1. |
- Ferrero, Luca, et al.
(author)
-
Airborne and marine microplastics from an oceanographic survey at the Baltic Sea : An emerging role of air-sea interaction?
- 2022
-
In: Science of the Total Environment. - : Elsevier BV. - 0048-9697 .- 1879-1026. ; 824
-
Journal article (peer-reviewed)abstract
- Microplastics (MPs) pollution is one of the most important problems of the Earth. They have been found in all the natural environments, including oceans and the atmosphere. In this study, the concentrations of both atmospheric and marine MPs were measured over the Baltic along a research cruise that started in the Gdansk harbour, till the Gotland island, and the way back. A deposition box (based on a combination of active/passive sampling) was used to collect airborne MPs while, marine MPs concentrations were investigated during the cruise using a dedicated net. Ancillary data were obtained using a combination of particle counters (OPC, LAS and CPC), Aethalometer (AE33 Magee Scientific), spectrofluorometer (sea surface samples, Varian Cary Eclipse), and meteorological sensors. Results showed airborne microplastics average concentrations higher in the Gdansk harbour (161 ± 75 m−3) compared to the open Baltic Sea and to the Gotland island (24 ± 9 and 45 ± 20 m−3). These latter values are closer to the ones measured in the sea (79 ± 18 m−3). The MPs composition was investigated using μ-Raman (for the airborne ones) and FTIR (for marine ones); similar results (e.g. polyethylene, polyethylene terephthalates, polyurethane) were found in the two environmental compartments. The concentrations and similar composition in air and sea suggested a linkage between the two compartments. For this purpose, the atmospheric MPs' equivalent aerodynamic diameter was calculated (28 ± 3 μm) first showing the capability of atmospheric MPs to remain suspended in the air. At the same time, the computed turnover times (0.3–90 h; depending on MPs size) limited the transport distance range. The estimated MPs sea emission fluxes (4–18 ∗ 106 μm3 m−2 s−1 range) finally showed the contemporary presence of atmospheric transport together with a continuous emission from the sea surface enabling a grasshopper long-range transport of microplastics across the sea.
|
|
2. |
- Ferrero, L., et al.
(author)
-
Determining the Aethalometer multiple scattering enhancement factor C from the filter loading parameter
- 2024
-
In: Science of the Total Environment. - 0048-9697 .- 1879-1026. ; 917
-
Journal article (peer-reviewed)abstract
- Light-absorbing aerosols heat the atmosphere; an accurate quantification of their absorption coefficient is mandatory. However, standard reference instruments (CAPS, MAAP, PAX, PTAAM) are not always available at each measuring site around the world.By integrating all previous published studies concerning the Aethalometers, the AE33 filter loading parameter, provided by the dual-spot algorithm, were used to determine the multiple scattering enhancement factor from the Aethalometer itself (hereinafter CAE) on an yearly and a monthly basis. The method was developed in Milan, where Aethalometer measurements were compared with MAAP data; the comparison showed a good agreement in terms of equivalent black carbon (R2 = 0.93; slope = 1.02 and a negligible intercept = 0.12 μg m−3) leading to a yearly experimental multiple scattering enhancement factor of 2.51 ± 0.04 (hereinafter CMAAP). On a yearly time base the CAE values obtained using the new approach was 2.52 ± 0.01, corresponding to the experimental one (CMAAP). Considering the seasonal behavior, higher experimental CMAAP and computed CAE values were found in summer (2.83 ± 0.12) whereas, the lower ones in winter/early-spring (2.37 ± 0.03), in agreement with the single scattering albedo behavior in the Po Valley.Overall, the agreement between the experimental CMAAP and CAE showed a root mean squared error (RMSE) of just 0.038 on the CMAAP prediction, characterized by a slope close to 1 (1.001 ± 0.178), a negligible intercept (−0.002 ± 0.455) and a high degree of correlation (R2 = 0.955). From an environmental point of view, the application of a dynamic (space/time) determination of CAE increases the accuracy of the aerosol heating rate (compared to applying a fixed C value) up to 16 % solely in Milan, and to 114 % when applied in the Arctic at 80°N.
|
|