| 1. |
- Romanelli, F, et al.
(author)
-
Overview of the JET results
- 2011
-
In: Nuclear Fusion. - : IOP Publishing. - 1741-4326 .- 0029-5515. ; 51:9
-
Journal article (peer-reviewed)abstract
- Since the last IAEA Conference JET has been in operation for one year with a programmatic focus on the qualification of ITER operating scenarios, the consolidation of ITER design choices and preparation for plasma operation with the ITER-like wall presently being installed in JET. Good progress has been achieved, including stationary ELMy H-mode operation at 4.5 MA. The high confinement hybrid scenario has been extended to high triangularity, lower ρ*and to pulse lengths comparable to the resistive time. The steady-state scenario has also been extended to lower ρ*and ν*and optimized to simultaneously achieve, under stationary conditions, ITER-like values of all other relevant normalized parameters. A dedicated helium campaign has allowed key aspects of plasma control and H-mode operation for the ITER non-activated phase to be evaluated. Effective sawtooth control by fast ions has been demonstrated with3He minority ICRH, a scenario with negligible minority current drive. Edge localized mode (ELM) control studies using external n = 1 and n = 2 perturbation fields have found a resonance effect in ELM frequency for specific q95values. Complete ELM suppression has, however, not been observed, even with an edge Chirikov parameter larger than 1. Pellet ELM pacing has been demonstrated and the minimum pellet size needed to trigger an ELM has been estimated. For both natural and mitigated ELMs a broadening of the divertor ELM-wetted area with increasing ELM size has been found. In disruption studies with massive gas injection up to 50% of the thermal energy could be radiated before, and 20% during, the thermal quench. Halo currents could be reduced by 60% and, using argon/deuterium and neon/deuterium gas mixtures, runaway electron generation could be avoided. Most objectives of the ITER-like ICRH antenna have been demonstrated; matching with closely packed straps, ELM resilience, scattering matrix arc detection and operation at high power density (6.2 MW m-2) and antenna strap voltages (42 kV). Coupling measurements are in very good agreement with TOPICA modelling. © 2011 IAEA, Vienna.
|
|
| 2. |
- Abel, I, et al.
(author)
-
Overview of the JET results with the ITER-like wall
- 2013
-
In: Nuclear Fusion. - : IOP Publishing. - 1741-4326 .- 0029-5515. ; 53:10, s. 104002-
-
Journal article (peer-reviewed)abstract
- Following the completion in May 2011 of the shutdown for the installation of the beryllium wall and the tungsten divertor, the first set of JET campaigns have addressed the investigation of the retention properties and the development of operational scenarios with the new plasma-facing materials. The large reduction in the carbon content (more than a factor ten) led to a much lower Z(eff) (1.2-1.4) during L- and H-mode plasmas, and radiation during the burn-through phase of the plasma initiation with the consequence that breakdown failures are almost absent. Gas balance experiments have shown that the fuel retention rate with the new wall is substantially reduced with respect to the C wall. The re-establishment of the baseline H-mode and hybrid scenarios compatible with the new wall has required an optimization of the control of metallic impurity sources and heat loads. Stable type-I ELMy H-mode regimes with H-98,H-y2 close to 1 and beta(N) similar to 1.6 have been achieved using gas injection. ELM frequency is a key factor for the control of the metallic impurity accumulation. Pedestal temperatures tend to be lower with the new wall, leading to reduced confinement, but nitrogen seeding restores high pedestal temperatures and confinement. Compared with the carbon wall, major disruptions with the new wall show a lower radiated power and a slower current quench. The higher heat loads on Be wall plasma-facing components due to lower radiation made the routine use of massive gas injection for disruption mitigation essential.
|
|
| 3. |
- Bruggmann, P., et al.
(author)
-
Historical epidemiology of hepatitis C virus (HCV) in selected countries
- 2014
-
In: Journal of Viral Hepatitis. - Hoboken : Wiley-Blackwell. - 1352-0504 .- 1365-2893. ; 21, s. 5-33
-
Journal article (peer-reviewed)abstract
- Chronic infection with hepatitis C virus (HCV) is a leading indicator for liver disease. New treatment options are becoming available, and there is a need to characterize the epidemiology and disease burden of HCV. Data for prevalence, viremia, genotype, diagnosis and treatment were obtained through literature searches and expert consensus for 16 countries. For some countries, data from centralized registries were used to estimate diagnosis and treatment rates. Data for the number of liver transplants and the proportion attributable to HCV were obtained from centralized databases. Viremic prevalence estimates varied widely between countries, ranging from 0.3% in Austria, England and Germany to 8.5% in Egypt. The largest viremic populations were in Egypt, with 6358000 cases in 2008 and Brazil with 2106000 cases in 2007. The age distribution of cases differed between countries. In most countries, prevalence rates were higher among males, reflecting higher rates of injection drug use. Diagnosis, treatment and transplant levels also differed considerably between countries. Reliable estimates characterizing HCV-infected populations are critical for addressing HCV-related morbidity and mortality. There is a need to quantify the burden of chronic HCV infection at the national level.
|
|
| 4. |
- Razavi, H., et al.
(author)
-
The present and future disease burden of hepatitis C virus (HCV) infection with today's treatment paradigm
- 2014
-
In: Journal of Viral Hepatitis. - Hoboken : Wiley-Blackwell. - 1352-0504 .- 1365-2893. ; 21:Suppl. 1, s. 34-59
-
Journal article (peer-reviewed)abstract
- The disease burden of hepatitis C virus (HCV) is expected to increase as the infected population ages. A modelling approach was used to estimate the total number of viremic infections, diagnosed, treated and new infections in 2013. In addition, the model was used to estimate the change in the total number of HCV infections, the disease progression and mortality in 2013-2030. Finally, expert panel consensus was used to capture current treatment practices in each country. Using today's treatment paradigm, the total number of HCV infections is projected to decline or remain flat in all countries studied. However, in the same time period, the number of individuals with late-stage liver disease is projected to increase. This study concluded that the current treatment rate and efficacy are not sufficient to manage the disease burden of HCV. Thus, alternative strategies are required to keep the number of HCV individuals with advanced liver disease and liver-related deaths from increasing.
|
|
| 5. |
- Wedemeyer, H., et al.
(author)
-
Strategies to manage hepatitis C virus (HCV) disease burden
- 2014
-
In: Journal of Viral Hepatitis. - Hoboken : Wiley-Blackwell. - 1352-0504 .- 1365-2893. ; 21, s. 60-89
-
Journal article (peer-reviewed)abstract
- The number of hepatitis C virus (HCV) infections is projected to decline while those with advanced liver disease will increase. A modeling approach was used to forecast two treatment scenarios: (i) the impact of increased treatment efficacy while keeping the number of treated patients constant and (ii) increasing efficacy and treatment rate. This analysis suggests that successful diagnosis and treatment of a small proportion of patients can contribute significantly to the reduction of disease burden in the countries studied. The largest reduction in HCV-related morbidity and mortality occurs when increased treatment is combined with higher efficacy therapies, generally in combination with increased diagnosis. With a treatment rate of approximately 10%, this analysis suggests it is possible to achieve elimination of HCV (defined as a >90% decline in total infections by 2030). However, for most countries presented, this will require a 3-5 fold increase in diagnosis and/or treatment. Thus, building the public health and clinical provider capacity for improved diagnosis and treatment will be critical.
|
|
| 6. |
|
|
| 7. |
|
|
| 8. |
|
|
| 9. |
|
|
