1. |
- Aaltonen, T., et al.
(author)
-
Combination of CDF and D0 W-Boson mass measurements
- 2013
-
In: Physical Review D. - 1550-7998 .- 1550-2368. ; 88:5, s. 052018-
-
Journal article (peer-reviewed)abstract
- We summarize and combine direct measurements of the mass of the W boson in root s = 1.96 TeV proton-antiproton collision data collected by CDF and D0 experiments at the Fermilab Tevatron Collider. Earlier measurements from CDF and D0 are combined with the two latest, more precise measurements: a CDF measurement in the electron and muon channels using data corresponding to 2.2 fb(-1) of integrated luminosity, and a D0 measurement in the electron channel using data corresponding to 4.3 fb(-1) of integrated luminosity. The resulting Tevatron average for the mass of the W boson is M-W = 80387 +/- 16 MeV. Including measurements obtained in electron-positron collisions at LEP yields the most precise value of M-W = 80385 +/- 15 MeV.
|
|
2. |
- Aaltonen, T., et al.
(author)
-
Combination of measurements of the top-quark pair production cross section from the Tevatron Collider
- 2014
-
In: Physical Review D. - 1550-7998 .- 1550-2368. ; 89:7
-
Journal article (peer-reviewed)abstract
- We combine six measurements of the inclusive top-quark pair (t(sic)) production cross section (sigma(t)(sic)) from data collected with the CDF and D0 detectors at the Fermilab Tevatron with proton-antiproton collisions at root s = 1.96 TeV. The data correspond to integrated luminosities of up to 8.8 fb(-1). We obtain a value of sigma tt = 7.60 +/- 0.41 pb for a top-quark mass of m(t) = 172.5 GeV. The contributions to the uncertainty are 0.20 pb from statistical sources, 0.29 pb from systematic sources, and 0.21 pb from the uncertainty on the integrated luminosity. The result is in good agreement with the standard model expectation of 7.35(-0.33)(+0.28) pb at next-to-next-to-leading order and next-to-next-to leading logarithms in perturbative QCD.
|
|
3. |
- Aaltonen, T., et al.
(author)
-
Combined Forward-Backward Asymmetry Measurements in Top-Antitop Quark Production at the Tevatron
- 2018
-
In: Physical Review Letters. - : AMER PHYSICAL SOC. - 0031-9007 .- 1079-7114. ; 120:4
-
Journal article (peer-reviewed)abstract
- The CDF and D0 experiments at the Fermilab Tevatron have measured the asymmetry between yields of forward- and backward-produced top and antitop quarks based on their rapidity difference and the asymmetry between their decay leptons. These measurements use the full data sets collected in proton-antiproton collisions at a center-of-mass energy of root s = 1.96 TeV. We report the results of combinations of the inclusive asymmetries and their differential dependencies on relevant kinematic quantities. The combined inclusive asymmetry is A(FB)(t (t) over bar) = 0.128 +/- 0.025. The combined inclusive and differential asymmetries are consistent with recent standard model predictions.
|
|
4. |
- Aaltonen, T., et al.
(author)
-
Observation of s-Channel Production of Single Top Quarks at the Tevatron
- 2014
-
In: Physical Review Letters. - 0031-9007 .- 1079-7114. ; 112:23
-
Journal article (peer-reviewed)abstract
- We report the first observation of single-top-quark production in the s channel through the combination of the CDF and D0 measurements of the cross section in proton-antiproton collisions at a center-of-mass energy of 1.96 TeV. The data correspond to total integrated luminosities of up to 9.7 fb(-1) per experiment. The measured cross section is sigma(s) = 1.29(-0.24)(+0.26) pb. The probability of observing a statistical fluctuation of the background to a cross section of the observed size or larger is 1.8 x 10(-10), corresponding to a significance of 6.3 standard deviations for the presence of an s-channel contribution to the production of single-top quarks.
|
|
5. |
- Aaltonen, T., et al.
(author)
-
Tevatron Combination of Single-Top-Quark Cross Sections and Determination of the Magnitude of the Cabibbo-Kobayashi-Maskawa Matrix Element V-tb
- 2015
-
In: Physical Review Letters. - 0031-9007 .- 1079-7114. ; 115:15
-
Journal article (peer-reviewed)abstract
- We present the final combination of CDF and D0 measurements of cross sections for single-top-quark production in proton-antiproton collisions at a center-of-mass energy of 1.96 TeV. The data correspond to total integrated luminosities of up to 9.7 fb(-1) per experiment. The t-channel cross section is measured to be sigma(t) = 2.25(-0.31)(+0.29) pb. We also present the combinations of the two-dimensional measurements of the s- vs t-channel cross section. In addition, we give the combination of the s + t channel cross section measurement resulting in sigma(s+t) = 3.30(-0.40)(+0.52) pb, without assuming the standard model value for the ratio sigma(s)/sigma(t). The resulting value of the magnitude of the top-to-bottom quark coupling is vertical bar V-tb vertical bar = 1.02(-0.05)(+0.06), corresponding to vertical bar V-tb vertical bar > 0.92 at the 95% C. L.
|
|
6. |
- Aaltonen, T., et al.
