1. |
- Acharya, B. S., et al.
(author)
-
Introducing the CTA concept
- 2013
-
In: Astroparticle physics. - : Elsevier BV. - 0927-6505 .- 1873-2852. ; 43, s. 3-18
-
Journal article (other academic/artistic)abstract
- The Cherenkov Telescope Array (CTA) is a new observatory for very high-energy (VHE) gamma rays. CTA has ambitions science goals, for which it is necessary to achieve full-sky coverage, to improve the sensitivity by about an order of magnitude, to span about four decades of energy, from a few tens of GeV to above 100 TeV with enhanced angular and energy resolutions over existing VHE gamma-ray observatories. An international collaboration has formed with more than 1000 members from 27 countries in Europe, Asia, Africa and North and South America. In 2010 the CTA Consortium completed a Design Study and started a three-year Preparatory Phase which leads to production readiness of CTA in 2014. In this paper we introduce the science goals and the concept of CTA, and provide an overview of the project. (C) 2013 Elsevier B.V. All rights reserved.
|
|
2. |
- Rauer, H., et al.
(author)
-
The PLATO 2.0 mission
- 2014
-
In: Experimental astronomy. - : Springer Science and Business Media LLC. - 0922-6435 .- 1572-9508. ; 38:1-2, s. 249-330
-
Journal article (peer-reviewed)abstract
- PLATO 2.0 has recently been selected for ESA's M3 launch opportunity (2022/24). Providing accurate key planet parameters (radius, mass, density and age) in statistical numbers, it addresses fundamental questions such as: How do planetary systems form and evolve? Are there other systems with planets like ours, including potentially habitable planets? The PLATO 2.0 instrument consists of 34 small aperture telescopes (32 with 25 s readout cadence and 2 with 2.5 s cadence) providing a wide field-of-view (2232 deg(2)) and a large photometric magnitude range (4-16 mag). It focuses on bright (4-11 mag) stars in wide fields to detect and characterize planets down to Earth-size by photometric transits, whose masses can then be determined by ground-based radial-velocity follow-up measurements. Asteroseismology will be performed for these bright stars to obtain highly accurate stellar parameters, including masses and ages. The combination of bright targets and asteroseismology results in high accuracy for the bulk planet parameters: 2 %, 4-10 % and 10 % for planet radii, masses and ages, respectively. The planned baseline observing strategy includes two long pointings (2-3 years) to detect and bulk characterize planets reaching into the habitable zone (HZ) of solar-like stars and an additional step-and-stare phase to cover in total about 50 % of the sky. PLATO 2.0 will observe up to 1,000,000 stars and detect and characterize hundreds of small planets, and thousands of planets in the Neptune to gas giant regime out to the HZ. It will therefore provide the first large-scale catalogue of bulk characterized planets with accurate radii, masses, mean densities and ages. This catalogue will include terrestrial planets at intermediate orbital distances, where surface temperatures are moderate. Coverage of this parameter range with statistical numbers of bulk characterized planets is unique to PLATO 2.0. The PLATO 2.0 catalogue allows us to e. g.: - complete our knowledge of planet diversity for low-mass objects, - correlate the planet mean density-orbital distance distribution with predictions from planet formation theories,- constrain the influence of planet migration and scattering on the architecture of multiple systems, and - specify how planet and system parameters change with host star characteristics, such as type, metallicity and age. The catalogue will allow us to study planets and planetary systems at different evolutionary phases. It will further provide a census for small, low-mass planets. This will serve to identify objects which retained their primordial hydrogen atmosphere and in general the typical characteristics of planets in such a low-mass, low-density range. Planets detected by PLATO 2.0 will orbit bright stars and many of them will be targets for future atmosphere spectroscopy exploring their atmospheres. Furthermore, the mission has the potential to detect exomoons, planetary rings, binary and Trojan planets. The planetary science possible with PLATO 2.0 is complemented by its impact on stellar and galactic science via asteroseismology as well as light curves of all kinds of variable stars, together with observations of stellar clusters of different ages. This will allow us to improve stellar models and study stellar activity. A large number of well-known ages from red giant stars will probe the structure and evolution of our Galaxy. Asteroseismic ages of bright stars for different phases of stellar evolution allow calibrating stellar age-rotation relationships. Together with the results of ESA's Gaia mission, the results of PLATO 2.0 will provide a huge legacy to planetary, stellar and galactic science.
|
|
3. |
|
|
4. |
|
|
5. |
- Rojas-Arriagada, A., et al.
