| 1. |
|
|
| 2. |
- Abate, E., et al.
(författare)
-
Combined performance tests before installation of the ATLAS Semiconductor and Transition Radiation Tracking Detectors
- 2008
-
Ingår i: Journal of Instrumentation. - 1748-0221. ; 3
-
Tidskriftsartikel (refereegranskat)abstract
- The ATLAS (A Toroidal LHC ApparatuS) Inner Detector provides charged particle tracking in the centre of the ATLAS experiment at the Large Hadron Collider (LHC). The Inner Detector consists of three subdetectors: the Pixel Detector, the Semiconductor Tracker (SCT), and the Transition Radiation Tracker (TRT). This paper summarizes the tests that were carried out at the final stage of SCT+TRT integration prior to their installation in ATLAS. The combined operation and performance of the SCT and TRT barrel and endcap detectors was investigated through a series of noise tests, and by recording the tracks of cosmic rays. This was a crucial test of hardware and software of the combined tracker detector systems. The results of noise and cross-talk tests on the SCT and TRT in their final assembled configuration, using final readout and supply hardware and software, are reported. The reconstruction and analysis of the recorded cosmic tracks allowed testing of the offline analysis chain and verification of basic tracker performance parameters, such as efficiency and spatial resolution, in combined operation before installation.
|
|
| 3. |
-
- 2019
-
Tidskriftsartikel (refereegranskat)
|
|
| 4. |
- Abdesselam, A., et al.
(författare)
-
Engineering for the ATLAS SemiConductor Tracker (SCT) end-cap
- 2008
-
Ingår i: Journal of Instrumentation. - 1748-0221. ; 3
-
Tidskriftsartikel (refereegranskat)abstract
- The ATLAS SemiConductor Tracker (SCT) is a silicon-strip tracking detector which forms part of the ATLAS inner detector. The SCT is designed to track charged particles produced in proton-proton collisions at the Large Hadron Collider (LHC) at CERN at an energy of 14 TeV. The tracker is made up of a central barrel and two identical end-caps. The barrel contains 2112 silicon modules, while each end-cap contains 988 modules. The overall tracking performance depends not only on the intrinsic measurement precision of the modules but also on the characteristics of the whole assembly, in particular, the stability and the total material budget. This paper describes the engineering design and construction of the SCT end-caps, which are required to support mechanically the silicon modules, supply services to them and provide a suitable environment within the inner detector. Critical engineering choices are highlighted and innovative solutions are presented - these will be of interest to other builders of large-scale tracking detectors. The SCT end-caps will be fully connected at the start of 2008. Further commissioning will continue, to be ready for proton-proton collision data in 2008.
|
|
| 5. |
- Abdesselam, A., et al.
(författare)
-
The ATLAS semiconductor tracker end-cap module
- 2007
-
Ingår i: Nuclear Instruments and Methods in Physics Research Section A. - : Elsevier BV. - 0168-9002 .- 1872-9576. ; 575:3, s. 353-389
-
Tidskriftsartikel (refereegranskat)abstract
- The challenges for the tracking detector systems at the LHC are unprecedented in terms of the number of channels, the required read-out speed and the expected radiation levels. The ATLAS Semiconductor Tracker. (SCT) end-caps have a total of about 3 million electronics channels each reading out every 25 ns into its own on-chip 3.3 mu s buffer. The highest anticipated dose after 10 years operation is 1.4x10(14) cm(-2) in units of 1 MeV neutron equivalent (assuming the damage factors scale with the non-ionising energy loss). The forward tracker has 1976 double-sided modules, mostly of area similar to 70 cm(2), each having 2 x 768 strips read out by six ASICs per side. The requirement to achieve an average perpendicular radiation length of 1.5% X-0, while coping with up to 7 W dissipation per module (after irradiation), leads to stringent constraints on the thermal design. The additional requirement of 1500e(-) equivalent noise charge (ENC) rising to only 1800e(-) ENC after irradiation, provides stringent design constraints on both the high-density Cu/Polyimide flex read-out circuit and the ABCD3TA read-out ASICs. Finally, the accuracy of module assembly must not compromise the 16 mu m (r phi) resolution perpendicular to the strip directions or 580 mu m radial resolution coming from the 40 mrad front-back stereo angle. A total of 2210 modules were built to the tight tolerances and specifications required for the SCT. This was 234 more than the 1976 required and represents a yield of 93%. The component flow was at times tight, but the module production rate of 40-50 per week was maintained despite this. The distributed production was not found to be a major logistical problem and it allowed additional flexibility to take advantage of where the effort was available, including any spare capacity, for building the end-cap modules. The collaboration that produced the ATLAS SCT end-cap modules kept in close contact at all times so that the effects of shortages or stoppages at different sites could be rapidly resolved.
