1. |
- Soares, M., et al.
(author)
-
Particles in exhaled air (PExA): non-invasive phenotyping of small airways disease in adult asthma
- 2018
-
In: Journal of Breath Research. - : IOP Publishing. - 1752-7155 .- 1752-7163. ; 12:4
-
Journal article (peer-reviewed)abstract
- Rationale: Asthma is often characterised by inflammation, damage and dysfunction of the small airways, but no standardised biomarkers are available. Objectives: Using a novel approach-particles in exhaled air (PExA)-we sought to (a) sample and analyse abundant protein biomarkers: surfactant protein A (SPA) and albumin in adult asthmatic and healthy patients and (b) relate protein concentrations with physiological markers using phenotyping. Methods: 83 adult asthmatics and 21 healthy volunteers were recruited from a discovery cohort in Leicester, UK, and 32 adult asthmatics as replication cohort from Sweden. Markers of airways closure/small airways dysfunction were evaluated using forced vital capacity, impulse oscillometry and multiple breath washout. SPA/albumin from PEx (PExA sample) were analysed using ELISA and corrected for acquired particle mass. Topological data analysis (TDA) was applied to small airway physiology and PExA protein data to identify phenotypes. Results: PExA manoeuvres were feasible, including severe asthmatic subjects. TDA identified a clinically important phenotype of asthmatic patients with multiple physiological markers of peripheral airway dysfunction, and significantly lower levels of both SPA and albumin. Conclusion: We report that the PExA method is feasible across the spectrum of asthma severity and could be used to identify small airway disease phenotypes.
|
|
2. |
- Strandberg, Bo, 1960, et al.
(author)
-
An improved method for determining dermal exposure to polycyclic aromatic hydrocarbons
- 2018
-
In: Chemosphere. - : Elsevier BV. - 0045-6535 .- 1879-1298. ; 198, s. 274-280
-
Journal article (peer-reviewed)abstract
- Many workers are occupationally exposed to polycyclic aromatic hydrocarbons (PAHs), which may cause various health problems, and some PAHs are known or suspected carcinogens. PAH exposure is primarily monitored by air sampling, but contamination may also occur through dermal exposure. PAHs adsorbed to the skin can be sampled by tape-stripping, but subsequent extraction of sampling tapes in organic solvent also releases diverse co-eluting substances that are difficult to remove before analysis of the PAHs by gas chromatography/mass spectrometry (GC/MS). The objective of this study was to optimise a procedure for analytical clean-up after extraction of 32 PAHs from tape-strips, by dialysis in organic solvent using semipermeable membranes. With triplicate subsamples, the developed method yields acceptable precision and repeatability for both the 32 PAHs, across the concentration range 10-160 ng per sample, and for a certified reference material (urban dust). The optimized clean-up procedure and GC/MS methodology was used to assess PAHs on skin from the lower part of the ventral side of the wrist and just below the collar bone of three firefighters and seven controls (office workers). Several gaseous and particle-bound PAHs were detected in all samples, including controls. Thus, the optimized procedure using semipermeable membranes for clean-up of tape-strip extracts can be used to assess the dermal exposure of both occupational and general populations to multiple PAHs. The results also show that both gaseous and particle-bound PAHs, including alkylated species, may be present on skin.
|
|
3. |
- Strandberg, Bo, 1960, et al.
(author)
-
Evaluation of polyurethane foam passive air sampler (PUF) as a tool for occupational PAH measurements
- 2018
-
In: Chemosphere. - : Elsevier BV. - 0045-6535 .- 1879-1298. ; 190, s. 35-42
-
Journal article (peer-reviewed)abstract
- Routine monitoring of workplace exposure to polycyclic aromatic hydrocarbons (PAHs) is performed mainly via active sampling. However, active samplers have several drawbacks and, in some cases, may even be unusable. Polyurethane foam (PUF) as personal passive air samplers constitute good alternatives for PAH monitoring in occupational air (8 h). However, PUFs must be further tested to reliably yield detectable levels of PAHs in short exposure times (1–3 h) and under extreme occupational conditions. Therefore, we compared the personal exposure monitoring performance of a passive PUF sampler with that of an active air sampler and determined the corresponding uptake rates (Rs). These rates were then used to estimate the occupational exposure of firefighters and police forensic specialists to 32 PAHs. The work environments studied were heavily contaminated by PAHs with (for example) benzo(a)pyrene ranging from 0.2 to 56 ng m−3, as measured via active sampling. We show that, even after short exposure times, PUF can reliably accumulate both gaseous and particle-bound PAHs. The Rs-values are almost independent of variables such as the concentration and the wind speed. Therefore, by using the Rs-values (2.0–20 m3 day−1), the air concentrations can be estimated within a factor of two for gaseous PAHs and a factor of 10 for particulate PAHs. With very short sampling times (1 h), our method can serve as a (i) simple and user-friendly semi-quantitative screening tool for estimating and tracking point sources of PAH in micro-environments and (ii) complement to the traditional active pumping methods. © 2017 The Authors
|
|