1. |
- Adare, A., et al.
(author)
-
Direct photon production in d+Au collisions at root s(NN)=200 GeV
- 2013
-
In: Physical Review C (Nuclear Physics). - 0556-2813. ; 87:5
-
Journal article (peer-reviewed)abstract
- Direct photons have been measured in root s(NN) = 200 GeV d + Au collisions at midrapidity. A wide p(T) range is covered by measurements of nearly real virtual photons (1 < p(T) < 6 GeV/c) and real photons (5 < p(T) < 16 GeV/c). The invariant yield of the direct photons in d + Au collisions over the scaled p + p cross section is consistent with unity. Theoretical calculations assuming standard cold-nuclear-matter effects describe the data well for the entire p(T) range. This indicates that the large enhancement of direct photons observed in Au + Au collisions for 1.0 < p(T) < 2.5 GeV/c is attributable to a source other than the initial-state nuclear effects.
|
|
2. |
- Adler, S. S., et al.
(author)
-
Transverse-energy distributions at midrapidity in p plus p, d plus Au, and Au plus Au collisions at root s(NN)=62.4-200 GeV and implications for particle-production models
- 2014
-
In: Physical Review C (Nuclear Physics). - 0556-2813. ; 89:4
-
Journal article (peer-reviewed)abstract
- Measurements of the midrapidity transverse-energy distribution, dE(T)/d eta, are presented for p + p, d+Au, and Au+Au collisions atv root s(NN) = 200 GeV and additionally for Au+Au collisions atv root s(NN) = 62.4 and 130 GeV. The dE(T)/d eta distributions are first compared with the number of nucleon participants N-part, number of binary collisions N-coll, and number of constituent-quark participants N-qp calculated from a Glauber model based on the nuclear geometry. For Au+Au, < dE(T)/d eta >/N-part increases with N-part, while < dE(T)/d eta >/N-qp is approximately constant for all three energies. This indicates that the two-component ansatz, dE(T)/d eta alpha (1 - x)N-part/2 + xN(coll), which was used to represent E-T distributions, is simply a proxy for N-qp, and that the N-coll term does not represent a hard-scattering component in E-T distributions. The dE(T)/d eta distributions of Au+Au and d+Au are then calculated from the measured p + p E-T distribution using two models that both reproduce the Au+Au data. However, while the number-of-constituent-quark-participant model agrees well with the d+Au data, the additive-quark model does not.
|
|
3. |
|
|
4. |
|
|
5. |
|
|