Modelling of High Power SOI Vertical DMOS Transistors and Flip-chip Packages

• Part I: Vertical DMOS Transistors System level integration is a major trend in the electronic industry at the moment. For automotive applications in particular it is desirable to integrate CMOS logic circuits and different types of power devices. One of the methods to separate these devices from each other is by having a Silicon-on-Insulator (SOI) material providing dielectric isolation between high and low voltage parts. An important question is related to the performance of these dielectrically isolated devices. High power vertical DMOS transistors (VDMOSFETs) on SOI are demonstrated with a CMOS compatible fabrication process. A large number of defects are created in the structure if the trench formation is performed prior to the device fabrication. The defect generation has been reduced signicantly by moving the trench formation towards the end of fabrication steps. In this way the trenches are not exposed to high temperatures. Our measurements of the fabricated SOI VDMOSFETs in the static region are in good agreement with the expected impact of the self-heating simulations on the saturation behaviour. Looking into details the carrier dynamics during the Unclamped Inductive Switching test can easily reveal the potential of having the parasitic bipolar transistors turned on. Furthermore high-temperature measurements point out that the parasitic BJT effect is activated. Switching simulations show that the substrate and oxide capacitors provide a second path for the current to flow during the discharging of the inductor. It can happen that the maximum current through the SOI device is separated in time from the maximum voltage across the device, thereby reducing the maximum power. Part II: Finite Element Calculations of Flip-chip Joints Flip-chip joining using anisotropically conductive adhesive (ACA) has become a very attractive technique for electronics packaging. In this work, the strain development during the thermal cycling test of ip-chip joining with different bump heights was studied. The effect of bump height is signicant in the interface between the bumps and the pads. Our calculations show that there is practically no effect of the bump height on the strain variation in the bumps and in the pads.

Subject headings

TEKNIK OCH TEKNOLOGIER  -- Elektroteknik och elektronik (hsv//swe)

ENGINEERING AND TECHNOLOGY  -- Electrical Engineering, Electronic Engineering, Information Engineering (hsv//eng)

Keyword

Conductive Adhesive

self-heating

Unclamped Inductive Switching

ACA

vertical DMOS

integration

Flip-chip

UIS

SOI

Publication and Content Type

dok (subject category)

vet (subject category)