| 1. |
- Adcox, K, et al.
(author)
-
PHENIX detector overview
- 2003
-
In: Nuclear Instruments & Methods in Physics Research. Section A: Accelerators, Spectrometers, Detectors, and Associated Equipment. - 0167-5087. ; 499:2-3, s. 469-479
-
Journal article (peer-reviewed)abstract
- The PHENIX detector is designed to perform a broad study of A-A, p-A, and p-p collisions to investigate nuclear matter under extreme conditions. A wide variety of probes, sensitive to all timescales, are used to study systematic variations with species and energy as well as to measure the spin structure of the nucleon. Designing for the needs of the heavy-ion and polarized-proton programs has produced a detector with unparalleled capabilities. PHENIX measures electron and muon pairs, photons, and hadrons with excellent energy and momentum resolution. The detector consists of a large number of subsystems that are discussed in other papers in this volume. The overall design parameters of the detector are presented. (C) 2002 Elsevier Science B.V. All rights reserved.
|
|
| 2. |
- Wang, Xiangjun, et al.
(author)
-
Growth and characterization of Na0.5K0.5NbO3 thin films on polycrystalline Pt80Ir20 substrates
- 2002
-
In: Journal of Materials Research. - 0884-2914 .- 2044-5326. ; 17:5, s. 1183-1191
-
Journal article (peer-reviewed)abstract
- Na0.5K0.5NbO3 thin films have been deposited onto textured polycrystalline Pt80Ir20 substrates using radio frequency magnetron sputtering. Films were grown in off- and on-axis positions relative to the target at growth temperatures of 500-700 degreesC and sputtering pressures of 1-7 Pa. The deposited films were found to be textured, displaying a mixture of two orientations (001) and (101). Films grown on-axis showed a prefered (001) orientation, while the off-axis films had a (101) orientation. Scanning electron microscopy showed that the morphology of the films was dependent on the substrate position and sputtering pressure. The low-frequency (10 kHz) dielectric constants of the films were found to be in the range of approximately 490-590. Hydrostatic piezoelectric measurements showed that the films were piezoelectric in the as-deposited form with a constant up to 14.5 pC/N.
|
|
| 3. |
- Adcox, K, et al.
(author)
-
PHENIX central arm tracking detectors
- 2003
-
In: Nuclear Instruments & Methods in Physics Research. Section A: Accelerators, Spectrometers, Detectors, and Associated Equipment. - 0167-5087. ; 499:2-3, s. 489-507
-
Journal article (peer-reviewed)abstract
- The PHENIX tracking system consists of Drift Chambers (DC), Pad Chambers (PC) and the Time Expansion Chamber (TEC). PC1/DC and PC2/TEC/PC3 form the inner and outer tracking units, respectively. These units link the track segments that transverse the RICH and extend to the EMCal. The DC measures charged particle trajectories in the r-phi direction to determine P-T of the particles and the invariant mass of particle pairs. The PCs perform 3D spatial point measurements for pattern recognition and longitudinal momentum reconstruction and provide spatial resolution of a few mm in both r-phi and z. The TEC tracks particles passing through the region between the RICH and the EMCal. The design and operational parameters of the detectors are presented and running experience during the first year of data taking with PHENIX is discussed. The observed spatial and momentum resolution is given which imposes a limitation on the identification and characterization of charged particles in various momentum ranges. (C) 2002 Published by Elsevier Science B.V.
|
|
