1. |
- Wang, Fang, et al.
(författare)
-
Emerging contaminants: A One Health perspective
- 2024
-
Ingår i: Innovation. - 2666-6758. ; 5
-
Forskningsöversikt (refereegranskat)abstract
- Environmental pollution is escalating due to rapid global development that often prioritizes human needs over planetary health. Despite global efforts to mitigate legacy pollutants, the continuous introduction of new substances remains a major threat to both people and the planet. In response, global initiatives are focusing on risk assessment and regulation of emerging contaminants, as demonstrated by the ongoing efforts to establish the UN's Intergovernmental Science-Policy Panel on Chemicals, Waste, and Pollution Prevention. This review identifies the sources and impacts of emerging contaminants on planetary health, emphasizing the importance of adopting a One Health approach. Strategies for monitoring and addressing these pollutants are discussed, underscoring the need for robust and socially equitable environmental policies at both regional and international levels. Urgent actions are needed to transition toward sustainable pollution management practices to safeguard our planet for future generations.
|
|
2. |
- Ke, You, et al.
(författare)
-
Defect Passivation for Red Perovskite Light-Emitting Diodes with Improved Brightness and Stability
- 2019
-
Ingår i: The Journal of Physical Chemistry Letters. - : AMER CHEMICAL SOC. - 1948-7185. ; 10:3, s. 380-385
-
Tidskriftsartikel (refereegranskat)abstract
- Efficient and stable red perovskite light-emitting diodes (PeLEDs) are important for realizing full-color display and lighting. Red PeLEDs can be achieved either by mixed-halide or low-dimensional perovskites. However, the device performance, especially the brightness, is still low owing to phase separation or poor charge transport issues. Here, we demonstrate red PeLEDs based on three-dimensional (3D) mixed-halide perovskites where the defects are passivated by using 5-aminovaleric acid. The red PeLEDs with an emission peak at 690 nm exhibit an external quantum efficiency of 8.7% and a luminance of 1408 cd m(-2). A maximum luminance of 8547 cd m(-2) can be further achieved as tuning the emission peak to 662 nm, representing the highest brightness of red PeLEDs. Moreover, those LEDs exhibit a half-life of up to 8 h under a high constant current density of 100 mA cm(-2), which is over 10 times improvement compared to literature results.
|
|
3. |
- Stanaway, Jeffrey D., et al.
(författare)
-
Global, regional, and national comparative risk assessment of 84 behavioural, environmental and occupational, and metabolic risks or clusters of risks for 195 countries and territories, 1990-2017: A systematic analysis for the Global Burden of Disease Study 2017
- 2018
-
Ingår i: The Lancet. - 1474-547X .- 0140-6736. ; 392:10159, s. 1923-1994
-
Tidskriftsartikel (refereegranskat)abstract
- Background The Global Burden of Diseases, Injuries, and Risk Factors Study (GBD) 2017 comparative risk assessment (CRA) is a comprehensive approach to risk factor quantification that offers a useful tool for synthesising evidence on risks and risk-outcome associations. With each annual GBD study, we update the GBD CRA to incorporate improved methods, new risks and risk-outcome pairs, and new data on risk exposure levels and risk- outcome associations. Methods We used the CRA framework developed for previous iterations of GBD to estimate levels and trends in exposure, attributable deaths, and attributable disability-adjusted life-years (DALYs), by age group, sex, year, and location for 84 behavioural, environmental and occupational, and metabolic risks or groups of risks from 1990 to 2017. This study included 476 risk-outcome pairs that met the GBD study criteria for convincing or probable evidence of causation. We extracted relative risk and exposure estimates from 46 749 randomised controlled trials, cohort studies, household surveys, census data, satellite data, and other sources. We used statistical models to pool data, adjust for bias, and incorporate covariates. Using the counterfactual scenario of theoretical minimum risk exposure level (TMREL), we estimated the portion of deaths and DALYs that could be attributed to a given risk. We explored the relationship between development and risk exposure by modelling the relationship between the Socio-demographic Index (SDI) and risk-weighted exposure prevalence and estimated expected levels of exposure and risk-attributable burden by SDI. Finally, we explored temporal changes in risk-attributable DALYs by decomposing those changes into six main component drivers of change as follows: (1) population growth; (2) changes in population age structures; (3) changes in exposure to environmental and occupational risks; (4) changes in exposure to behavioural risks; (5) changes in exposure to metabolic risks; and (6) changes due to all other factors, approximated as the risk-deleted death and DALY rates, where the risk-deleted rate is the rate that would be observed had we reduced the exposure levels to the TMREL for all risk factors included in GBD 2017.
|
|
4. |
- Wang, Shule, et al.
