1. |
- Teixeira, H., et al.
(author)
-
Assessing coastal benthic macrofauna community condition using best professional judgement - Developing consensus across North America and Europe
- 2010
-
In: Marine Pollution Bulletin. - 0025-326X. ; 60:4, s. 589-600
-
Journal article (peer-reviewed)abstract
- Benthic indices are typically developed independently by habitat, making their incorporation into large geographic scale assessments potentially problematic because of scaling inequities. A potential solution is to establish common scaling using expert best professional judgment (BPJ). To test if experts from different geographies agree on condition assessment, sixteen experts from four regions in USA and Europe were provided species-abundance data for twelve sites per region. They ranked samples from best to worst condition and classified samples into four condition (quality) categories. Site rankings were highly correlated among experts, regardless of whether they were assessing samples from their home region. There was also good agreement on condition category, though agreement was better for samples at extremes of the disturbance gradient. The absence of regional bias suggests that expert judgment is a viable means for establishing a uniform scale to calibrate indices consistently across geographic regions. (C) 2009 Elsevier Ltd. All rights reserved.
|
|
2. |
- Ranasinghe, C., et al.
(author)
-
A simplified method for determining gas turbine performance parameters based upon available catalogue data
- 2014
-
In: Proceedings of the ASME Turbo Expo. - 9780791845752
-
Conference paper (peer-reviewed)abstract
- Overall theoretical performance analysis of gas turbines can be conducted by applying design parameters into several thermodynamic theories and equations. However, limited availability of the design parameters will not provide sufficient room for a detailed analysis. Ga s turbine manufacturers publish only a limited amount of design/performance data, while important parameters remained hidden and the available information is not sufficiently enough for obtaining a complete gas turbine performance dataset. Five main parameters commonly provided by a gas turbine manufacturer's catalogues; pressure ratio of the compressor, exhaust mass flow rate, exhaust temperature of flue gas, overall efficiency, and electrical output. A theoretical model developed based on Mathcad software as documented in literature is used to reveal other hidden gas turbine parameters. A similar theoretical model using another solver was developed to obtain a complete dataset by using the available catalogue data with additional assumptions, which correspond to the commercial state of the art. The engineering equation solver (EES) software has been used as a platform to rebuild the theoretical model. As the main development, a graphical user interphase (GUI) has been introduced to the new program with the aim to make it more user friendly. Furthermore on top of obtaining the hidden thermodynamic parameters for the gas turbine, performing flue gas analysis and an exergy analysis has now become possible through this program. The developed EES program is expected to be run in the learning laboratory at the Division of Heat and Power Technology, Department of Energy Technology, Royal Institute of Technology (KTH), Stockholm and finally it is going to be incorporated into CompEdu Learning Platform of the same division.
|
|