| 1. |
- Alvebratt, Caroline, et al.
(author)
-
In Vitro Performance and Chemical Stability of Lipid-Based Formulations Encapsulated in a Mesoporous Magnesium Carbonate Carrier
- 2020
-
In: Pharmaceutics. - : MDPI AG. - 1999-4923. ; 12:5
-
Journal article (peer-reviewed)abstract
- Lipid-based formulations can circumvent the low aqueous solubility of problematic drug compounds and increase their oral absorption. As these formulations are often physically unstable and costly to manufacture, solidification has been suggested as a way to minimize these issues. This study evaluated the physicochemical stability and in vitro performance of lipid-loaded mesoporous magnesium carbonate (MMC) particles with an average pore size of 20 nm. A medium chain lipid was loaded onto the MMC carrier via physical adsorption. A modified in vitro lipolysis setup was then used to study lipid release and digestion with 1H nuclear magnetic resonance spectroscopy. The lipid loading efficiency with different solidification techniques was also evaluated. The MMC, unlike more commonly used porous silicate carriers, dissolved during the lipolysis assay, providing a rapid release of encapsulated lipids into solution. The digestion of the dispersed lipid-loaded MMC therefore resembled that of a coarse dispersion of the lipid. The stability data demonstrated minor degradation of the lipid within the pores of the MMC particles, but storage for three months did not reveal extensive degradation. To conclude, lipids can be adsorbed onto MMC, creating a solid powder from which the lipid is readily released into the solution during in vitro digestion. The chemical stability of the formulation does however merit further attention.
|
|
| 2. |
- Dening, Tahnee J., et al.
(author)
-
Improving Correlations Between Drug Solubilization and In Vitro Lipolysis by Monitoring the Phase Partitioning of Lipolytic Species for Lipid-Based Formulations
- 2019
-
In: Journal of Pharmaceutical Sciences. - : Elsevier BV. - 1520-6017 .- 0022-3549. ; 108:1, s. 295-304
-
Journal article (peer-reviewed)abstract
- Solution proton nuclear magnetic resonance analysis was used in conjunction with in vitro lipolysis to elucidate the time-dependent speciation and release of lipolytic products during the digestion of lipid-loaded inorganic particles, allowing correlations to be made between the phase partitioning of lipolytic products and an encapsulated poorly soluble drug. Silicon dioxide, montmorillonite, and laponite were used to encapsulate medium chain triglycerides into solid-state lipid-based formulations (LBFs), and coumarin 102 was selected as a model poorly soluble compound. The specific inorganic carrier material used to encapsulate medium chain triglycerides significantly impacted the release and partitioning of the solubilizing lipolytic products, that is, diglycerides, monoglycerides, and fatty acids. A strong linear correlation was obtained between drug solubilization and fatty acid release to the aqueous phase (R2 = 0.996), indicating fatty acids to be the most important lipid species for enabling solubilization and potential drug absorption in vivo. This method was developed to improve upon the use of pH-stat titration for characterizing LBF digestion during in vitro lipolysis studies and is demonstrated herein to provide useful insights into how the selected inorganic carrier material impacts LBF performance when solid-state LBF powders are fabricated via adsorption.
|
|
| 3. |
- Dening, Tahnee J., et al.
(author)
-
Inorganic surface chemistry and nanostructure controls lipolytic product speciation and partitioning during the digestion of inorganic-lipid hybrid particles
- 2018
-
In: Journal of Colloid and Interface Science. - : Elsevier BV. - 1095-7103 .- 0021-9797. ; 532, s. 666-679
-
Journal article (peer-reviewed)abstract
- Hypothesis: Solid-state lipid formulations, whereby liquid lipids are encapsulated in inorganic particle matrices, have attracted significant interest for drug/nutrient delivery in recent years. We hypothesized that the surface chemistry of the inorganic material used to encapsulate lipids impacts the lipase-mediated digestion and partitioning of lipolytic species between the solubilized aqueous and insoluble pellet phases. Experiments: Medium chain triglycerides were spray dried with silica nanoparticles, montmorillonite or laponite platelets to form inorganic-lipid hybrid particles. In vitro lipolysis studies were conducted under gastric (pH 1.6) and intestinal (pH 7.5) conditions, and the speciation and partitioning of lipolytic products between the aqueous and pellet phases was characterized using solution-state proton nuclear magnetic resonance and fourier transform infrared spectroscopy. Findings: Under gastric conditions, greater than 80% of all lipid species remained adsorbed within each lipolysis pellet after 60 min. Approximately 40%, 50–60% and 80–90% of all lipid species were adsorbed from solution by silica-, montmorillonite- and laponite-based particle matrices during intestinal lipolysis. Monoglycerides were preferentially adsorbed by silica, whereas triglycerides and fatty acids were adsorbed by montmorillonite and laponite. Adsorption of lipolytic products from solution is expected to impact significantly on drug/nutrient solubilization and absorption in vivo. To the best of our knowledge, this is the first report characterizing the speciation and phase behavior of lipolytic products released from solid-state lipid formulations during in vitro lipolysis studies.
|
|
| 4. |
- Dening, Tahnee J., et al.
