Sökning: onr:"swepub:oai:DiVA.org:kth-23085" >
Modeling the in-fli...
Modeling the in-flight events during metal spray forming
-
- Tinoco, José (författare)
- KTH,Metallernas gjutning
-
- Widell, Björn (författare)
- KTH,Metallernas gjutning
-
- Fredriksson, Hasse (författare)
- KTH,Metallernas gjutning
-
visa fler...
-
- Fuchs, Laszlo (författare)
- Lund University,Lunds universitet,Strömningsteknik,Institutionen för energivetenskaper,Institutioner vid LTH,Lunds Tekniska Högskola,Fluid Mechanics,Department of Energy Sciences,Departments at LTH,Faculty of Engineering, LTH
-
visa färre...
-
(creator_code:org_t)
- Elsevier BV, 2004
- 2004
- Engelska.
-
Ingår i: Materials Science & Engineering. - : Elsevier BV. - 0921-5093 .- 1873-4936. ; 365:1-2, s. 302-310
- Relaterad länk:
-
http://dx.doi.org/10...
-
visa fler...
-
https://urn.kb.se/re...
-
https://doi.org/10.1...
-
https://lup.lub.lu.s...
-
visa färre...
Abstract
Ämnesord
Stäng
- In this work, the in-flight events occurring during deposition over a rotating substrate were modeled. The calculations were performed by solving the momentum and enthalpy equations for the gas. A Lagrangian approach was used to obtain the trajectories and thermal history of the droplets. A modified heat capacity model was used to simulate the release of latent heat due to the solidification of the droplets. Turbulent particle dispersion was not considered. The results showed that the droplet temperature strongly depends on the droplet diameter and on its location in the spray since the relative velocity between the gas and the droplets varies largely depending on the location. An estimation of the state of the spray is presented in terms of mass and thermal averages. The results showed that the average fraction of solid obtained in the spray depends on the initial conditions, such as gas temperature and particle size distribution parameters.
Ämnesord
- TEKNIK OCH TEKNOLOGIER -- Materialteknik (hsv//swe)
- ENGINEERING AND TECHNOLOGY -- Materials Engineering (hsv//eng)
- TEKNIK OCH TEKNOLOGIER -- Maskinteknik -- Strömningsmekanik och akustik (hsv//swe)
- ENGINEERING AND TECHNOLOGY -- Mechanical Engineering -- Fluid Mechanics and Acoustics (hsv//eng)
Nyckelord
- CFD
- spray casting
- droplet solidification
- average solid fraction
- temperature
- behavior
- droplet solidification
- CFD
- spray casting
- average solid fraction
Publikations- och innehållstyp
- ref (ämneskategori)
- art (ämneskategori)
Hitta via bibliotek
Till lärosätets databas