1. |
- Baveja, P. P., et al.
(författare)
-
Impact of photon lifetime on thermal rollover in 850-nm high-speed VCSELs
- 2012
-
Ingår i: Proceedings of SPIE - The International Society for Optical Engineering. - : SPIE. - 0277-786X .- 1996-756X. - 9780819489197 ; 8276
-
Konferensbidrag (refereegranskat)abstract
- We present an empirical thermal model for VCSELs based on extraction of temperature dependence of macroscopic VCSEL parameters from CW measurements. We apply our model to two, oxide-confined, 850-nm VCSELs, fabricated with a 9-mu m inner-aperture diameter and optimized for high-speed operation. We demonstrate that for both these devices, the power dissipation due to linear heat sources dominates the total self-heating. We further show that reducing photon lifetime down to 2 ps drastically reduces absorption heating and improves device static performance by delaying the onset of thermal rollover. The new thermal model can identify the mechanisms limiting the thermal performance and help in formulating the design strategies to ameliorate them.
|
|
2. |
- Davani, Hooman A., et al.
(författare)
-
Polarization investigation of a tunable high-speed short-wavelength bulk-micromachined MEMS-VCSEL
- 2012
-
Ingår i: Proceedings of SPIE - The International Society for Optical Engineering. - : SPIE. - 0277-786X .- 1996-756X. - 9780819489197 ; 8276, s. Art. no. 82760T-
-
Konferensbidrag (refereegranskat)abstract
- We report the investigation of the state of polarization (SOP) of a tunable vertical-cavity surface-emitting laser (VCSEL) operating near 850 nm with a mode-hop free single-mode tuning range of about 12 nm and an amplitude modulation bandwidth of about 5 GHz. In addition, the effect of a sub-wavelength grating on the device and its influence on the polarization stability and polarization switching has been investigated. The VCSEL with an integrated sub-wavelength grating shows a stable SOP with a polarization mode suppression ratio (PMSR) more than 35 dB during the tuning.
|
|
3. |
- Haglund, Erik, 1985, et al.
(författare)
-
Reducing the spectral width of high speed oxide confined VCSELs using an integrated mode filter
- 2012
-
Ingår i: Proceedings of SPIE - The International Society for Optical Engineering. - : SPIE. - 0277-786X .- 1996-756X. - 9780819489197 ; 8276, s. Article Number: 82760L-
-
Konferensbidrag (refereegranskat)abstract
- We have reduced the spectral width of high speed oxide confined 850 nm VCSELs using a shallow surface relief for suppression of higher order transverse modes. The surface relief acts as a mode filter by introducing a spatially varying and therefore mode selective loss. The VCSEL employs multiple oxide layers for reduced capacitance which leads to a strong index guiding and a large spectral width in the absence of a mode filter. With an appropriate choice of surface relief parameters, the RMS spectral width for a 5 jam oxide aperture VCSEL is reduced from 0.6 to 0.3 nm. The small signal modulation bandwidth is 19 GHz. Due to reduced effects of chromatic and modal fiber dispersion, the maximum error-free (bit-error-rate
|
|
4. |
- Kögel, Benjamin, 1979, et al.
(författare)
-
Integrated MEMS-tunable VCSELs for reconfigurable optical interconnects
- 2012
-
Ingår i: Proceedings of SPIE - The International Society for Optical Engineering. - : SPIE. - 0277-786X .- 1996-756X. - 9780819489197 ; 8276, s. Article Number: 82760Q-
-
Konferensbidrag (refereegranskat)abstract
- A simple and low-cost technology for tunable vertical-cavity surface-emitting lasers (VCSELs) with curved movable micromirror is presented. The micro-electro-mechanical system (MEMS) is integrated with the active optical component (so-called half-VCSEL) by means of surface-micromachining, using a reflown photoresist droplet as sacrificial layer. The technology is demonstrated for electrically pumped, short-wavelength (850nm) tunable VCSEts. Fabricated devices with 10 mu m oxide aperture are singlemode with sidemode suppression >35 dB, tunable over 24 mit with output power up to 0.5 mW, and have a beam divergence angle
|
|
5. |
- Larsson, Anders, 1957, et al.