(author)
-
The Gaia-ESO Survey: metallicity and kinematic trends in the Milky Way bulge
- 2014
-
In: Astronomy & Astrophysics. - : EDP Sciences. - 0004-6361 .- 1432-0746. ; 569
-
Journal article (peer-reviewed)abstract
- Aims. Observational studies of the Milky Way bulge are providing increasing evidence of its complex chemo-dynamical patterns and morphology. Our intent is to use the iDR1 Gaia-ESO Survey (GES) data set to provide new constraints on the metallicity and kinematic trends of the Galactic bulge, exploring the viability of the currently proposed formation scenarios. Methods. We analyzed the stellar parameters and radial velocities of similar to 1200 stars in five bulge fields wich are located in the region -10 degrees < / < 7 degrees and -10 degrees < b < -4 degrees. We use VISTA Variables in the Via Lactea (VVV) photometry to verify the internal consistency of the atmospheric parameters recommended by the consortium. As a by-product, we obtained reddening values using a semi-empirical Tdf -color calibration. We constructed the metallicity distribution functions and combined them with photometric and radial velocity data to analyze the properties of the stellar populations in the observed fields. Results. From a Gaussian decomposition of the metallicity distribution functions, we unveil a clear bimodality in all fields, with the relative size of components depending of the specific position on the sky. In agreement with some previous studies, we find a mild gradient along the minor axis (-0.05 dex/deg between b = -6 degrees and b = -10 degrees) that arises from the varying proportion of metal-rich and metal-poor components. The number of metal-rich stars fades in favor of the metal-poor stars with increasing b. The K-magnitude distribution of the metal-rich population splits into two peaks for two of the analyzed fields that intersects the near and far branches of the X-shaped bulge structure. In addition, two lateral fields at (l,b) = (7, -9) and (l, b) = (-10, 8) present contrasting characteristics. In the former, the metallicity distribution is dominated by metal-rich stars, while in the latter it presents a mix of a metal-poor population and and a metal-intermediate one, of nearly equal sizes. Finally, we find systematic differences in the velocity dispersion between the metal-rich and the metal-poor components of each field. Conclusions. The iDR I bulge data show chemo-dynamical distributions that are consistent with varying proportions of stars belonging to (i) a metal-rich boxy/peanut X-shaped component, with bar-like kinematics; and (ii) a metal-poor more extended rotating structure with a higher velocity dispersion that dominates far from the Galactic plane. These first GES data already allow studying the detailed spatial dependence of the Galactic bulge populations, thanks to the analysis of individual fields with relatively high statistics.
|
|
6. |
- Wang, C. H., et al.
(author)
-
InAs hole inversion and bandgap interface state density of 2 x 10(11) cm(-2) eV(-1) at HfO2/InAs interfaces
- 2013
-
In: Applied Physics Letters. - : AIP Publishing. - 0003-6951 .- 1077-3118. ; 103:14
-
Journal article (peer-reviewed)abstract
- High-k/InAs interfaces have been manufactured using InAs surface oxygen termination and low temperature atomic layer deposition of HfO2. Capacitance-voltage (C-V) curves revert to essentially classical shape revealing mobile carrier response in accumulation and depletion, hole inversion is observed, and predicted minority carrier response frequency in the hundred kHz range is experimentally confirmed; reference samples using conventional techniques show a trap dominated capacitance response. C-V curves have been fitted using advanced models including nonparabolicity and Fermi-Dirac distribution. For an equivalent oxide thickness of 1.3 nm, an interface state density D-it = 2.2 x 10(11) cm(-2) eV(-1) has been obtained throughout the InAs bandgap. (C) 2013 AIP Publishing LLC.
|
|
7. |
- Wang, Haidong, et al.