(author)
-
Spray Dried Smectite Clay Particles as a Novel Treatment against Obesity
- 2019
-
In: Pharmaceutical Research. - : Springer Science and Business Media LLC. - 1573-904X .- 0724-8741. ; 36:1
-
Journal article (peer-reviewed)abstract
- Purpose: To explore the feasibility of spray dried smectite clay particles fabricated from montmorillonite or laponite materials for adsorbing dietary lipids and reducing rodent weight gain in vivo. Methods: Spray dried montmorillonite (SD-MMT) and spray dried laponite (SD-LAP) particles were prepared via spray drying. Particle morphology, surface area and redispersion/aggregation properties in aqueous media were characterized. The ability of SD-MMT and SD-LAP particles to inhibit lipid digestion kinetics and adsorb lipid species from solution was assessed during in vitro lipolysis using proton nuclear magnetic resonance analysis. SD-MMT and SD-LAP particles were dosed to rodents fed a high-fat diet and their effect on body weight gain was evaluated. Results: Both SD-MMT and SD-LAP particles adsorbed significant quantities of medium chain triglycerides and lipolytic products from solution during in vitro lipolysis. At a concentration of 50% w/w relative to lipid content, SD-MMT and SD-LAP particles adsorbed 42% and 94% of all lipid species, respectively. SD-MMT and SD-LAP particles also reduced the extent of rodent weight gain relative to the negative control treatment group and performed similarly to orlistat via an alternate mechanism of action. Conclusions: Spray dried smectite clay particles (SD-MMT and SD-LAP) with significant adsorptive capacities for dietary lipids and digestion products were successfully fabricated. These particles may be developed as novel anti-obesity treatments with fewer adverse effects than currently marketed treatment options.
|
|
| 5. |
- Joyce, Paul, 1989, et al.
(author)
-
Modulating the Lipase-Mediated Bioactivity of Particle-Lipid Conjugates Through Changes in Nanostructure and Surface Chemistry
- 2017
-
In: European Journal of Lipid Science and Technology. - : Wiley. - 1438-7697 .- 1438-9312. ; 119:12, s. 1700213-
-
Journal article (peer-reviewed)abstract
- The lipase-mediated hydrolysis of triglycerides can be controlled by confining lipid droplets within highly porous nanostructured particle matrices. Novel hybrid materials with varying bioactivities toward lipase have been developed by spray drying particle-stabilized emulsions to form highly organized three-dimensional architectures. In this study, the particle size, nanostructure, and surface chemistry of hybrid particles are tailored to systematically investigate the influence of material characteristics on lipase activity. This is achieved by varying (i) the spray drying process and (ii) the structure and composition of particulate colloids employed to stabilize the precursor emulsions. In all cases, the colloidal self-assembly of particles and droplets into nanostructured conjugates during the water removal process facilitated enhanced lipase activity compared to submicron triglyceride emulsions, with lipolysis kinetics increasing in the following order: polymer-lipid hybrid (PLH)
|
|
| 6. |
- Joyce, Paul, 1989, et al.
(author)
-
Nanostructured clay particles supplement orlistat action in inhibiting lipid digestion: An in vitro evaluation for the treatment of obesity
- 2019
-
In: European Journal of Pharmaceutical Sciences. - : Elsevier BV. - 0928-0987 .- 1879-0720. ; 135, s. 1-11
-
Journal article (peer-reviewed)abstract
- Obesity is a rapidly growing epidemic, with over one-third of the global population classified as overweight or obese. Consequently, an urgent need exists to develop innovative approaches and technologies that regulate energy uptake, to curb the rising trend in obesity statistics. In this study, nanostructured clay (NSC)particles, fabricated by spray drying delaminated dispersions technologies that regulate energy uptake, to curb the rising trend in obesity statistics. In this study, nanostructured clay (NSC)particles, fabricated by spray drying delaminated dispersions of commercial clay platelets (Veegum® HS and LAPONITE® XLG), were delivered as complimentary, bioactive excipients with the potent lipase inhibitor, orlistat, for the inhibition of fat (lipid)hydrolysis. Simulated intestinal lipolysis studies were performed by observing changes in free fatty acid concentration and revealed that a combinatorial effect existed when NSC particles were co-administered with orlistat, as evidenced by a 1.2- to 1.6-fold greater inhibitory response over 60 min, compared to dosing orlistat alone. Subsequently, it was determined that a multifaceted approach to lipolysis inhibition was presented, whereby NSC particles adsorbed high degrees of lipid (up to 80% of all lipid species present in lipolysis media)and thus physically shielded the lipid-in-water interface from lipase access, while orlistat covalently attached and blocked the lipase enzyme active site. Thus, the ability for NSC particles to enhance the biopharmaceutical performance and potency of orlistat is hypothesised to translate into promising in vivo pharmacodynamics, where this novel approach is predicted to lead to considerably greater weight reductions for obese patients, compared to dosing orlistat alone.
|
|
| 7. |
- Joyce, Paul, 1989, et al.
(author)
-
Solidification to improve the biopharmaceutical performance of SEDDS: Opportunities and challenges
- 2019
-
In: Advanced Drug Delivery Reviews. - : Elsevier BV. - 0169-409X .- 1872-8294. ; 142, s. 102-117
-
Research review (peer-reviewed)abstract
- Self-emulsifying drug delivery systems (SEDDS) offer potential for overcoming the inherent slow dissolution and poor oral absorption of hydrophobic drugs by retaining them in a solubilised state during gastrointestinal transit. However, the promising biopharmaceutical benefits of liquid lipid formulations has not translated into widespread commercial success, due to their susceptibility to long term storage and in vivo precipitation issues. One strategy that has emerged to overcome such limitations, is to combine the solubilisation and dissolution enhancing properties of lipids with the stabilising effects of solid carrier materials. The development of intelligent hybrid drug formulations has presented new opportunities to harness the potential of emulsified lipids in optimising oral bioavailability for lipophilic therapeutics. Specific emphasis of this review is placed on the impact of solidification approaches and excipients on the biopharmaceutical performance of self-emulsifying lipids, with findings highlighting the key design considerations that should be implemented when developing hybrid lipid-based formulations.
|
|
