1. |
- Keller, Martin, 1985, et al.
(author)
-
Interaction of mineral matter of coal with oxygen carriers in chemical-looping combustion (CLC)
- 2014
-
In: Chemical Engineering Research and Design. - : Elsevier BV. - 0263-8762 .- 1744-3563. ; 92:9, s. 1753-1770
-
Journal article (peer-reviewed)abstract
- The chemical-looping combustion (CLC) and chemical-looping with oxygen uncoupling (CLOU) processes are novel solutions for efficient combustion with direct separation of carbon dioxide. These processes use a metal oxide as an oxygen carrier to transfer oxygen from an air to a fuel reactor, where the fuel reacts with the solid oxygen carrier. When utilizing coal in CLC, the oxygen carrier particles could be affected through interaction with the ash-forming mineral matter found in coal, causing deactivation and/or agglomeration. In this work, possible interactions between minerals commonly encountered in coal and several promising oxygen carriers that are currently under investigation for their use in CLC are studied by both experiment and thermodynamic equilibrium calculations. Possible interaction was studied for both highly reducing and oxidizing conditions at 900 °C. Under highly reducing conditions pyrite was found to have by far the most deteriorating effect on the oxygen carrier particles, as the sulfur in the pyrite reacted with the oxygen carrier to form sulfides. Quartz and clay minerals were found to have a rather low influence on the oxygen carriers. Out of the oxygen carriers investigated, CuO/MgAl2O4 and the Mn3O4/ZrO2 oxygen carriers tended to be quite reactive towards mineral matter whereas ilmenite has been shown to be the most robust oxygen carrier. Although sulfur can clearly deactivate Ni, Cu and Mn based oxygen carriers under sub-stoichiometric conditions, when the fuel is converted fully to CO2 and H2O, sulfides are only expected for Ni-based oxygen carriers.
|
|
2. |
- Keller, Martin, 1985, et al.
(author)
-
Investigation of Natural and Synthetic Bed Materials for Their Utilization in Chemical Looping Reforming for Tar Elimination in Biomass-Derived Gasification Gas
- 2014
-
In: Energy & Fuels. - : American Chemical Society (ACS). - 1520-5029 .- 0887-0624. ; 28:6, s. 3833-3840
-
Journal article (peer-reviewed)abstract
- The removal of condensable hydrocarbons or tars from raw gas derived from biomass gasification presents an obstacle in the widespread application of biomass gasification. Hot catalytic tar cleaning as a secondary tar removal strategy is discussed as a tar cleaning technology. This can be realized in a dual-fluidized-bed reactor system, in which a catalytically active bed material is continuously regenerated. Such a process is termed chemical looping reforming (CLR). In such a process, it has been suggested that oxygen carrier particles employed for chemical looping combustion may be used, with the oxygen transfer from the particles to the gas promoting tar decomposition. Experiments were conducted in a small-scale, batch-wise fluidized-bed reactor with the aim of investigating a variety of bed materials for this process. The purpose of the present work is thus to conduct a screening study of a variety of bed materials based on the transition metals Fe, Mn, Ni, and Cu. The experiments were conducted in a batch fluidized bed, where the particles are exposed to reformer and regenerator conditions alternatingly. The conversion of ethylene from a synthetic gasification gas mixture was used as an indicator for the suitability of the materials for tar conversion. It was found that the natural material bauxite and the synthetic bed materials NiO/alpha-Al2O3, CuO/MgAl2O4, and La0.8Sr0.2FeO3/gamma-Al2O3 exhibit high ethylene conversion rates and, thus, possess promising properties for their application in CLR
|
|