1. |
- Adcox, K, et al.
(author)
-
Formation of dense partonic matter in relativistic nucleus-nucleus collisions at RHIC: Experimental evaluation by the PHENIX Collaboration
- 2005
-
In: Nuclear Physics, Section A. - : Elsevier BV. - 0375-9474. ; 757:1-2, s. 184-283
-
Research review (peer-reviewed)abstract
- Extensive experimental data from high-energy nucleus-nucleus collisions were recorded using the PHENIX detector at the Relativistic Heavy Ion Collider (RHIC). The comprehensive set of measurements from the first three years of RHIC operation includes charged particle multiplicities, transverse energy, yield ratios and spectra of identified hadrons in a wide range of transverse momenta (PT), elliptic flow, two-particle correlations, nonstatistical fluctuations, and suppression of particle production at high PT. The results are examined with an emphasis on implications for the formation of a new state of dense matter. We find that the state of matter created at RHIC cannot be described in terms of ordinary color neutral hadrons.
|
|
2. |
- Abate, E., et al.
(author)
-
Combined performance tests before installation of the ATLAS Semiconductor and Transition Radiation Tracking Detectors
- 2008
-
In: Journal of Instrumentation. - 1748-0221. ; 3
-
Journal article (peer-reviewed)abstract
- The ATLAS (A Toroidal LHC ApparatuS) Inner Detector provides charged particle tracking in the centre of the ATLAS experiment at the Large Hadron Collider (LHC). The Inner Detector consists of three subdetectors: the Pixel Detector, the Semiconductor Tracker (SCT), and the Transition Radiation Tracker (TRT). This paper summarizes the tests that were carried out at the final stage of SCT+TRT integration prior to their installation in ATLAS. The combined operation and performance of the SCT and TRT barrel and endcap detectors was investigated through a series of noise tests, and by recording the tracks of cosmic rays. This was a crucial test of hardware and software of the combined tracker detector systems. The results of noise and cross-talk tests on the SCT and TRT in their final assembled configuration, using final readout and supply hardware and software, are reported. The reconstruction and analysis of the recorded cosmic tracks allowed testing of the offline analysis chain and verification of basic tracker performance parameters, such as efficiency and spatial resolution, in combined operation before installation.
|
|
3. |
- Abdesselam, A., et al.
(author)
-
Engineering for the ATLAS SemiConductor Tracker (SCT) end-cap
- 2008
-
In: Journal of Instrumentation. - 1748-0221. ; 3
-
Journal article (peer-reviewed)abstract
- The ATLAS SemiConductor Tracker (SCT) is a silicon-strip tracking detector which forms part of the ATLAS inner detector. The SCT is designed to track charged particles produced in proton-proton collisions at the Large Hadron Collider (LHC) at CERN at an energy of 14 TeV. The tracker is made up of a central barrel and two identical end-caps. The barrel contains 2112 silicon modules, while each end-cap contains 988 modules. The overall tracking performance depends not only on the intrinsic measurement precision of the modules but also on the characteristics of the whole assembly, in particular, the stability and the total material budget. This paper describes the engineering design and construction of the SCT end-caps, which are required to support mechanically the silicon modules, supply services to them and provide a suitable environment within the inner detector. Critical engineering choices are highlighted and innovative solutions are presented - these will be of interest to other builders of large-scale tracking detectors. The SCT end-caps will be fully connected at the start of 2008. Further commissioning will continue, to be ready for proton-proton collision data in 2008.
|
|
4. |
- Abdesselam, A., et al.
(author)
-
The ATLAS semiconductor tracker end-cap module
- 2007
-
In: Nuclear Instruments and Methods in Physics Research Section A. - : Elsevier BV. - 0168-9002 .- 1872-9576. ; 575:3, s. 353-389
-
Journal article (peer-reviewed)abstract
- The challenges for the tracking detector systems at the LHC are unprecedented in terms of the number of channels, the required read-out speed and the expected radiation levels. The ATLAS Semiconductor Tracker. (SCT) end-caps have a total of about 3 million electronics channels each reading out every 25 ns into its own on-chip 3.3 mu s buffer. The highest anticipated dose after 10 years operation is 1.4x10(14) cm(-2) in units of 1 MeV neutron equivalent (assuming the damage factors scale with the non-ionising energy loss). The forward tracker has 1976 double-sided modules, mostly of area similar to 70 cm(2), each having 2 x 768 strips read out by six ASICs per side. The requirement to achieve an average perpendicular radiation length of 1.5% X-0, while coping with up to 7 W dissipation per module (after irradiation), leads to stringent constraints on the thermal design. The additional requirement of 1500e(-) equivalent noise charge (ENC) rising to only 1800e(-) ENC after irradiation, provides stringent design constraints on both the high-density Cu/Polyimide flex read-out circuit and the ABCD3TA read-out ASICs. Finally, the accuracy of module assembly must not compromise the 16 mu m (r phi) resolution perpendicular to the strip directions or 580 mu m radial resolution coming from the 40 mrad front-back stereo angle. A total of 2210 modules were built to the tight tolerances and specifications required for the SCT. This was 234 more than the 1976 required and represents a yield of 93%. The component flow was at times tight, but the module production rate of 40-50 per week was maintained despite this. The distributed production was not found to be a major logistical problem and it allowed additional flexibility to take advantage of where the effort was available, including any spare capacity, for building the end-cap modules. The collaboration that produced the ATLAS SCT end-cap modules kept in close contact at all times so that the effects of shortages or stoppages at different sites could be rapidly resolved.
|
|
5. |
- Abdesselam, A., et al.