(författare)
-
High-speed tunable and fixed-wavelength VCSELs for short-reach optical links and interconnects
- 2012
-
Ingår i: Proceedings of SPIE - The International Society for Optical Engineering. - : SPIE. - 0277-786X .- 1996-756X. - 9780819489197 ; 8276, s. Article Number: 82760H-
-
Konferensbidrag (refereegranskat)abstract
- This paper presents a review of recent work on high speed tunable and fixed wavelength vertical cavity surface emitting lasers (VCSELs) at Chalmers University of Technology. All VCSELs are GaAs-based, employ an oxide aperture for current and/or optical confinement, and emit around 850 nm. With proper active region and cavity designs, and techniques for reducing capacitance and thermal impedance, our fixed wavelength VCSELs have reached a modulation bandwidth of 23 GHz, which has enabled error-free 40 Gbps back-to-back transmission and 35 Gbps transmission over 100 m of multimode fiber. A MEMS-technology for wafer scale integration of tunable high speed VCSELs has also been developed. A tuning range of 24 nm and a modulation bandwidth of 6 GHz have been achieved, enabling error-free back-to-back transmission at 5 Gbps.
|
|
6. |
- Abrahamsson, Christoffer, et al.
(författare)
-
Scatter correction of transmission NIR spectra by photon migration data - Quantitative analysis of solids
- 2005
-
Ingår i: Proceedings of SPIE - The International Society for Optical Engineering. - : SPIE. - 1996-756X .- 0277-786X. ; 6009, s. 60090-60090
-
Konferensbidrag (refereegranskat)abstract
- The scope of this presentation is a new methodology to correct conventional NIR data for scattering effects. The technique aims at measuring the absorption coefficient of the samples rather than the total attenuation, measured by conventional NIR spectroscopy. The main advantage of this is that the absorption coefficient is independent of the path length of the light inside the sample, and therefore independent of the scattering effects. The measurements in this work were made using a novel system for time-resolved measurements, based on short light continuum pulses generated in an index-guided crystal fibre and a spectrometer-equipped streak camera. The system enables spectral recordings in the wavelength range 500 - 1200 nm with a spectral resolution of 5 nm and a temporal resolution of 30 ps. The evaluation scheme is based on modeling of light transport by diffusion theory, that provides an independent measure of the scattering properties of the samples, that later is used to correct conventional NIR data. This yields a clear advantage over other pre-processing techniques, where scattering effects are estimated and corrected for by using the shape of the measured spectrum only. PLS calibration models shows that, by using the proposed evaluation scheme, the predictive ability is improved by 50% as compared to models based on conventional NIR data. The method also makes it possible to predict the concentration of active substance in samples with physical properties different from those of the samples included in the calibration model.
|
|
7. |
- Achilles, Silvio, et al.
(författare)
-
GPU-Accelerated Coupled Ptychographic Tomography
- 2022
-
Ingår i: Developments in X-Ray Tomography XIV. - : SPIE. - 1996-756X .- 0277-786X. - 9781510654686 ; 12242
-
Konferensbidrag (refereegranskat)abstract
- Scanning coherent X-ray microscopy (ptychography) has gained considerable interest during the last decade since the performance of this indirect imaging technique does not necessarily rely on the quality of the X-ray optics and, in principle, can achieve highest spatial resolution in X-ray imaging. The method can be easily extended to 3D by adding standard tomographic reconstruction schemes. However, the tomographic reconstruction is often applied in a subsequent step using a sequence of aligned ptychographic 2D projections. In this contribution, we outline current developments of a GPU-accelerated framework for direct 3D ptychography, coupling 2D ptychography and tomography. The program utilizes a custom GPU-accelerated framework for ptychography that offers three distinct ptychographic reconstruction algorithms. The tomographic reconstruction runs simultaneously and uses numerical routines of the ASTRA Toolbox. This parallel-computing approach results in a high performance increase considerably reducing the reconstruction time of 3D ptychographic datasets.
|
|
8. |
- Adler, Alexandre, et al.
