| 1. |
|
|
| 2. |
|
|
| 3. |
- Haslett, Sophie, 1988-, et al.
(author)
-
Nighttime NO emissions strongly suppress chlorine and nitrate radical formation during the winter in Delhi
- 2023
-
In: Atmospheric Chemistry And Physics. - 1680-7316 .- 1680-7324. ; 23:16, s. 9023-9036
-
Journal article (peer-reviewed)abstract
- Atmospheric pollution in urban regions is highly influenced by oxidants due to their important role in the formation of secondary organic aerosol (SOA) and smog. These include the nitrate radical (NO3), which is typically considered a nighttime oxidant, and the chlorine radical (Cl), an extremely potent oxidant that can be released in the morning in chloride-rich environments as a result of nocturnal build-up of nitryl chloride (ClNO2). Chloride makes up a higher percentage of particulate matter in Delhi than has been observed anywhere else in the world, which results in Cl having an unusually strong influence in this city. Here, we present observations and model results revealing that atmospheric chemistry in Delhi exhibits an unusual diel cycle that is controlled by high concentrations of NO during the night. As a result of this, the formation of both NO3 and dinitrogen pentoxide (N2O5), a precursor of ClNO2 and thus Cl, are suppressed at night and increase to unusually high levels during the day. Our results indicate that a substantial reduction in nighttime NO has the potential to increase both nocturnal oxidation via NO(3 )and the production of Cl during the day.
|
|
| 4. |
- Keck, Hannes, et al.
(author)
-
Setting-aside cropland did not reduce greenhouse gas emissions from a drained peat soil in Sweden
- 2024
-
In: Frontiers in Environmental Science. - : Frontiers Media S.A.. - 2296-665X. ; 12
-
Journal article (peer-reviewed)abstract
- In the process of their formation, northern peatlands were accumulating vast amounts of carbon (C). When drained for agricultural use, a large proportion of that C is oxidized and emitted as carbon dioxide (CO2), turning those peatlands to strong CO2 emitters. As a mitigation option, setting-aside farmland on drained peat is being incentivized by policies, but recent evidence casts doubt on these policies' efficiency for greenhouse gas (GHG) emission mitigation. To investigate the effects of setting-aside farmland on GHG fluxes from a Swedish peatland, we measured CO2, nitrous oxide (N2O), and methane (CH4) fluxes on two adjacent sites under contrasting management. The cultivated (CL) site was used for cereal production (wheat or barley) and the set-aside (SA) site was under permanent grassland. Carbon dioxide fluxes were measured from 2013 to 2019 using the eddy covariance (EC) method. Additionally, CO2, N2O, and CH4 fluxes were measured during the growing seasons of 2018-2020, using transparent and opaque chambers on vegetated plots and on bare peat. The cumulative CO2 fluxes measured by EC over the measurement period were 0.97 (+/- 0.05) and 2.09 (+/- 0.17) kg m-2 with annual average losses of 0.16 and 0.41 kg CO2 m-2 yr-1 for the CL and SA site, respectively. Thus, the SA site acted as a stronger CO2 source than the CL site. Both sites' contribution to global warming, calculated on basis of the chamber measurements, was dominated by CO2. The contribution of the SA site was higher than that of the CL site. Nitrous oxide emissions were low at both sites with higher emissions from the CL site for transparent measurements and measurements on bare peat. Whereas, CH4 uptake was highest on the SA grassland. Thus, on the basis of our study, we found no evidence that setting-aside farmland on shallow drained peat soils will reduce GHG emissions or even turn the peatland into a C sink.
|
|
| 5. |
- Veljkovic, Milan, et al.
(author)
-
High-strength tower in steel for wind turbines (Histwin) : Final report
- 2012
-
Reports (peer-reviewed)abstract
- Innovative solutions for assembling joints of a tubular tower for wind turbines were studied and the project provides a background for design. This solution is simpler to produce and 80 % less expensive than traditional flange connection. Our feasibility study at the production plant indicates that the towers would be easy to assemble in situ. In addition to the direct cost savings due to the technical simplicity of the solution, the higher fatigue endurance than that of the flange connection is experimentally established. Further reduction of costs due to optimal use of higher-strength steel grades, especially in the bottom segments of the tower where the stiffening of the door opening is costly, is shown in the report. The total reduction of the costs for tower is estimated at about 10–15 % compared to the traditional tower. The project objectives are achieved in following sequences. • Experimental activities of the friction connection: small-scale tests to establish resistance of the friction connection for a variety of faying surfaces and bolt types, accompanying testing to ensure realistic input data for FEA, long-term testing to establish loss of pretension forces during the lifetime and fatigue tests.• Bending test of the friction and flange connection in a down-scaled tower. • Feasibility of production of the tower segments in the laboratory and at the production plant. • Monitoring of the existing tower to access a stress variation during the operation. • FEA analysis of experimental results and a complete case study of the monitored tower. Numerical examples for design of the friction connection are given for the sake of illustration and to encourage use of the new connection
|
|
