1. |
- Kelly, J. J., et al.
(author)
-
Recoil polarization measurements for neutral pion electroproduction at Q(2)=1(GeV/c)(2) near the Delta resonance
- 2007
-
In: Physical Review C (Nuclear Physics). - 0556-2813. ; 75:2
-
Journal article (peer-reviewed)abstract
- We measured angular distributions of differential cross section, beam analyzing power, and recoil polarization for neutral pion electroproduction at Q(2)=1.0 (GeV/c)(2) in 10 bins of 1.17 <= W <= 1.35 GeV across the Delta resonance. A total of 16 independent response functions were extracted, of which 12 were observed for the first time. Comparisons with recent model calculations show that response functions governed by real parts of interference products are determined relatively well near the physical mass, W=M-Delta approximate to 1.232 GeV, but the variation among models is large for response functions governed by imaginary parts, and for both types of response functions, the variation increases rapidly with W > M-Delta. We performed a multipole analysis that adjusts suitable subsets of center dot(pi)<= 2 amplitudes with higher partial waves constrained by baseline models. This analysis provides both real and imaginary parts. The fitted multipole amplitudes are nearly model independent-there is very little sensitivity to the choice of baseline model or truncation scheme. By contrast, truncation errors in the traditional Legendre analysis of N ->Delta quadrupole ratios are not negligible. Parabolic fits to the W dependence around M-Delta for the multiple analysis gives values for Re(S1+/M1+)=(-6.61 +/- 0.18)% and Re(E1+/M1+)=(-2.87 +/- 0.19)% for the p pi(0) channel at W=1.232 GeV and Q(2)=1.0 (GeV/c)(2) that are distinctly larger than those from the Legendre analysis of the same data. Similarly, the multipole analysis gives Re(S0+/M1+)=(+7.1 +/- 0.8)% at W=1.232 GeV, consistent with recent models, while the traditional Legendre analysis gives the opposite sign because its truncation errors are quite severe.
|
|
2. |
|
|
3. |
|
|
4. |
|
|
5. |
- Litnovsky, Andrey, et al.
(author)
-
Carbon transport, deposition and fuel accumulation in castellated structures exposed in TEXTOR
- 2007
-
In: Journal of Nuclear Materials. - : Elsevier BV. - 0022-3115 .- 1873-4820. ; 367, s. 1481-1486
-
Journal article (peer-reviewed)abstract
- In order to maintain the thermo-mechanical durability of ITER it is proposed to castellate the interior surface of the first wall and divertor by splitting them into small-size cells [W. Daener et a]., Fusion Eng. Des. 61&62 (2002) 61]. A concern is the accumulation of fuel in the gaps of the castellation. In TEXTOR, molybdenum limiters were exposed in the scrape-off layer (SOL) plasma to assess fuel accumulation. The first limiter was exposed under deposition-dominated conditions. Carbon deposits were formed both on top surfaces and in the gaps. About 0.12% of the impinging D-fluence was found in the gaps. Another castellated limiter was exposed under erosion-dominated conditions. Deposited layers were found only on the plasma shadowed areas of the gaps. A significant amount of molybdenum from the limiter was found intermixed in the deposit. The gaps contained similar to 0.03% of the impinging D-fluence. Modeling was performed to simulate carbon transport into the gaps.
|
|