1. |
- Karimipanah, Taghi, 1953-, et al.
(author)
-
Maximum velocity of return flow close to the floor in a ventilated room - experimental and numerical results
- 1996
-
Conference paper (peer-reviewed)abstract
- The problem of sensation of draught in ventilated spaces is connected to inappropriate velocities in the occupied zone. In Scandinavia, velocities higher than 0.15 m/s are said to be an indicator of that occupants are likely to feel discomfort. Therefore knowledge of the flow field (both mean velocities and fluctuations) is necessary. Both experimental and numerical analysis of the flow field in a full scale room ventilated by a slot inlet, with two inlet Reynolds numbers 2440 and 7110, have been carried out . Results from both approaches show that the location of the maximum velocity near the floor is nearly independent of the Reynolds number. For a two-dimensional room, the maximum velocity at the floor level occurred at about 213 room length from the supply. The distance from the floor level is dependent on the inlet Reynolds number. The velocity profiles far away from the wall opposite to the inlet device have the same character as a wall jet profile. However, close to the corners they are transformed. The relative turbulence intensities measured in the return flow region are questionable, because of a hot wire's inability to record large fluctuations at low mean velocities. These turbulence intensities close to floor level vary from 15 to 80 % and as the authors have pointed out previously hot wires do not indicate the real value of the turbulence intensities beyond 20%. Difficulties appear in numerical predictions of return flow properties. Comparison between predicted values and experimentally obtained values show a reasonable agreement. This is promising for future CFD-predictions. However, there is a need for an appropriate measurement technique that can cope with reversing flow.
|
|
2. |
- Karimipanah, Taghi, 1953-
(author)
-
Turbulent jets in confined spaces : application in mixing ventilation: experimental and numerical studies
- 1996
-
Doctoral thesis (other academic/artistic)abstract
- The basis of mixing ventilation is the airflow supply to the room by means of jets initiatedfrom the ventilation diffusers. To avoid the draught problem, the design of mixing ventilationmakes uses the throw term, which is defined as the distance to the supply air terminal inwhich the jet centreline mean velocity is decreased to a given value. Traditionally, the throw ismeasured by the supply air device manufacturer. The throw is applied by designers to estimatethe velocity levels in the occupied zone. A standard for determining the throw is the CENstandard CEN/TC156/WG4 N86 "Draft Standard. Air terminal Devices. AerodynamicsTesting And Rating For Mixed Flow Application".The measurement of the throw is very time consuming even with the free jets and theinfluence of the room (the effect of confinement) is not considered. The objective of thepresent study is to give a basis for modifying the existing design and testing method used topredict the velocities in the occupied zone during the design process. A new method whichmay probably be more easier than the existing methods and at the same time give a betterprecision by including the confinement effect.In this thesis two methodological systems of experiment and numerical simulations have beenused. The numerical predictions are used in comparison with the measurements. Thereasonable agreement of the above mentioned methods is implemented to numerical study ofthe other room configurations which are not experimentally studied. This examining methodallows the possibility of studying a lot of configurations and in this manner generalising of theresults. Although the experimental part was made for both model-scale and full-scale testrooms, a large amount of data was obtained for a new test room whose dimension aresystematically varied. All of studies have been made for the isothermal case and themeasurements of velocities and pressures conducted along the room perimeters. The effect ofshort and deep rooms on the properties of the jet ( velocities, pressure, integral scale, jetmomentum, the rate of spreading of jet and turbulence intensities) have been carried out.Some old and recent investigations have been examined. Specially the concept of correlationsfrom open to closed rooms is criticised. It is also shown that the flow field in a confined roomis affected by many other factors than the Reynolds number. The surface pressure on theperimeters was used to calculate the reaction forces at the corners which causes recirculatingbubbles at corners. A study of the turbulent axisymmetric jet which is the basic element inturbulent shear flows and some restrictions of the traditional measurement techniques at theregion of interest in ventilation applications are discussed. The jet momentum is measured byweighing on a balance. Also a study of jets which collide with a wall , that is impinging jet,the effect of walls and confinement on the jet momentum have experimentally andnumerically been carried out. A new momentum balance model was developed for both thefree jet and confined one. An empirical relation has been found for estimation of the room’srotation centre which is used for validation of CFD results.Finally, it is found that the jets in a ventilated room which are a combination of free jet, walljet and impinging jet differ from the traditional wall jets. The rate of spreading of the jet andthe maximum velocity decay in a ventilated room are also different depending on the roomsize and its confinement.
|
|