(author)
-
Tevatron Constraints on Models of the Higgs Boson with Exotic Spin and Parity Using Decays to Bottom-Antibottom Quark Pairs
- 2015
-
In: Physical Review Letters. - 0031-9007 .- 1079-7114. ; 114:15
-
Journal article (peer-reviewed)abstract
- Combined constraints from the CDF and D0 Collaborations on models of the Higgs boson with exotic spin J and parity P are presented and compared with results obtained assuming the standard model value J(P) = 0(+). Both collaborations analyzed approximately 10 fb(-1) of proton-antiproton collisions with a center-of-mass energy of 1.96 TeV collected at the Fermilab Tevatron. Two models predicting exotic Higgs bosons with J(P) = 0(-) and J(P) = 2(+) are tested. The kinematic properties of exotic Higgs boson production in association with a vector boson differ from those predicted for the standard model Higgs boson. Upper limits at the 95% credibility level on the production rates of the exotic Higgs bosons, expressed as fractions of the standard model Higgs boson production rate, are set at 0.36 for both the J(P) = 0(-) hypothesis and the J(P) = 2(+) hypothesis. If the production rate times the branching ratio to a bottom-antibottom pair is the same as that predicted for the standard model Higgs boson, then the exotic bosons are excluded with significances of 5.0 standard deviations and 4.9 standard deviations for the J(P) = 0(-) and J(P) = 2(+) hypotheses, respectively.
|
|
7. |
- Aaltonen, T., et al.
(author)
-
Tevatron Run II combination of the effective leptonic electroweak mixing angle
- 2018
-
In: Physical Review D. - : AMER PHYSICAL SOC. - 2470-0010 .- 2470-0029. ; 97:11
-
Journal article (peer-reviewed)abstract
- Drell-Yan lepton pairs produced in the process p (p) over bar -> l(+)l(-) + X through an intermediate gamma*/Z boson have an asymmetry in their angular distribution related to the spontaneous symmetry breaking of the electroweak force and the associated mixing of its neutral gauge bosons. The CDF and D0 experiments have measured the effective-leptonic electroweak mixing parameter sin(2) theta(lept)(eff) using electron and muon pairs selected from the full Tevatron proton-antiproton data sets collected in 2001-2011, corresponding to 9-10 fb(-1) of integrated luminosity. The combination of these measurements yields the most precise result from hadron colliders, sin(2)theta(lept)(eff) = 0.23148 +/- 0.00033. This result is consistent with, and approaches in precision, the best measurements from electron-positron colliders. The standard model inference of the on-shell electroweak mixing parameter sin(2) theta(W), or equivalently the W-boson mass M-W, using the ZFITTER software package yields sin(2) theta(W) = 0.22324 +/- 0.00033 or equivalently, M-W = 80.367 +/- 0.017 GeV/c(2).
|
|
8. |
- Bäbler, Matthäus, 1977-, et al.
(author)
-
Breakup of small aggregates in bounded and unbounded turbulent flows
- 2020
-
In: ETC 2013 - 14th European Turbulence Conference. - : Zakon Group LLC.
-
Conference paper (peer-reviewed)abstract
- Breakup of small tracer-like aggregates is studied by means of numerical simulations in four different flows, namely homogeneous isotropic turbulence, smooth stochastic flow, turbulent channel flow, and developing boundary layer flow. Aggregate breakup occurs when the local hydrodynamic stress σ ∼ ε1/2, where ε is the local energy dissipation, overcomes a given threshold value σcr [or equivalently εcr ∼ σcr2 ] characteristic for a given type of aggregates. Following the aggregate trajectory upon release and detecting the first occurrence of local energy dissipation exceeding the predefined threshold allows for estimating the breakup rate as a function of εcr. Results show that the breakup rate decreases with increasing threshold. For small values of the threshold, this decrease assumes consistent scaling among the different flows which is explained by universal small scale flow properties.
|
|
9. |
- Bäbler, Matthäus, et al.
(author)
-
Numerical simulations of aggregate breakup in bounded and unbounded turbulent flows
- 2015
-
In: Journal of Fluid Mechanics. - : Cambridge University Press (CUP). - 0022-1120 .- 1469-7645. ; 766
-
Journal article (peer-reviewed)abstract
- Breakup of small aggregates in fully developed turbulence is studied by means of direct numerical simulations in a series of typical bounded and unbounded flow configurations, such as a turbulent channel flow, a developing boundary layer and homogeneous isotropic turbulence. The simplest criterion for breakup is adopted, whereby aggregate breakup occurs when the local hydrodynamic stress sigma similar to epsilon(1/2), with epsilon being the energy dissipation at the position of the aggregate, overcomes a given threshold sigma(cr), which is characteristic for a given type of aggregate. Results show that the breakup rate decreases with increasing threshold. For small thresholds, it develops a scaling behaviour among the different flows. For high thresholds, the breakup rates show strong differences between the different flow configurations, highlighting the importance of non-universal mean-flow properties. To further assess the effects of flow inhomogeneity and turbulent fluctuations, the results are compared with those obtained in a smooth stochastic flow. Furthermore, we discuss the limitations and applicability of a set of independent proxies.
|
|
10. |
|
|