1. |
- Benard, N., et al.
(author)
-
Shear Layer and Shedding Modes Excitations of a Backward-Facing Step Flow by Surface Plasma Discharge
- 2020
-
In: Advances in Effective Flow Separation Control for Aircraft Drag Reduction. - Cham : Springer. ; , s. 55-74
-
Book chapter (peer-reviewed)abstract
- The present experimental study interests in determining the influence of a linear plasma actuator (dielectric barrier discharge) on the development of a separated turbulent shear layer. More specifically, the plasma actuator is used to impose periodic perturbations at the step corner of a backward-facing step. Two different modes of excitation are explored. One concerns the shear layer mode of instability, a mode whose amplification leads to a minimization of the recirculation bubble. The present investigation shows how a dielectric barrier discharge plasma actuator can impose periodic perturbations that excite the shear layer mode and result in a strong regularization of the vortex street. The case of excitation at the shedding mode is also experimentally investigated using a DBD actuator. The measurements show the increase in Reynolds stress caused by this excitation as well as the specific growing mechanism of the shear layer. Indeed, phase-averaged flow measurements highlights the difference in the mechanism of development of the shear layer regarding the type of excitation used, the shear layer mode promoting a growing mechanism by fluid entrainment while the shedding mode enhancing the pairing of successive vortical flow structures.
|
|
2. |
- Sujar Garrido, Patricia, et al.
(author)
-
Efficiency assessment of a single surface dielectric barrier discharge plasma actuator with an optimized Suzen–Huang model
- 2022
-
In: Physics of fluids. - : AIP Publishing. - 1070-6631 .- 1089-7666. ; 34:4, s. 047110-047110
-
Journal article (peer-reviewed)abstract
- Spatial and time-resolved characteristics of a single surface dielectric barrier discharge (sDBD) actuator are experimentally and numerically investigated. The paper also focuses on the efficiency of sDBD actuators used as flow-control devices. The motivation is the need for developing a cost-effective way to optimize the balance between control performance and actuator power consumption. The study considers the steady state as often employed in experiments as well as the transient regime. Experimental methods to obtain the active power are revisited, and for the first time, the commonly used simplified phenomenological Suzen–Huang model (SHM) is used for the computation of electrical characteristics. The SHM represents fair qualitative features of the starting vortex. However, it fails when time-resolved velocity profiles are compared. Results show that even with an optimized parametrical analysis of the “tuned” plasma variables, the model is not able to fully reproduce the induced wall-jet neither spatially nor temporally. Furthermore, it underestimates the power consumption by more than 80%. The intrinsic challenge of accurately measuring the alternating current of the DBD and the instantaneous mechanical power, together with the failure of representing time-resolved velocity profiles and the underestimated electric power by the model, highlights that a better phenomenological model including gas dynamics and electric characteristics or using a fully coupled physical plasma model is required.
|
|