(författare)
-
Modelling ground pickup for microwave telescopes
- 2022
-
Ingår i: Proceedings of SPIE, the International Society for Optical Engineering. - : SPIE. - 0277-786X .- 1996-756X. ; 12190
-
Tidskriftsartikel (refereegranskat)abstract
- Microwave telescopes require an ever-increasing control of experimental systematics in their quest to measure the Cosmic Microwave Background (CMB) to exquisite levels of precision. One important systematic for ground and balloon-borne experiments is ground pickup, where beam sidelobes detect the thermal emission of the much warmer ground while the main beam is scanning the sky. This generates scan-synchronous noise in experiment timestreams, which is difficult to filter out without also deleting some of the signal from the sky. Therefore, efficient modelling of pickup can help guide the design of experiments and of analysis pipelines. In this work, we present an extension to the BEAMCONV algorithm that enables us to generate time-ordered data (TOD) from beam-convolved sky and ground maps simultaneously. We simulate ground pickup for both a ground-based experiment and a telescope attached to a stratospheric balloon. Ground templates for the balloon experiment are obtained by re-projecting satellite maps of the Earth's microwave emission.
|
|
9. |
- Afanasiev, Sergey V., et al.
(författare)
-
Experimental apparatus to study crystal channeling in an external SPS beamline
- 2007
-
Ingår i: Proceedings of SPIE, the International Society for Optical Engineering. - : SPIE. - 0277-786X .- 1996-756X. ; 6634
-
Tidskriftsartikel (refereegranskat)abstract
- For the new generation of high intensity hadronic machines as, for instance, LHC, halo collimation is a necessary issue for the accelerator to operate at the highest possible luminosity and to prevent the damage of superconductor magnets.1 We propose an experiment aimed to systematic study of the channeling phenomenology and of the newly observed "volume reflection" effect. This experiment will be performed for an external SPS beamline and will make use of a primary proton beam with 400 GeV/c momentum and very small (∼ 3 μrad) divergence. The advantage of a proposed experiment is precise tracking of particles that interacted with a crystal, so that to determine the single-pass efficiency for all the processes involved. For this purpose, a telescope equipped with high-resolution silicon microstrip detectors will be used. New generation silicon crystals and an extra-precise goniometer are mandatory issues. Main goal of the experiment is to get the precise information on channeling of relativistic particles and, ultimately, on the feasibility of such technique for halo collimation at LHC. In this contribution we review the status of the setting-up of experimental apparatus and its future development in sight of the planned run in September 2006.
|
|
10. |
- Alexander, Naomi E., et al.
(författare)
-
IMAGINE project : A low cost, high performance, monolithic passive mm-wave imager front-end
- 2012
-
Ingår i: Proceedings of SPIE - The International Society for Optical Engineering. - : SPIE. - 0277-786X .- 1996-756X. - 9780819492852
-
Konferensbidrag (refereegranskat)abstract
- The FP7 Research for SME project IMAGINE - a low cost, high performance monolithic passive mm-wave imager front-end is described in this paper. The main innovation areas for the project are: i) the development of a 94 GHz radiometer chipset and matching circuits suitable for monolithic integration. The chipset consists of a W-band low noise amplifier, fabricated using the commercially available OMMIC D007IH GaAs mHEMT process, and a zero bias resonant interband tunneling diode, fabricated using a patented epi-layer structure that is lattice matched to the same D007IH process; ii) the development of a 94 GHz antenna adapted for low cost manufacturing methods with performance suitable for real-time imaging; iii) the development of a low cost liquid crystal polymer PCB build-up technology with performance suitable for the integration and assembly of a 94 GHz radiometer module; iv) the assembly of technology demonstrator modules. The results achieved in these areas are presented.
|
|