(author)
-
The barrel modules of the ATLAS semiconductor tracker
- 2006
-
In: Nuclear Instruments and Methods in Physics Research Section A. - : Elsevier BV. - 0168-9002 .- 1872-9576. ; 568:2, s. 642-671
-
Journal article (peer-reviewed)abstract
- This paper describes the silicon microstrip modules in the barrel section of the SemiConductor Tracker (SCT) of the ATLAS experiment at the CERN Large Hadron Collider (LHC). The module requirements, components and assembly techniques are given, as well as first results of the module performance on the fully assembled barrels that make up the detector being installed in the ATLAS experiment.
|
|
6. |
- Doornenbal, P., et al.
(author)
-
Spectroscopy of 32Ne and the "Island of Inversion"
- 2009
-
In: Physical Review Letters. - American Physical Society. - 0031-9007 .- 1079-7114. ; 103:3, s. 032501-1-032501-4
-
Journal article (peer-reviewed)abstract
- We report on the first spectroscopic study of the N = 22 nucleus 32Ne at the newly completed RIKEN Radioactive Ion Beam Factory. A single γ-ray line with an energy of 722(9) keV was observed in both inelastic scattering of a 226 MeV=u 32Ne beam on a carbon target and proton removal from 33Na at 245 MeV=u. This transition is assigned to the deexcitation of the first Jπ = 2+ state in 32Ne to the 0+ ground state. Interpreted through comparison with state-of-the-art shell-model calculations, the low excitation energy demonstrates that the ‘‘island of inversion’’ extends to at least N = 22 for the Ne isotopes.
|
|
7. |
|
|
8. |
- Jönsson, K. Ingemar, 1959-, et al.
(author)
-
Sexual patterns of prebreeding energy reserves in the common frog Rana temporaria along a latitudinal gradient
- 2009
-
In: Ecography. - : Wiley-Blackwell. - 0906-7590 .- 1600-0587. ; 32:5, s. 831-839
-
Journal article (peer-reviewed)abstract
- The ability to store energy is an important life history trait for organisms facing long periods without energy income, and in particular for capital breeders such as temperate zone amphibians, which rely on stored energy during reproduction. However, large scale comparative studies of energy stores in populations with different environmental constraints on energy allocation are scarce. We investigated energy storage patterns in spring (after hibernation and before reproduction) in eight common frog (Rana temporaria) populations exposed to different environmental conditions along a 1600 km latitudinal gradient across Scandinavia (range of annual activity period 3-7 months). Analyses of lean body weight (eviscerated body mass), weight of fat bodies, liver weight, and liver fat content, showed that (i) post-hibernation/pre-breeding energy stores increased with increasing latitude in both sexes, (ii) males generally had larger energy reserves than females and (iii) the difference in energy stores between sexes decreased towards the north. Larger energy reserves towards the north can serve as a buffer against less predictable and/or less benign weather conditions during the short activity period, and may also represent a risk-averse tactic connected with a more pronounced iteroparous life history. In females, the continuous and overlapping vitellogenic activity in the north may also demand more reserves in early spring. The general sexual difference could be a consequence of the fact that, at the time of our sampling, females had already invested their energy into reproduction in the given year (i.e. their eggs were already ovulated), while the males' main reproductive activities (e.g. calling, mate searching, sexual competition) occurred later in the season.
|
|
9. |
- Abe, Y, et al.
(author)
-
Feasibility of a nylon-mesh holder for vitrification of bovine germinal vesicle oocytes in subsequent production of viable blastocysts
- 2005
-
In: Biology of Reproduction. - : Society for the Study of Reproduction. - 0006-3363 .- 1529-7268. ; 72:6, s. 1416-1420
-
Journal article (peer-reviewed)abstract
- To improve the feasibility of nylon-mesh holder for vitrification of bovine cumulus-oocytes complexes (GV-COCs) having germinal vesicle, this study was conducted to demonstrate effects of sugars and protocol of exposure in vitrification on subsequent in vitro maturation, ultrastructural changes, and in vitro development in bovine immature oocytes after cryopreservation using nylon mesh. Before vitrification, GV-COCs were exposed to the cryoprotectant, which was composed of 40% (v/v) ethylene glycol, 18% (w/v) Ficoll-70, and 0.3 M sucrose (EFS40) or 0.3 M trehalose (EFT40), either by single step or in a stepwise way. The maturation rates in the stepwise exposure with EFS40 or EFT40 were significantly higher (P less than 0.05) compared with the corresponding rates in the single step. In the stepwise exposure, few abnormalities were observed compared with the single-step exposure, where most oocytes showed a highly vacuolated cytoplasm with many ruptured mitochondria. Cleavage rates in fertilized oocytes previously exposed stepwise to EFS40 or EFT40 were significantly higher than those exposed by the single-step procedure. The cleaved embryos derived from the stepwise exposure to EFS40 developed to blastocysts. After transfer of blastocysts derived from vitrified GV oocytes, a female calf was born. These results indicate that vitrification of large numbers of bovine GV-COCs using a nylon-mesh holder accompanied with stepwise exposure minimizes structural damage in organelles, resulting in yield of viable blastocysts following in vitro embryo production.
|
|
10. |
- Hautmann, R, et al.
(author)
-
Urinary diversion
- 2006
-
In: Bladder Tumors. ; , s. 239-239
-
Book chapter (other academic/artistic)
|
|
11. |
|
|