|
|
| 6. |
- Abdesselam, A., et al.
(författare)
-
The barrel modules of the ATLAS semiconductor tracker
- 2006
-
Ingår i: Nuclear Instruments and Methods in Physics Research Section A. - : Elsevier BV. - 0168-9002 .- 1872-9576. ; 568:2, s. 642-671
-
Tidskriftsartikel (refereegranskat)abstract
- This paper describes the silicon microstrip modules in the barrel section of the SemiConductor Tracker (SCT) of the ATLAS experiment at the CERN Large Hadron Collider (LHC). The module requirements, components and assembly techniques are given, as well as first results of the module performance on the fully assembled barrels that make up the detector being installed in the ATLAS experiment.
|
|
| 7. |
- Abt, I, et al.
(författare)
-
Inclusive V-0 production cross sections from 920 GeV fixed target proton-nucleus collisions
- 2003
-
Ingår i: European Physical Journal C. Particles and Fields. - : Springer Science and Business Media LLC. - 1434-6044. ; 29:2, s. 181-190
-
Tidskriftsartikel (refereegranskat)abstract
- Inclusive differential cross sections dsigma(pA)/dx(F) and dsigma(pA)/dp(t)(2) for the production of K-S(0), Lambda, and (&ULambda;) over bar particles are measured at HERA in proton-induced reactions on C, Al, Ti, and W targets. The incident beam energy is 920 GeV, corresponding to roots = 41.6 GeV in the proton-nucleon system. The ratios of differential cross sections dsigma(pA)(K-S(0))/dsigma(pA)(Lambda) and dsigma(pA)((&ULambda;) over bar)/dsigma(pA) (Lambda) are measured to be 6.2 +/- 0.5 and 0.66 +/- 0.07, respectively, for x(F) approximate to -0.06. No significant dependence upon the target material is observed. Within errors, the slopes of the transverse momentum distributions da,Ald t also show no significant dependence upon the target material. The dependence of the extrapolated total cross sections sigma(pA) on the atomic mass A of the target material is discussed, and the deduced cross sections per nucleon sigma(pN) are compared with results obtained at other energies.
|
|
| 8. |
- Abt, I, et al.
(författare)
-
Measurement of the b(b)over-bar production cross section in 920 GeV fixed-target proton-nucleus collisions
- 2003
-
Ingår i: European Physical Journal C. Particles and Fields. - : Springer Science and Business Media LLC. - 1434-6044. ; 26:3, s. 345-355
-
Tidskriftsartikel (refereegranskat)abstract
- Using the HERA-B detector, the b (b) over bar production cross section has been measured in 920 GeV proton collisions on carbon and titanium targets. The b (b) over bar production was tagged via inclusive bottom quark decays into J/psi by exploiting the longitudinal separation of J/psi --> l(+)l(-) decay vertices from the primary proton-nucleus interaction. Both e(+)e(-) and mu(+)mu(-) channels have been reconstructed and the combined analysis yields the cross section sigma(b (b) over bar) = 32(-12)(+14)(stat) (+6)(-7)(sys) nb/nucleon.
|
|
| 9. |
- Wheeler, H, et al.