(author)
-
Global, regional, and national levels of neonatal, infant, and under-5 mortality during 1990-2013 : a systematic analysis for the Global Burden of Disease Study 2013
- 2014
-
In: The Lancet. - 0140-6736 .- 1474-547X. ; 384:9947, s. 957-979
-
Journal article (peer-reviewed)abstract
- BACKGROUND: Remarkable financial and political efforts have been focused on the reduction of child mortality during the past few decades. Timely measurements of levels and trends in under-5 mortality are important to assess progress towards the Millennium Development Goal 4 (MDG 4) target of reduction of child mortality by two thirds from 1990 to 2015, and to identify models of success.METHODS: We generated updated estimates of child mortality in early neonatal (age 0-6 days), late neonatal (7-28 days), postneonatal (29-364 days), childhood (1-4 years), and under-5 (0-4 years) age groups for 188 countries from 1970 to 2013, with more than 29 000 survey, census, vital registration, and sample registration datapoints. We used Gaussian process regression with adjustments for bias and non-sampling error to synthesise the data for under-5 mortality for each country, and a separate model to estimate mortality for more detailed age groups. We used explanatory mixed effects regression models to assess the association between under-5 mortality and income per person, maternal education, HIV child death rates, secular shifts, and other factors. To quantify the contribution of these different factors and birth numbers to the change in numbers of deaths in under-5 age groups from 1990 to 2013, we used Shapley decomposition. We used estimated rates of change between 2000 and 2013 to construct under-5 mortality rate scenarios out to 2030.FINDINGS: We estimated that 6·3 million (95% UI 6·0-6·6) children under-5 died in 2013, a 64% reduction from 17·6 million (17·1-18·1) in 1970. In 2013, child mortality rates ranged from 152·5 per 1000 livebirths (130·6-177·4) in Guinea-Bissau to 2·3 (1·8-2·9) per 1000 in Singapore. The annualised rates of change from 1990 to 2013 ranged from -6·8% to 0·1%. 99 of 188 countries, including 43 of 48 countries in sub-Saharan Africa, had faster decreases in child mortality during 2000-13 than during 1990-2000. In 2013, neonatal deaths accounted for 41·6% of under-5 deaths compared with 37·4% in 1990. Compared with 1990, in 2013, rising numbers of births, especially in sub-Saharan Africa, led to 1·4 million more child deaths, and rising income per person and maternal education led to 0·9 million and 2·2 million fewer deaths, respectively. Changes in secular trends led to 4·2 million fewer deaths. Unexplained factors accounted for only -1% of the change in child deaths. In 30 developing countries, decreases since 2000 have been faster than predicted attributable to income, education, and secular shift alone.INTERPRETATION: Only 27 developing countries are expected to achieve MDG 4. Decreases since 2000 in under-5 mortality rates are accelerating in many developing countries, especially in sub-Saharan Africa. The Millennium Declaration and increased development assistance for health might have been a factor in faster decreases in some developing countries. Without further accelerated progress, many countries in west and central Africa will still have high levels of under-5 mortality in 2030.
|
|
8. |
- Agüero, Juan C., et al.
(author)
-
Accuracy of linear multiple-input multiple-output (MIMO) models obtained by maximum likelihood estimation
- 2012
-
In: Automatica. - : Elsevier BV. - 0005-1098 .- 1873-2836. ; 48:4, s. 632-637
-
Journal article (peer-reviewed)abstract
- In this paper, we study the accuracy of linear multiple-input multiple-output (MIMO) models obtained by maximum likelihood estimation. We present a frequency-domain representation for the information matrix for general linear MIMO models. We show that the variance of estimated parametric models for linear MIMO systems satisfies a fundamental integral trade-off. This trade-off is expressed as a multivariable 'water-bed' effect. An extension to spectral estimation is also discussed.
|
|
9. |
- Proletov, Ian, et al.
(author)
-
Primary and secondary glomerulonephritides 1.
- 2014
-
In: Nephrology, dialysis, transplantation : official publication of the European Dialysis and Transplant Association - European Renal Association. - : Oxford University Press (OUP). - 1460-2385. ; 29 Suppl 3:May, s. 186-200
-
Journal article (peer-reviewed)
|
|
10. |
- Ramírez, Jaime A., et al.
(author)
-
Aportes a la Teoría y la Implementación del Método LSCR
- 2010
-
In: RIAI - Revista Iberoamericana de Automatica e Informatica Industrial. - 1697-7912. ; 7:3, s. 83-94
-
Journal article (peer-reviewed)abstract
- The LSCR method (Leave-out-Sign-dominant-Correlation-Regions) provides confidence regions for the parameters of a system by evaluating a set of correlation functions calculated for the available data. To do the approximation for the whole region, the procedure must be repeated for each value of the parameter vector. The main attributes of LSCR are its validity for a finite set of data and the scarce assumptions on the noise. However, the procedure needs much computational effort, which limits its application to very simple cases. In this work some theoretical aspects of the LSCR method are improved and some implementation alternatives are suggested. It is also compared, in terms of computational effort, with Bootstrap, another way to obtain confidence regions.
|
|