(författare)
-
Van Krevelen diagrams based on machine learning visualize feedstock-product relationships in thermal conversion processes
- 2023
-
Ingår i: Communications Chemistry. - : Springer Nature. - 2399-3669. ; 6:1
-
Tidskriftsartikel (refereegranskat)abstract
- Feedstock properties play a crucial role in thermal conversion processes, where understanding the influence of these properties on treatment performance is essential for optimizing both feedstock selection and the overall process. In this study, a series of van Krevelen diagrams were generated to illustrate the impact of H/C and O/C ratios of feedstock on the products obtained from six commonly used thermal conversion techniques: torrefaction, hydrothermal carbonization, hydrothermal liquefaction, hydrothermal gasification, pyrolysis, and gasification. Machine learning methods were employed, utilizing data, methods, and results from corresponding studies in this field. Furthermore, the reliability of the constructed van Krevelen diagrams was analyzed to assess their dependability. The van Krevelen diagrams developed in this work systematically provide visual representations of the relationships between feedstock and products in thermal conversion processes, thereby aiding in optimizing the selection of feedstock and the choice of thermal conversion technique.
|
|
5. |
- Wang, Yuming, et al.
(författare)
-
High-Efficiency Flexible Solar Cells Based on Organometal Halide Perovskites
- 2016
-
Ingår i: Advanced Materials. - : WILEY-V C H VERLAG GMBH. - 0935-9648 .- 1521-4095. ; 28:22, s. 4532-4540
-
Tidskriftsartikel (refereegranskat)abstract
- Flexible and light-weight solar cells are important because they not only supply power to wearable and portable devices, but also reduce the transportation and installation cost of solar panels. High-efficiency organometal halide perovskite solar cells can be fabricated by a low-temperature solution process, and hence are promising for flexible-solar-cell applications. Here, the development of perovskite solar cells is briefly discussed, followed by the merits of organometal halide perovskites as promising candidates as high-efficiency, flexible, and light-weight photovoltaic materials. Afterward, recent developments of flexible solar cells based on perovskites are reviewed.
|
|
6. |
- Wang, Yuming, et al.
(författare)
-
Light-induced degradation of fullerenes in organic solar cells : a case study on TQ1:PC71BM
- 2018
-
Ingår i: Journal of Materials Chemistry A. - : Royal Society of Chemistry. - 2050-7488 .- 2050-7496. ; 6:25, s. 11884-11889
-
Tidskriftsartikel (refereegranskat)abstract
- The stability of organic solar cells (OSCs) is critical for practical applications of this emerging technology. Unfortunately, in spite of intensive investigations, the degradation mechanisms in OSCs have not been clearly understood yet. In this report, we employ a range of spectroscopic and transport measurements, coupled with drift-diffusion modelling, to investigate the light-induced degradation mechanisms of fullerene-based OSCs. We find that trap states formed in the fullerene phase under illumination play a critical role in the degradation of the open-circuit voltage (V-OC) in OSCs. Our results indicate that the degradation is intrinsic to the fullerenes in OSCs and that alternative acceptor materials are desired for the development of stable OSCs.
|
|
7. |
- Yang, Rong, et al.
