1. |
- Adcox, K, et al.
(author)
-
PHENIX detector overview
- 2003
-
In: Nuclear Instruments & Methods in Physics Research. Section A: Accelerators, Spectrometers, Detectors, and Associated Equipment. - 0167-5087. ; 499:2-3, s. 469-479
-
Journal article (peer-reviewed)abstract
- The PHENIX detector is designed to perform a broad study of A-A, p-A, and p-p collisions to investigate nuclear matter under extreme conditions. A wide variety of probes, sensitive to all timescales, are used to study systematic variations with species and energy as well as to measure the spin structure of the nucleon. Designing for the needs of the heavy-ion and polarized-proton programs has produced a detector with unparalleled capabilities. PHENIX measures electron and muon pairs, photons, and hadrons with excellent energy and momentum resolution. The detector consists of a large number of subsystems that are discussed in other papers in this volume. The overall design parameters of the detector are presented. (C) 2002 Elsevier Science B.V. All rights reserved.
|
|
2. |
|
|
3. |
- Adler, SS, et al.
(author)
-
PHENIX on-line systems
- 2003
-
In: Nuclear Instruments & Methods in Physics Research. Section A: Accelerators, Spectrometers, Detectors, and Associated Equipment. - 0167-5087. ; 499:2-3, s. 560-592
-
Journal article (peer-reviewed)abstract
- The PHENIX On-Line system takes signals from the Front End Modules (FEM) on each detector subsystem for the purpose of generating events for physics analysis. Processing of event data begins when the Data Collection Modules (DCM) receive data via fiber-optic links from the FEMs. The DCMs format and zero suppress the data and generate data packets. These packets go to the Event Builders (EvB) that assemble the events in final form. The Level-1 trigger (LVL1) generates a decision for each beam crossing and eliminates uninteresting events. The FEMs carry out all detector processing of the data so that it is delivered to the DCMs using a standard format. The FEMs also provide buffering for LVL1 trigger processing and DCM data collection. This is carried out using an architecture that is pipelined and deadtimeless. All of this is controlled by the Master Timing System (MTS) that distributes the RHIC clocks. A Level-2 trigger (LVL2) gives additional discrimination. A description of the components and operation of the PHENIX On-Line system is given and the solution to a number of electronic infrastructure problems are discussed. (C) 2002 Elsevier Science B.V. All rights reserved.
|
|
4. |
|
|
5. |
|
|
6. |
- Bower, K. N., et al.
(author)
-
ACE-2 HILLCLOUD. An overview of the ACE-2 ground-based cloud experiment
- 2000
-
In: Tellus. Series B: Chemical and Physical Meteorology. - : Stockholm University Press. - 0280-6509. ; 52:2, s. 750-778
-
Journal article (peer-reviewed)abstract
- The ACE-2 HILLCLOUD experiment was carried out on the island of Tenerife in June-July 1997 to investigate the interaction of the boundary layer aerosol with a hill cap cloud forming over a ridge to the north-east of the island. The cloud was used as a natural flow through reactor to investigate the dependence of the cloud microphysics and chemistry on the characteristics of the aerosols and trace gases entering cloud, and to simultaneously study the influence of the physical and chemical processes occurring within the cloud on the size distribution, chemical and hygroscopic properties of the aerosol exiting cloud. 5 major ground base sites were used, measuring trace gases and aerosols upwind and downwind of the cloud, and cloud microphysics and chemistry and interstitial aerosol and gases within the cloud on the hill. 8 intensive measurement periods or runs were undertaken during cloud events, (nocturnally for seven of the eight runs) and were carried out in a wide range of airmass conditions from clean maritime to polluted continental. Polluted air was characterised by higher than average concentrations of ozone (> 50 ppbv), fine and accumulation mode aerosols (> 3000 and > 1500 cm -3 , respectively) and higher aerosol mass loadings. Cloud droplet number concentrations N, increased from 50 cm -3 in background maritime air to > 2500 cm -3 in aged polluted continental air, a concentration much higher than had previously been detected. Surprisingly, N was seen to vary almost linearly with aerosol number across this range. The droplet aerosol analyser (DAA) measured higher droplet numbers than the corrected forward scattering spectrometer probe (FSSP) in the most polluted air, but at other times there was good agreement (FSSP = 0.95 DAA with an r 2 = 0.89 for N < 1200 cm -3 ). Background ammonia gas concentrations were around 0.3 ppbv even in air originating over the ocean, another unexpected but important result for the region. NO 2 was present in background concentrations of typically 15 pptv to 100 pptv and NO 3 . (the nitrate radical) was observed at night throughout. Calculations suggest NO 3 . losses were mainly by reaction with DMS to produce nitric acid. Low concentrations of SO 2 (~30 pptv), HNO 3 and HCl were always present. HNO 3 concentrations were higher in polluted episodes and calculations implied that these exceeded those which could be accounted for by NO 2 oxidation. It is presumed that nitric and hydrochloric acids were present as a result of outgassing from aerosol, the HNO 3 from nitrate rich aerosol transported into the region from upwind of Tenerife, and HCl from sea salt aerosol newly formed at the sea surface. The oxidants hydrogen peroxide and ozone were abundant (i.e., were well in excess over SO 2 throughout the experiment). Occasions of significant aerosol growth following cloud processing were observed, particularly in cleaner cases. Observations and modelling suggested this was due mainly to the take up of nitric acid, hydrochloric acid and ammonia by the smallest activated aerosol particles. On a few occasions a small contribution was made by the in-cloud oxidation of S(IV). The implications of these results from HILLCLOUD for the climatologically more important stratocumulus Marine Boundary Layer (MBL) clouds are considered.
|
|
7. |
- Isaksson, E, et al.
