SwePub
Sök i LIBRIS databas

  Extended search

onr:"swepub:oai:lup.lub.lu.se:edda1463-009d-4f53-b8a4-388aeeaa3b98"
 

Search: onr:"swepub:oai:lup.lub.lu.se:edda1463-009d-4f53-b8a4-388aeeaa3b98" > Optimisation of mem...

  • 1 of 1
  • Previous record
  • Next record
  •    To hitlist

Optimisation of membrane area and energy requirement in tubular membrane modules

Nordin, Anna-Karin (author)
Lund University,Lunds universitet,Avdelningen för kemiteknik,Institutionen för processteknik och tillämpad biovetenskap,Institutioner vid LTH,Lunds Tekniska Högskola,Division of Chemical Engineering,Department of Process and Life Science Engineering,Departments at LTH,Faculty of Engineering, LTH
Jönsson, Ann-Sofi (author)
Lund University,Lunds universitet,Avdelningen för kemiteknik,Institutionen för processteknik och tillämpad biovetenskap,Institutioner vid LTH,Lunds Tekniska Högskola,Division of Chemical Engineering,Department of Process and Life Science Engineering,Departments at LTH,Faculty of Engineering, LTH
 (creator_code:org_t)
Elsevier BV, 2006
2006
English.
In: Desalination. - : Elsevier BV. - 1873-4464 .- 0011-9164. ; 199:1-3, s. 94-95
  • Journal article (peer-reviewed)
Abstract Subject headings
Close  
  • During ultrafiltration (UF), the driving force along the membrane is diminished due to concentration increase and frictional pressure drop. In most applications of ultrafiltration the influence of the frictional pressure drop is negligible. However, when treating concentrated, viscous liquids the frictional pressure drop can reduce the transmembrane pressure (TMP) significantly. The influence of cross-flow velocity and inlet pressure on flux and frictional pressure drop during concentration of retentate from the Stora Enso Nymölla pulp and paper mill ultrafiltration plant treating hardwood bleach plant effluent was studied in this work. The experimental data were used in a calculation tool to investigate the membrane area and energy requirement of two module design alternatives during concentration of the retentate in an additional stage. The first alternative is the same module design as in the existing plant on the hardwood line at Nymölla, where the tubular membranes in a module are connected in series. In the second alternative, the membrane tubes in a module were instead connected in parallel. The experimental flux increased markedly with increasing pressure and cross-flow velocity at all concentrations. However, the flux was significantly reduced when the chemical oxygen demand (COD) was increased. The flux was 120 l/m2 h at 180 g/l and 23 l/m2 h at 330 g/l (at 1.0 MPa and 4 m/s). The concentration was 180 and 330 g/l at volume reduction factor (VRF) 1 and 2. The calculated average flux was significantly higher in the design with membrane tubes in parallel. In addition, the flux was not only higher, but it also increased with increasing cross-flow velocity, whereas the flux in the design with membrane tubes in series reached a maximum flux at about 3 m/s.

Subject headings

TEKNIK OCH TEKNOLOGIER  -- Kemiteknik (hsv//swe)
ENGINEERING AND TECHNOLOGY  -- Chemical Engineering (hsv//eng)

Keyword

Ultrafiltration
Bleach plant effluent
Energy requirement
Tubular membranes

Publication and Content Type

art (subject category)
ref (subject category)

Find in a library

To the university's database

  • 1 of 1
  • Previous record
  • Next record
  •    To hitlist

Find more in SwePub

By the author/editor
Nordin, Anna-Kar ...
Jönsson, Ann-Sof ...
About the subject
ENGINEERING AND TECHNOLOGY
ENGINEERING AND ...
and Chemical Enginee ...
Articles in the publication
Desalination
By the university
Lund University

Search outside SwePub

Kungliga biblioteket hanterar dina personuppgifter i enlighet med EU:s dataskyddsförordning (2018), GDPR. Läs mer om hur det funkar här.
Så här hanterar KB dina uppgifter vid användning av denna tjänst.

 
pil uppåt Close

Copy and save the link in order to return to this view