1. |
- Gao, Chuansi, et al.
(author)
-
Validation of standard ASTM F2732 and comparison with ISO 11079 with respect to comfort temperature ratings for cold protective clothing
- 2015
-
In: Applied Ergonomics. - : Elsevier BV. - 1872-9126 .- 0003-6870. ; 46:Online 17 July 2014, s. 44-53
-
Journal article (peer-reviewed)abstract
- American standard ASTM F2732 estimates the lowest environmental temperature for thermal comfort for cold weather protective clothing. International standard ISO 11079 serves the same purpose but expresses cold stress in terms of required clothing insulation for a given cold climate. The objective of this study was to validate and compare the temperature ratings using human subject tests at two levels of metabolic rates (2 and 4 MET corresponding to 116.4 and 232.8 W/m(2)). Nine young and healthy male subjects participated in the cold exposure at 3.4 and -30.6 °C. The results showed that both standards predict similar temperature ratings for an intrinsic clothing insulation of 1.89 clo and for 2 MET activity. The predicted temperature rating for 2 MET activity is consistent with test subjects' thermophysiological responses, perceived thermal sensation and thermal comfort. For 4 MET activity, however, the whole body responses were on the cold side, particularly the responses of the extremities. ASTM F2732 is also limited due to its omission and simplification of three climatic variables (air velocity, radiant temperature and relative humidity) and exposure time in the cold which are of practical importance.
|
|
2. |
- Lin, Li-Yen, et al.
(author)
-
A laboratory validation study of comfort and limit temperatures of four sleeping bags defined according to EN 13537 (2002)
- 2013
-
In: Applied Ergonomics. - : Elsevier BV. - 1872-9126 .- 0003-6870. ; 44:2, s. 321-326
-
Journal article (peer-reviewed)abstract
- In this study, we validated comfort and limit temperatures of four sleeping bags with different levels of insulation defined according to EN 13537. Six male subjects and four female subjects underwent totally 20 two-hour exposures in four sleeping bags at four intended testing temperatures: 11.2, 3.8, 2.1 and -9.0 degrees C. The subjective perceptions and physiological responses of these subjects were reported and analyzed. It was found that the EN 13537 defined comfort temperature and limit temperature were underestimated for sleeping bags MA3, HAG and MAM. The predictions are so conservative that further revision may be required to meet the requirements of both manufacturers and consumers. In contrast, for the sleeping bag MAO with a low level of insulation, the limit temperature defined by EN 13537 was slightly overestimated. In addition, two individual case studies (-28.0 and -32.0 degrees C) demonstrated that low toe temperatures were widely observed among the male and female subjects, although the mean skin temperatures were almost within the thermoneutrality range (32.0-34.0 degrees C). It seems that the IREQ model (ISO 11079) overestimated both the comfort and limit temperatures of the sleeping bags. Finally, traditional sleeping bags may be required to be re-designed to provide consumers both whole body comfort as well as local thermal comfort at feet/toes or users need to be made aware of the higher need for their insulation. (C) 2012 Elsevier Ltd and The Ergonomics Society. All rights reserved.
|
|
3. |
|
|
4. |
- Wang, Faming, et al.
(author)
-
Localised boundary air layer and clothing evaporative resistances for individual body segments.
- 2012
-
In: Ergonomics. - : Informa UK Limited. - 0014-0139 .- 1366-5847. ; 55:7, s. 799-812
-
Journal article (peer-reviewed)abstract
- Evaporative resistance is an important parameter to characterise clothing thermal comfort. However, previous work has focused mainly on either total static or dynamic evaporative resistance. There is a lack of investigation of localised clothing evaporative resistance. The objective of this study was to study localised evaporative resistance using sweating thermal manikins. The individual and interaction effects of air and body movements on localised resultant evaporative resistance were examined in a strict protocol. The boundary air layer's localised evaporative resistance was investigated on nude sweating manikins at three different air velocity levels (0.18, 0.48 and 0.78 m/s) and three different walking speeds (0, 0.96 and 1.17 m/s). Similarly, localised clothing evaporative resistance was measured on sweating manikins at three different air velocities (0.13, 0.48 and 0.70 m/s) and three walking speeds (0, 0.96 and 1.17 m/s). Results showed that the wind speed has distinct effects on local body segments. In contrast, walking speed brought much more effect on the limbs, such as thigh and forearm, than on body torso, such as back and waist. In addition, the combined effect of body and air movement on localised evaporative resistance demonstrated that the walking effect has more influence on the extremities than on the torso. Therefore, localised evaporative resistance values should be provided when reporting test results in order to clearly describe clothing local moisture transfer characteristics. Practitioner Summary: Localised boundary air layer and clothing evaporative resistances are essential data for clothing design and assessment of thermal comfort. A comprehensive understanding of the effects of air and body movement on localised evaporative resistance is also necessary by both textile and apparel researchers and industry.
|
|
5. |
|
|
6. |
- Wang, Faming, et al.
(author)
-
Validation of the physiological model of sleeping bags defined in EN13537 (2002)
- 2012
-
In: ; , s. 1-4
-
Conference paper (peer-reviewed)abstract
- Abstract in UndeterminedIn this study, we validated comfort and limit temperatures of four sleeping bags with different levels of insulation defined according to EN 13537. Six male subjects and four female subjects underwent totally 20 two-hour exposures in four sleeping bags at four intended testing temperatures: 11.2, 3.8, 2.1 and -9.0 °C. The subjective perceptions and physiological responses of these subjects were reported and analysed. It was found that the EN 13537 defined comfort temperature and limit temperature were underestimated for sleeping bags MA3, HAG and MAM. The predictions are so conservative that further revision may be required to meet the requirements of both manufacturers and consumers. In contrast, for the sleeping bag MA0 with a low level of insulation, the limit temperature defined by EN 13537 was slightly overestimated. Finally, traditional sleeping bags may be required to be redesigned to provide consumers both whole body comfort as well as local thermal comfort at feet/toes or users need to be made aware of the need for their better insulation.
|
|