equilibrium reconstruction in iron-core tokamaks, termed the deterministic magnetisation model is developed and implemented in EFIT++. The iron is represented by a boundary current with the gradients in the magnetisation dipole state generating macroscopic internal magnetisation currents. A model for the boundary magnetisation currents at the iron-air interface is developed using B-Splines enabling continuity to arbitrary order; internal magnetisation currents are allocated to triangulated regions within the iron, and a method to enable adaptive refinement is implemented. The deterministic model has been validated by comparing it with a synthetic 2-D electromagnetic model of JET. It is established that the maximum field discrepancy is less than 1.5 mT throughout the vacuum region enclosing the plasma. The discrepancies of simulated magnetic probe signals are accurate to within 1% for signals with absolute magnitude greater than 100 mT; in all other cases agreement is to within 1 mT. The effect of neglecting the internal magnetisation currents increases the maximum discrepancy in the vacuum region to >20 mT, resulting in errors of 5%-10% in the simulated probe signals. The fact that the previous model neglects the internal magnetisation currents (and also has additional free parameters when fitting the measured data) makes it unsuitable for analysing data in the absence of plasma current. The discrepancy of the poloidal magnetic flux within the vacuum vessel is to within 0.1 Wb. Finally the deterministic model is applied to an equilibrium force-balance solution of a JET discharge using experimental data. It is shown that the discrepancies of the outboard separatrix position, and the outer strike-point position inferred from Thomson Scattering and Infrared camera data are much improved beyond the routine equilibrium reconstruction, whereas the discrepancy of the inner strike-point position is similar.
|
|
