SwePub
Sök i SwePub databas

  Extended search

Träfflista för sökning "WFRF:(Salman Hassan) srt2:(1998-1999)"

Search: WFRF:(Salman Hassan) > (1998-1999)

  • Result 1-3 of 3
Sort/group result
   
EnumerationReferenceCoverFind
1.
  • Degerman, Bengt, et al. (author)
  • Studies of two stage gas turbine combustor for biomass powder : Part 1 : atmospheric cyclone gasification experiments with wood powder
  • 1998
  • Reports (other academic/artistic)abstract
    • This report summarises the research and development work regarding development of a two stage gas turbine combustor for wood powder carried out at the Luleå University of Technology from July 1993 to December 1996. The process being studied is based on cyclone gasification of the wood powder and combustion of the product gas in a suitably adapted gas turbine combustion chamber, without other gas cleaning than that obtained by the cyclone. A critical issue to be studied in the project is if the burned gases from such a cyclone gasifier lead to acceptably low deposition rates for K- and Na-compounds in a gas turbine with 850°C inlet temperature. The project strategy has been to study wood powder feeding and cyclone gasification first at atmospheric pressure, then run separate pressurised cyclone gasification tests for studies of the possibilities to achieve stable operation when the air flow is supplied by a separate compressor and finally to run integrated gasifier/gas turbine tests for studies of the deposition problem in practical operation.
  •  
2.
  • Joppich, A., et al. (author)
  • Wood powder feeding, difficulties and solutions
  • 1999
  • In: Biomass and Bioenergy. - 0961-9534 .- 1873-2909. ; 16:3, s. 191-198
  • Journal article (peer-reviewed)abstract
    • A pneumatic fuel feeding system for wood powder fired gas turbines was incorporated at the Vienna University of Technology. One of the most important requirements of fuel feeding is a very homogeneous mass flow of wood powder. Therefore, the performance of the mechanical conveying part of the feeding system has been studied experimentally at flow rates corresponding to the operation range. Beside screw feeding, a vibrator is used to homogenize the flow rate. While the screw feeder shows large fluctuations, the vibrator conveyer reduces them considerably. The tests also show that for each flow rate a certain optimum amplitude of the vibrator exists at which the fluctuations reach a minimum. Furthermore, a linear function is observed between optimum oscillation amplitude and feeding rate.
  •  
3.
  •  
Skapa referenser, mejla, bekava och länka
  • Result 1-3 of 3
Type of publication
reports (1)
journal article (1)
licentiate thesis (1)
Type of content
other academic/artistic (2)
peer-reviewed (1)
Author/Editor
Salman, Hassan (3)
Hedin, Johan (1)
Fredriksson, Christi ... (1)
Degerman, Bengt (1)
Kjellström, Björn (1)
Joppich, A. (1)
University
Luleå University of Technology (3)
Language
English (3)
Research subject (UKÄ/SCB)
Engineering and Technology (3)

Year

Kungliga biblioteket hanterar dina personuppgifter i enlighet med EU:s dataskyddsförordning (2018), GDPR. Läs mer om hur det funkar här.
Så här hanterar KB dina uppgifter vid användning av denna tjänst.

 
pil uppåt Close

Copy and save the link in order to return to this view