Wide Bandgap Semiconductor (SiC & GaN) Power Amplifiers in Different Classes

• SiC MESFETs and GaN HEMTs have an enormous potential in high-power amplifiers at microwave frequencies due to their wide bandgap features of high electric breakdown field strength, high electron saturation velocity and high operating temperature. The high power density combined with the comparably high impedance attainable by these devices also offers new possibilities for wideband power microwave systems. In this thesis, Class C switching response of SiC MESFET in TCAD and two different generations of broadband power amplifiers have been designed, fabricated and characterized. Input and output matching networks and shunt feedback topology based on microstrip and lumped components have been designed, to increase the bandwidth and to improve the stability. The first amplifier is a single stage 26-watt using a SiC MESFET covering the frequency from 200-500 MHz is designed and fabricated. Typical results at 50 V drain bias for the whole band are, 22 dB power gain, 43 dBm output power, minimum power added efficiency at P 1dB is 47 % at 200 MHz and maximum 60 % at 500 MHz and the IMD3 level at 10 dB back-off from P 1dB is below ‑45 dBc. The results at 60 V drain bias at 500 MHz are, 24.9 dB power gain, 44.15 dBm output power (26 W) and 66 % PAE.In the second phase, two power amplifiers at 0.7-1.8 GHz without feed back for SiC MESFET and with feedback for GaN HEMT are designed and fabricated (both these transistors were of 10 W). The measured maximum output power for the SiC amplifier at Vd = 48 V was 41.3 dBm (~13.7 W), with a PAE of 32 % and a power gain above 10 dB. At a drain bias of Vd= 66 V at 700 MHz the Pmax was 42.2 dBm (~16.6 W) with a PAE of 34.4 %. The measured results for GaN amplifier are; maximum output power at Vd = 48 V is 40 dBm (~10 W), with a PAE of 34 % and a power gain above 10 dB. The SiC amplifier gives better results than for GaN amplifier for the same 10 W transistor.A comparison between the physical simulations and measured device characteristics has also been carried out. A novel and efficient way to extend the physical simulations to large signal high frequency domain was developed in our group, is further extended to study the class-C switching response of the devices. By the extended technique the switching losses, power density and PAE in the dynamics of the SiC MESFET transistor at four different frequencies of 500 MHz, 1, 2 and 3 GHz during large signal operation and the source of switching losses in the device structure was investigated. The results obtained at 500 MHz are, PAE of 78.3%, a power density of 2.5 W/mm with a switching loss of 0.69 W/mm. Typical results at 3 GHz are, PAE of 53.4 %, a power density of 1.7 W/mm with a switching loss of 1.52 W/mm.

Subject headings

TEKNIK OCH TEKNOLOGIER  -- Materialteknik (hsv//swe)

ENGINEERING AND TECHNOLOGY  -- Materials Engineering (hsv//eng)

Keyword

Wide bandgap

SiC

MESFET

GaN

HEMT

Power Amplifiers

Materials science

Teknisk materialvetenskap

Publication and Content Type

vet (subject category)

lic (subject category)