(författare)
-
The need for transformative changes in the use of Indigenous knowledge along with science for environmental decision‐making in the Arctic
- 2020
-
Ingår i: People and Nature. - : John Wiley & Sons. - 2575-8314. ; 2:3, s. 544-556
-
Tidskriftsartikel (refereegranskat)abstract
- 1. Recent attention to the role of Indigenous knowledge (IK) in environmental monitoring, research and decision‐making is likely to attract new people to this field of work.2. Advancing the bringing together of IK and science in a way that is desirable to IK holders can lead to successful and inclusive research and decision‐making.3. We used the Delphi technique with 18 expert participants who were IK holders or working closely with IK from across the Arctic to examine the drivers of progress and limitations to the use of IK along with science to inform decision‐making related to wildlife, reindeer herding and the environment. We also used this technique to identify participants' experiences of scientists' misconceptions concerning IK.4. Participants had a strong focus on transformative change relating to the structure of institutions, politics, rights, involvement, power and agency over technical issues advancing or limiting progress (e.g. new technologies and language barriers).5. Participants identified two modes of desirable research: coproducing knowledge with scientists and autonomous Indigenous‐led research. They highlighted the need for more collaborative and coproduction projects to allow further refinement of approaches and more funding to support autonomous, Indigenous‐led research.6. Most misconceptions held by scientists concerning IK that were identified by participants related to the spatial, temporal and conceptual scope of IK, and the perceived need to validate IK using Western science.7. Our research highlights some of the issues that need to be addressed by all participants in research and decision‐making involving IK and science. While exact approaches will need to be tailored to specific social‐ecological contexts, consideration of these broader concerns revealed by our analysis are likely to be central to effective partnerships.
|
|
| 10. |
- Balieva, F. N., et al.
(författare)
-
Treatment Preferences in Young Adults with Moderate to Severe Psoriasis: A Qualitative Study from the Nordic Countries
- 2023
-
Ingår i: Dermatology and Therapy. - 2193-8210. ; 13:8, s. 1873-1887
-
Tidskriftsartikel (refereegranskat)abstract
- IntroductionThe purpose of this study is to explore treatment preferences and identify patient characteristics in young bio-naive adults with moderate to severe psoriasis in the Nordic countries (Norway, Finland, Sweden, and Denmark).MethodsPatients were 18-45 years old and bio-naive but referred for biologic treatment of moderate to severe psoriasis. Patients were included at eight Nordic dermatology clinics. Patients with significant comorbidity or psoriatic arthritis were excluded. The Psoriasis Area and Severity Index (PASI) and Dermatology Life Quality Index (DLQI) were assessed along with basic patient information.A semistructured interview guide was used in individual qualitative interviews, asking patients about their treatment preferences and reasons, disease journey, and disease management. The interviews were analyzed using thematic content analysis. Twenty-four patients sufficed to reach saturation in this qualitative study.ResultsThe patient sample characteristics represented a qualitative variation in age, sex, symptoms, duration of disease, and country. We included a total of 12 male and 12 female patients. The mean age was 34 years (range 18-45 years), the mean age at diagnosis was 20 years (range 6-34 years), the mean & PLUSMN; standard deviation (SD) time since diagnosis was 13 & PLUSMN; 8 years, PASI was 9.5 & PLUSMN; 4.7, and DLQI was 15.2 & PLUSMN; 6.4.Interviews suggested that both the burden of disease as well as the burden of treatment influenced patient preferences regarding treatment attributes, hence getting alleviation from symptoms did not alone influence patient preferences. Time, effort, and inconvenience related to psoriasis treatments also influenced patient preferences.ConclusionsThis first in-depth, qualitative study in young bio-naive adults with psoriasis suggests that patient preferences are focusing not only on symptom relief but also on alleviating the burden of psoriasis treatment. Understanding the reasons for patient preferences and the perspectives of young adults is needed to guide individual shared decision-making in psoriasis management. Plain Language SummaryNot much research has been done on understanding the disease burden and treatment needs of young adults suffering from psoriasis. This is an interview study with young adults from Nordic countries suffering from moderate to severe psoriasis with an active lifestyle. The adult patients were all referred for biologic treatment of psoriasis but had not yet started treatment when they were interviewed. The aim was to explore treatment preferences in this group.The study showed that treatment goals depended upon both alleviation of symptoms and obtaining a low treatment burden. The most influential symptoms were scaling, itching, and visible plaques. The most important treatment burden features were efficacy, durability, speed of response, safety, and convenience. Understanding the reasons behind these different treatment preferences is essential to help shared-decision psoriasis management that matches individual needs.
|
|
