| 1. |
- Lin, Yuze, et al.
(författare)
-
Mapping Polymer Donors toward High-Efficiency Fullerene Free Organic Solar Cells
- 2017
-
Ingår i: Advanced Materials. - : WILEY-V C H VERLAG GMBH. - 0935-9648 .- 1521-4095. ; 29:3
-
Tidskriftsartikel (refereegranskat)abstract
- Five polymer donors with distinct chemical structures and different electronic properties are surveyed in a planar and narrow-bandgap fused-ring electron acceptor (IDIC)-based organic solar cells, which exhibit power conversion efficiencies of up to 11%.
|
|
| 2. |
- Melianas, Armantas, et al.
(författare)
-
Photogenerated Carrier Mobility Significantly Exceeds Injected Carrier Mobility in Organic Solar Cells
- 2017
-
Ingår i: Advanced Energy Materials. - : John Wiley & Sons. - 1614-6832 .- 1614-6840. ; 7:9
-
Tidskriftsartikel (refereegranskat)abstract
- Charge transport in organic photovoltaic (OPV) devices is often characterized by space-charge limited currents (SCLC). However, this technique only probes the transport of charges residing at quasi-equilibrium energies in the disorder-broadened density of states (DOS). In contrast, in an operating OPV device the photogenerated carriers are typically created at higher energies in the DOS, followed by slow thermalization. Here, by ultrafast time-resolved experiments and simulations it is shown that in disordered polymer/fullerene and polymer/polymer OPVs, the mobility of photogenerated carriers significantly exceeds that of injected carriers probed by SCLC. Time-resolved charge transport in a polymer/polymer OPV device is measured with exceptionally high (picosecond) time resolution. The essential physics that SCLC fails to capture is that of photogenerated carrier thermalization, which boosts carrier mobility. It is predicted that only for materials with a sufficiently low energetic disorder, thermalization effects on carrier transport can be neglected. For a typical device thickness of 100 nm, the limiting energetic disorder is σ ≈71 (56) meV for maximum-power point (short-circuit) conditions, depending on the error one is willing to accept. As in typical OPV materials the disorder is usually larger, the results question the validity of the SCLC method to describe operating OPVs.
|
|
| 3. |
- Täuber, Daniela, et al.
(författare)
-
Nanoscale Chain Alignment and Morphology in All-Polymer Blends Visualized Using 2D Polarization Fluorescence Imaging: Correlation to Power Conversion Efficiencies in Solar Cells
- 2017
-
Ingår i: The Journal of Physical Chemistry C. - : AMER CHEMICAL SOC. - 1932-7447 .- 1932-7455. ; 121:40, s. 21848-21856
-
Tidskriftsartikel (refereegranskat)abstract
- All-polymer blends are promising materials for organic electronics. Their performance critically depends on the quality of mixing of the electron donor and acceptor polymers and on the local chain organization. We investigated spatially resolved photoluminescence properties of as-prepared and annealed blends of poly[2,3-bis(3-octyloxyphenyl)quinoxaline-5,8-diyl-alt-thiophene-2,5-diyl] (TQ1) and poly(N,N-bis-2-octyldodecyl-naphtalene-1,4,5,8-bisdicarboximide-2,6-diyl-alt- 5,5-2,2-bithiophene) (N2200) using two-dimensional polarization imaging (2D POLIM). N2200 is known to aggregate into fiber-like morphologies with a few hundreds of nanometers lateral extensions. Our findings suggest a highly parallel chain organization within individual domains. Comparing blends differing in the batch of the N2200 component, we could relate decreased power conversion efficiencies of the corresponding devices to aggregation of N2200 in tens of micrometer-sized elongated structures. TQ1 showed less sensitivity to preparation conditions. Other than N2200, TQ1 is liquid crystalline, and its side chain structure hinders aggregation. It thus might be feasible to consider similar properties for the design of acceptor polymers as well.
|
|
| 4. |
- Yuan, Jianyu, et al.
(författare)
-
Comparing the device physics, dynamics and morphology of polymer solar cells employing conventional PCBM and non-fullerene polymer acceptor N2200
- 2017
-
Ingår i: Nano Energy. - : ELSEVIER SCIENCE BV. - 2211-2855 .- 2211-3282. ; 35, s. 251-262
-
Tidskriftsartikel (refereegranskat)abstract
- Current all polymer solar cells still suffer from low fill factors (FF) and short-circuit current density (J(sc)) compared with the conventional polymer/fullerene system. Herein in this work, devices using PTP8 as the electron donor and [70]PCBM as well as widely used polymer N2200 as the electron acceptor were systematically studied and compared. The major loss mechanisms in the all polymer solar cells were investigated to understand their relatively lower performance than the PTP8/fullerene system. By performing in-depth analysis on ultrafast transient transmission spectroscopy results, we estimated that in PTP8/N2200 device nearly half of the charges recombine geminately, which is confirmed as the major factor hindering the device performance of all polymer solar cells compared with polymer/fullerene system. Through thorough morphology analysis, the low charge generation efficiency is attributed to the reduced crystallinity of N2200 in the blend film and the unfavorable face-to-edge orientation at the donor/acceptor heterojunction. Coupling these results with knowledge from efficient polymer/fullerene systems, the future design of new polymers can devote to increase the attraction between the pi face of donor and acceptor, leading to enhanced face-to-face orientation at the heterojunction, while maintaining a high pi-pi stacking order for each polymer.
|
|
