| 1. |
- von Fieandt, Linus, et al.
(author)
-
Corrosion properties of CVD grown Ti(C,N) coatings in 3.5 wt-% NaCl environment
- 2018
-
In: Corrosion Engineering, Science and Technology. - 1478-422X .- 1743-2782. ; 53:4, s. 316-320
-
Journal article (peer-reviewed)abstract
- The corrosion behaviour of Titanium carbonitride (Ti(C,N)) films grown by chemical vapour deposition was analysed in artificial sea water environment. From potentiodynamic polarisation curves, two passivation zones were detected, which originated from an initial oxidation of TiC and TiN to TiO2 followed by growth of the TiO2 layer upon increased polarisation. X-ray photoelectron spectroscopy analyses verified the mechanism by detecting a gradual decrease in Ti(C,N) peaks accompanied by a gradual increase of oxidised Ti (e.g. TiO2). It was likewise found that carbon in TiC mainly decomposes into carbonate species while the nitrogen in TiN remains elemental and likely escapes as nitrogen gas. Accordingly, Ti(C,N) behaves like a superposition of TiC and TiN with their individual oxidation behaviour, resulting in a highly corrosion resistant material.
|
|
| 2. |
- von Fieandt, Linus, et al.
(author)
-
On the growth, orientation and hardness of chemical vapor deposited Ti(C,N)
- 2018
-
In: Thin Solid Films. - : Elsevier BV. - 0040-6090 .- 1879-2731. ; 645, s. 19-26
-
Journal article (peer-reviewed)abstract
- Chemical vapor deposition (CVD) of Ti(C,N) from a reaction gas mixture of TiCl4, CH3CN, H2 and N2 was investigated with respect to gas phase composition and kinetics. The gas phase composition was modelled by thermodynamic calculations and the growth rate of the CVD process was measured when replacing H2 for N2 while the sum of partial pressures H2+N2 was kept constant. The N2/H2 molar ratio was varied from 0 to 19. Single crystal c-sapphire was used as substrates. It was found that low molar ratios (N2/H2 molar ratio below 0.6) lead to an increased Ti(C,N) growth rate with up to 22%, compared to deposition without added N2. The mechanism responsible for the increased growth rate was attributed to the formation and increased gas phase concentration of one major growth species, HCN, in the gas phase. The texture of the Ti(C,N) films were also studied. ⟨211⟩ textured layers were deposited at N2/H2 molar ratios below 9. At higher molar ratios, ⟨111⟩ oriented Ti(C,N) layers were deposited and the grain size increased considerably. The films deposited at a N2/H2 ratio above 9 exhibited superior hardness, reaching 37GPa. The increased hardness is attributed to an almost epitaxial orientation between the layer and the substrate. The absence of grain twinning in the ⟨111⟩ oriented layer also contributed to the increased hardness.The Ti(C,N) layers were characterized by elastic recoil detection analysis, X-ray photo electron spectroscopy, scanning electron microscopy, X-ray diffraction and nanoindentation.
|
|
