1. |
- Appelgren, Patrik, et al.
(author)
-
Modeling of a small helical magnetic flux compression generator
- 2008
-
In: IEEE Transactions on Plasma Science. - 0093-3813 .- 1939-9375. ; 36:5, s. 2662-2672
-
Journal article (peer-reviewed)abstract
- In order to gain experience in explosive pulsed power and to provide experimental data as the basis for computer modeling, a small high-explosive-driven helical magnetic flux-compression generator (FCG) was designed at the Swedish Defence Research Agency. The generator, of which three have been built, has an overall length of 300 mm and a diameter of 70 mm. It could serve as the energy source in a pulse-forming network to generate high-power pulses for various loads. This paper presents a simulation model of this helical FCG. The model, which was implemented in Matlab-Simulink, uses analytical expressions for the generator inductance. The model of resistive losses takes into account the heating of the conductors and the diffusion of the magnetic field into the conductors. The simulation results are compared with experimental data from two experiments with identical generators but with different seed currents, influencing the resistive losses. The model is used to analyze the performance of the generator.
|
|
2. |
- Appelgren, Patrik, et al.
(author)
-
Small Helical Magnetic Flux-Compression Generators : Experiments and Analysis
- 2008
-
In: IEEE Transactions on Plasma Science. - 0093-3813 .- 1939-9375. ; 36:5, s. 2673-2683
-
Journal article (peer-reviewed)abstract
- In order to gain experience in explosive pulsed power and to provide experimental data for modeling, a small high-explosive-driven helical magnetic flux-compression generator (FCG) was designed at the Swedish Defence Research Agency (FOI). The generator, of which three have been built, has an overall length of 300 mm and a diameter of 70 mm. It could serve as the energy source in a pulse-forming network to generate high power pulses for various loads. This paper presents the design of, and tests with, this helical FCG. The generator had an initial inductance of 23 mu H and was operated into a load of 0.2 mu H. The generator is charged with 0.27 kg of high explosives (PBXN-5). Various types of diagnostics were used to monitor the operation of the generator, including current probes, optical fibers, and piezo gauges. With seed currents of 5.7 and 11.2 kA, final currents of 269 and 436 kA were obtained, corresponding to current amplification factors of 47 and 39. The peak of the current was reached about 30 mu s after the time of crowbar. The two generators showed only small losses in terms of 2 pi-clocking. Using signals from optical fibers, the deflection angle of the armature could be determined to be 10 degrees in good agreement with hydrodynamic simulations of the detonation process and the detonation velocity to be 8.7 km/s in agreement with tabulated value.
|
|
3. |
- Larsson, Anders, et al.
(author)
-
Radiated electric field strength from high-power microwave systems
- 2008
-
In: IEEE transactions on electromagnetic compatibility (Print). - 0018-9375 .- 1558-187X. ; 50:3, s. 758-761
-
Journal article (peer-reviewed)abstract
- Intentional electromagnetic interference (IEMI) is an emerging threat and a new electromagnetic environment that has to be considered in the mitigation of electromagnetic compatibility problems. This paper presents an attempt to estimate the upper limitations of IEMI systems based on high-power microwave devices. The upper limit of transmitted electromagnetic wave power is basically set by the microwave breakdown event. The estimate includes the properties of the electromagnetic wave propagation from the generation of the wave to the possible target.
|
|
4. |
|
|