Sökning: onr:"swepub:oai:DiVA.org:ltu-100670" >
Microstructural, Me...
Microstructural, Mechanical, and Electrochemical Characterization of CrMoNbTiZr High-Entropy Alloy for Biomedical Application
-
- Akinwekomi, Akeem (författare)
- Luleå tekniska universitet,Materialvetenskap,Department of Metallurgical and Materials Engineering, Federal University of Technology Akure, Akure 340252, Ondo State, Nigeria
-
- Akhtar, Farid (författare)
- Luleå tekniska universitet,Materialvetenskap
-
(creator_code:org_t)
- MDPI, 2023
- 2023
- Engelska.
-
Ingår i: Materials. - : MDPI. - 1996-1944. ; 16:15
- Relaterad länk:
-
https://doi.org/10.3...
-
visa fler...
-
https://ltu.diva-por... (primary) (Raw object)
-
https://urn.kb.se/re...
-
https://doi.org/10.3...
-
visa färre...
Abstract
Ämnesord
Stäng
- High-entropy alloys (HEA) with superior biocompatibility, high pitting resistance, minimal debris accumulation, and reduced release of metallic ions into surrounding tissues are potential replacements for traditional metallic bio-implants. A novel equiatomic HEA based on biocompatible metals, CrMoNbTiZr, was consolidated by spark plasma sintering (SPS). The relative sintered density of the alloy was about 97% of the theoretical density, indicating the suitability of the SPS technique to produce relatively dense material. The microstructure of the sintered HEA consisted of a BCC matrix and Laves phase, corresponding to the prediction of the thermodynamic CALPHAD simulation. The HEA exhibited a global Vickers microhardness of 531.5 ± 99.7 HV, while the individual BCC and Laves phases had hardness values of 364.6 ± 99.4 and 641.8 ± 63.0 HV, respectively. Its ultimate compressive and compressive yield strengths were 1235.7 ± 42.8 MPa and 1110.8 ± 78.6 MPa, respectively. The elasticity modulus of 34.9 ± 2.9 GPa of the HEA alloy was well within the range of cortical bone and significantly lower than the values reported for commonly used biomaterials made from Ti-based and Cr–Co-based alloys. In addition, the alloy exhibited good resistance to bio-corrosion in PBS and Hanks solutions. The CrMoNbTiZr HEA exhibited an average COF of 0.43 ± 0.06, characterized mainly by abrasive and adhesive wear mechanisms. The CrMoNbTiZr alloy’s mechanical, bio-corrosion, and wear resistance properties developed in this study showed a good propensity for application as a biomaterial.
Ämnesord
- TEKNIK OCH TEKNOLOGIER -- Materialteknik -- Metallurgi och metalliska material (hsv//swe)
- ENGINEERING AND TECHNOLOGY -- Materials Engineering -- Metallurgy and Metallic Materials (hsv//eng)
Nyckelord
- high-entropy alloy
- biomaterials
- CrMoNbTiZr
- powder methods
- bio-corrosion
- Materialteknik
- Engineering Materials
Publikations- och innehållstyp
- ref (ämneskategori)
- art (ämneskategori)
Hitta via bibliotek
Till lärosätets databas