(författare)
-
Oriented Quasi-2D Perovskites for High Performance Optoelectronic Devices
- 2018
-
Ingår i: Advanced Materials. - : WILEY-V C H VERLAG GMBH. - 0935-9648 .- 1521-4095. ; 30:51
-
Tidskriftsartikel (refereegranskat)abstract
- Quasi-2D layered organometal halide perovskites have recently emerged as promising candidates for solar cells, because of their intrinsic stability compared to 3D analogs. However, relatively low power conversion efficiency (PCE) limits the application of 2D layered perovskites in photovoltaics, due to large energy band gap, high exciton binding energy, and poor interlayer charge transport. Here, efficient and water-stable quasi-2D perovskite solar cells with a peak PCE of 18.20% by using 3-bromobenzylammonium iodide are demonstrated. The unencapsulated devices sustain over 82% of their initial efficiency after 2400 h under relative humidity of approximate to 40%, and show almost unchanged photovoltaic parameters after immersion into water for 60 s. The robust performance of perovskite solar cells results from the quasi-2D perovskite films with hydrophobic nature and a high degree of electronic order and high crystallinity, which consists of both ordered large-bandgap perovskites with the vertical growth in the bottom region and oriented small-bandgap components in the top region. Moreover, due to the suppressed nonradiative recombination, the unencapsulated photovoltaic devices can work well as light-emitting diodes (LEDs), exhibiting an external quantum efficiency of 3.85% and a long operational lifetime of approximate to 96 h at a high current density of 200 mA cm(-2) in air.
|
|
8. |
- Fu, Huiting, et al.
(författare)
-
Suppression of Recombination Energy Losses by Decreasing the Energetic Offsets in Perylene Diimide-Based Nonfullerene Organic Solar Cells
- 2018
-
Ingår i: ACS Energy Letters. - : AMER CHEMICAL SOC. - 2380-8195. ; 3:11, s. 2729-2735
-
Tidskriftsartikel (refereegranskat)abstract
- In this work, a range of nonfullerene organic solar cells comprising two perylene diimide (PDI)-based small molecule acceptors in combination with four representative polymer donors have been investigated and compared. In addition to significant differences in the power conversion efficiency, the energy losses of photovoltaic devices vary widely for these two PDI-based acceptors when paired with different donors. The sensitive Fourier-transform photocurrent spectroscopy (FTPS) and electroluminescence (EL) measurements have been performed to quantify their respective energetic offsets (Delta(Eoffiet)) and energy losses, with the aim of understanding the distinct energy losses in the studied organic blends. By comparing these results, we find that with decreasing Delta(Eoffset), recombination loss due to the charge-transfer state absorption A both nonradiative recombination loss and radiative are suppressed; as a result, the total energy loss is decreased. These observations offer a deep understanding of how the energetic offset affects the energy losses from the viewpoint of the Shockey-Queisser limit.
|
|
9. |
|
|
10. |
- Gulshan, Samina, et al.
(författare)
-
Kinetic investigation on the catalytic pyrolysis of plastic fractions of waste electrical and electronic equipment (WEEE) : A mathematical deconvolution approach
- 2024
-
Ingår i: Waste Management. - : Elsevier Ltd. - 0956-053X .- 1879-2456. ; 187, s. 156-166
-
Tidskriftsartikel (refereegranskat)abstract
- Waste electrical and electronic equipment (WEEE) has become a critical environmental problem. Catalytic pyrolysis is an ideal technique to treat and convert the plastic fraction of WEEE into chemicals and fuels. Unfortunately, research using real WEEE remains relatively limited. Furthermore, the complexity of WEEE complicates the analysis of its pyrolytic kinetics. This study applied the Fraser-Suzuki mathematical deconvolution method to obtain the pseudo reactions of the thermal degradation of two types of WEEE, using four different catalysts (Al2O3, HBeta, HZSM-5, and TiO2) or without a catalyst. The main contributor(s) to each pseudo reaction were identified by comparing them with the pyrolysis results of the pure plastics in WEEE. The nth order model was then applied to estimate the kinetic parameters of the obtained pseudo reactions. In the low-grade electronics pyrolysis, the pseudo-1 reaction using TiO2 as a catalyst achieved the lowest activation energy of 92.10 kJ/mol, while the pseudo-2 reaction using HZSM-5 resulted in the lowest activation energy of 101.35 kJ/mol among the four catalytic cases. For medium-grade electronics, pseudo-3 and pseudo-4 were the main reactions for thermal degradation, with HZSM-5 and TiO2 yielding the lowest pyrolytic activation energies of 75.24 and 226.39 kJ/mol, respectively. This effort will play a crucial role in comprehending the pyrolysis kinetic mechanism of WEEE and propelling this technology toward a brighter future.
|
|