1. |
- Schael, S, et al.
(author)
-
Precision electroweak measurements on the Z resonance
- 2006
-
In: Physics Reports. - : Elsevier BV. - 0370-1573 .- 1873-6270. ; 427:5-6, s. 257-454
-
Research review (peer-reviewed)abstract
- We report on the final electroweak measurements performed with data taken at the Z resonance by the experiments operating at the electron-positron colliders SLC and LEP. The data consist of 17 million Z decays accumulated by the ALEPH, DELPHI, L3 and OPAL experiments at LEP, and 600 thousand Z decays by the SLID experiment using a polarised beam at SLC. The measurements include cross-sections, forward-backward asymmetries and polarised asymmetries. The mass and width of the Z boson, m(Z) and Gamma(Z), and its couplings to fermions, for example the p parameter and the effective electroweak mixing angle for leptons, are precisely measured: m(Z) = 91.1875 +/- 0.0021 GeV, Gamma(Z) = 2.4952 +/- 0.0023 GeV, rho(l) = 1.0050 +/- 0.0010, sin(2)theta(eff)(lept) = 0.23153 +/- 0.00016. The number of light neutrino species is determined to be 2.9840 +/- 0.0082, in agreement with the three observed generations of fundamental fermions. The results are compared to the predictions of the Standard Model (SM). At the Z-pole, electroweak radiative corrections beyond the running of the QED and QCD coupling constants are observed with a significance of five standard deviations, and in agreement with the Standard Model. Of the many Z-pole measurements, the forward-backward asymmetry in b-quark production shows the largest difference with respect to its SM expectation, at the level of 2.8 standard deviations. Through radiative corrections evaluated in the framework of the Standard Model, the Z-pole data are also used to predict the mass of the top quark, m(t) = 173(+10)(+13) GeV, and the mass of the W boson, m(W) = 80.363 +/- 0.032 GeV. These indirect constraints are compared to the direct measurements, providing a stringent test of the SM. Using in addition the direct measurements of m(t) and m(W), the mass of the as yet unobserved SM Higgs boson is predicted with a relative uncertainty of about 50% and found to be less than 285 GeV at 95% confidence level. (c) 2006 Elsevier B.V. All rights reserved.
|
|
2. |
- Delahaye, P, et al.
(author)
-
Recent results with the Phoenix booster at ISOLDE
- 2006
-
In: Review of Scientific Instruments. - : AIP Publishing. - 0034-6748 .- 1089-7623. ; 77:3, s. 03B105-
-
Journal article (peer-reviewed)abstract
- At ISOLDE, CERN the development of charge breeding techniques is one of the key points for numerous future experiments. We report in this article on the latest online tests of the Daresbury Phoenix booster at ISOLDE. The performances of the continuous mode were investigated for different injected stable beams. Preliminary results were obtained with the afterglow pulsing method and two injected noble gas isotopes. These latter tests are of particular interest for the postacceleration of ISOL-type beams.
|
|
3. |
- Fedosseev, V. N., et al.
(author)
-
ISOLDE RILIS : New beams, new facilities
- 2008
-
In: Nuclear Instruments and Methods in Physics Research Section B. - : Elsevier BV. - 0168-583X .- 1872-9584. ; 266:19-20, s. 4378-4382
-
Journal article (peer-reviewed)abstract
- The resonance ionization laser ion source (RILIS) at the ISOLDE on-line isotope separator is based on the selective excitation of atomic transitions by tunable laser radiation. New ion beams have been produced with RILIS in recent years: Sb, Sc, Dy, Au, Hg and Po. In total, isotopes of 26 different elements have been selectively laser-ionized and separated at ISOLDE. In order to facilitate the work on development of atomic ionization schemes an off-line laser laboratory has been established at CERN. Operating independently of the on-line RI LIS setup, this laboratory will be capable of providing extensive data on atomic transitions, in particular between highly excited and auto-ionizing atomic states, which are required for the improvement of the RILIS efficiency. Additionally, the program gram of upgrading the on-line RI LIS system by the implementation of solid state lasers will be presented.
|
|
4. |
- Fritioff, T., et al.
(author)
-
Purification of radioactive neutron-rich argon beams using an ion source in charge breeding mode
- 2006
-
In: Nuclear Instruments and Methods in Physics Research Section A. - : Elsevier BV. - 0168-9002 .- 1872-9576 .- 0167-5087. ; 556:1, s. 31-37
-
Journal article (peer-reviewed)abstract
- Measurements of nuclear properties of some neutron-rich asymmetric fission isotopes at an ISOL laboratory present a severe problem when a plasma ion source is used as the primary ion-source. The problem is associated with intense multi-charged symmetric fission contaminants that cannot be mass-separated from asymmetric fission products. In this work we demonstrate how this problem can be overcome on-line by using an electron cyclotron resonance ion source (ECRIS) as a charge-breeding secondary ion-source. Mixed Ar+/Kr2+/Xe3+ radioactive beams from an plasma ion-source were injected into the PHOENIX ECRIS that currently is installed at the ISOLDE facility at CERN in order to improve the ratio of Ar to the background contaminants of Kr and Xe. The signal to noise ratio was improved by more than two orders of magnitude after charge-breeding and mass-separation of the Ar8+, Ar9+ beams. The information on the decay of the Ar-48 nucleus obtained in these tests is useful for a better understanding of the origin of the Ca-48/Ca-46 meteorite isotopic anomaly. Potential applications of the method are discussed.
|
|
5. |
- Marsh, B. A., et al.
(author)
-
The ISOLDE RILIS pump laser upgrade and the LARIS Laboratory
- 2010
-
In: Hyperfine Interactions. - : Springer Nature. - 0304-3843 .- 1572-9540. ; 196:1-3, s. 129-141
-
Journal article (peer-reviewed)abstract
- On account of its high efficiency, speed and unmatched selectivity, the Resonance Ionization Laser Ion Source (RILIS) is the preferred method for ionizing the nuclear reaction products at the ISOLDE on-line isotope separator facility. By exploiting the unique electronic energy level 'fingerprint' of a chosen element, the RILIS process of laser step-wise resonance ionization enables an ion beam of high chemical purity to be sent through the mass selective separator magnet. The isobaric purity of a beam of a chosen isotope is therefore greatly increased. The RILIS, comprising of up to three frequency tunable pulsed dye lasers has been upgraded with the installation of a Nd:YAG pump laser as a replacement for the old Copper Vapor Laser (CVL) system. A summary of the current Nd:YAG pumped RILIS performance is given. To accompany the RILIS pump laser upgrade, a new ionization scheme for manganese has been developed at the newly constructed LAser Resonance Ionization Spectroscopy (LARIS) laboratory and successfully applied for on-line RILIS operation. An overview of the LARIS facility is given along with details of the ionization scheme development work for manganese.
|
|