(author)
-
Ice cores from Svalbard :useful archives of past climate and pollution history.
- 2003
-
In: Physics and chemistry of the earth. Part A. - : Elsevier BV. - 1464-1895 .- 1873-4642 .- 1474-7065. ; 28:28-32, s. 1217-1228
-
Journal article (peer-reviewed)abstract
- Ice cores from the relatively low-lying ice caps in Svalbard have not been widely exploited in climatic and environmental studies due to uncertainties about the effect of melt water percolation. However, results from two recent Svalbard ice cores, at Lomonosovfonna (1250 m asl) and Austfonna (750 m asl), have shown that with careful site selection, high-resolution sampling and multiple chemical analyses, it is possible to recover ice cores with partly preserved annual signals. These cores are estimated to cover at least the past 600 years and have been dated using a combination of known reference horizons and glacial modeling. The δ18O data from both Lomonosovfonna and Austfonna ice cores suggest that the 20th century was the warmest during the past 600 years. A comparison of the ice core and sea ice records from this period suggests that sea ice extent and Austfonna δ18O are linked over the past 400 years. This may reflect the position of the storm tracks and their direct influence on the relatively low altitude Austfonna. Lomonosovfonna may be less sensitive to such changes and primarily record atmospheric changes due to its higher elevation. The anthropogenic influence on Svalbard environment is illustrated by increased levels of non-sea-salt sulphate, nitrate, acidity, fly-ash and organic contaminants particularly during the second half of 1900s. Decreased concentrations of some components in recent decades most likely reflect emission and use restrictions. However, some current-use organic pesticide compounds show growing concentrations in near surface layers.
|
|
8. |
|
|
9. |
- Pohjola, V, et al.
(author)
-
Effect of periodic melting on geochemical and isotopic signals in an ice core from Lomonosovfonna, Svalbard
- 2002
-
In: J.Geophys.Res.. ; 107:D4, s. ACL 1-14
-
Journal article (peer-reviewed)abstract
- In this work we examine the quality of the atmospherically deposited signals in an ice core taken from a periodically melting ice field, Lomonosovfonna on central Spitsbergen, Svalbard. The aim is to investigate how much the atmospheric deposited signals in the stratigraphy of ice pack are changed by periodic melting of the ice. To determine the impact of this melting on the stratigraphy found in the ice core, we use three diagnostics: 1) Association between peak values in the ice chemical and isotopic record and ice facies type; 2) Number of “annual” cycles in these records compared with independently-determined number of years represented in the ice core; 3) Statistical comparison between the isotopic record in the ice core and the isotope records from coastal stations from the same region. We find that during warm summers as much as 50% of the annual accumulation may melt and percolate into the firn, and in a median year this decreases to ca. 25 %. As a consequence of percolation the most mobile acids show upto 50 % higher concentrations in bubble poor ice facies compared with facies that are less affected by melt. Most of the other chemical species are less affected than the strong acids, and the stable water isotopes show little evidence of mobility Annual, or bi-annual cycles are detected in most parameters, and the water isotope record has a comparable statistical distribution to isotopic records from coastal stations. We conclude that ice cores from sites like Lomonosovfonna preserve an useful environmental record despite melt events and percolation, where most parameters displays an annual, or in poor cases a bi-annual atmospheric signal.
|
|
10. |
- Pohjola, V, et al.
(author)
-
Reconstruction of three centuries of annual accumulation rates based on the record of stable isotopes of water from Lomonosovfonna, Svalbard
- 2002
-
In: Annals of glaciology. ; 35, s. 57-62
-
Journal article (peer-reviewed)abstract
- We use the upper 81 m of the record of stable isotopes of water from a 122 m long ice core from Lomonosovfonna, central Spitsbergen, to construct an ice core chronology and the annual accumulation rates over the ice field. The isotope cycles are counted in the ice core record using a model that neglects short wavelength and low amplitude cycles. We find approximately the same number of ä18O cycles as years between known reference horizons, and assume these cycles represent annual cycles. Testing the validity of this assumption using cycles in äD shows that both records give similar numbers of cycles. Using the ä18O chronology, and de-compressing the accumulation records using the Nye flow model, we calculate the annual accumulation for the ice core site back to 1715 AD. We find that the average accumulation rate from 1715 to 1950 o was on average 0.30 m w.e. Accumulation rates increased ca. 25% during the later part of the 20th century to an average of 0.41 m w.e. for the period 1950 – 1997. The accumulation rates show highly significant 2.1 and 21 year periodicities, which gives credibility to our time scale.
|
|