| 1. |
- Adolfsson, Jan, et al.
(författare)
-
Clinical characteristics and primary treatment of prostate cancer in Sweden between 1996 and 2005
- 2007
-
Ingår i: Scandinavian Journal of Urology and Nephrology. - : Informa UK Limited. - 0036-5599 .- 1651-2065. ; 41:6, s. 456-477
-
Tidskriftsartikel (refereegranskat)abstract
- OBJECTIVE: The incidence of prostate cancer is rising rapidly in Sweden and there is a need to better understand the pattern of diagnosis, tumor characteristics and treatment. MATERIAL AND METHODS: Between 1996 and 2005, all new cases of adenocarcinoma of the prostate gland were intended to be registered in the National Prostate Cancer Register (NPCR). This register contains information on diagnosing unit, date of diagnosis, cause of diagnosis, tumor grade, tumor stage according to the TNM classification in force, serum prostate-specific antigen (PSA) levels at diagnosis and primary treatment given within the first 6 months after diagnosis. RESULTS: In total, 72,028 patients were registered, comprising >97% of all pertinent incident cases of prostate cancer in the Swedish Cancer Register (SCR). During the study period there was a considerable decrease in median age at the time of diagnosis, a stage migration towards smaller tumors, a decrease in median serum PSA values at diagnosis, a decrease in the age-standardized incidence rate of men diagnosed with distant metastases or with a PSA level of > 100 ng/ml at diagnosis and an increase in the proportion of tumors with Gleason score <6. Relatively large geographical differences in the median age at diagnosis and the age-standardized incidence of cases with category T1c tumors were observed. Treatment with curative intent increased dramatically and treatment patterns varied according to geographical region. In men with localized tumors and a PSA level of <20 ng/ml at diagnosis, expectant treatment was more commonly used in those aged > or =75 years than in those aged <75 years. Also, the pattern of endocrine treatment varied in different parts of Sweden. CONCLUSIONS: All changes in the register seen over time are consistent with increased diagnostic activity, especially PSA testing, resulting in an increased number of cases with early disease, predominantly tumors in category T1c. The patterns of diagnosis and treatment of prostate cancer vary considerably in different parts of Sweden. The NPCR continues to be an important source for research, epidemiological surveillance of the incidence, diagnosis and treatment of prostate cancer.
|
|
| 2. |
- Davidsson, Kent, 1967, et al.
(författare)
-
Potassium, chlorine, and sulfur in ash, particles, deposits, and corrosion during wood combustion in a circulating fluidized-bed boiler
- 2007
-
Ingår i: Energy & Fuels. - : American Chemical Society (ACS). - 1520-5029 .- 0887-0624. ; 21:1, s. 71-81
-
Tidskriftsartikel (refereegranskat)abstract
- The effect of the addition of chlorine and/or sulfur to the fuel on fly ash composition, deposit formation, and superheater corrosion has been studied during biomass combustion in a circulating fluidized-bed boiler. The chlorine (HCl (aq)) and sulfur (SO2 (g)) were added in proportions of relevance for the potassium chemistry. The composition of the bottom and the fly ashes was analyzed. Gas and particle measurements were performed downstream of the cyclone before the convection pass and the flue gas composition was recorded in the stack with a series of standard instruments and an FTIR analyzer. At the position downstream of the cyclone, a deposit probe was situated, simulating a superheater tube. Deposits on the probe and initial corrosion were examined. It is concluded that addition of sulfur and chlorine increases the formation of submicron particles leading to deposition of potassium sulfate and chloride. The results compare well with earlier work based on laboratory-scale experiments concerning effects of chlorine and sulfur on potassium chemistry.
|
|
| 3. |
- Källhammer, Jan-Erik, et al.
(författare)
-
Fulfilling the pedestrian protection directive using a long-wavelength infrared camera designed to meet both performance and cost targets
- 2006
-
Ingår i: Photonics in the Automobile II. - : SPIE. ; , s. 19809-19809
-
Konferensbidrag (refereegranskat)abstract
- Pedestrian fatalities are around 15% of the traffic fatalities in Europe. A proposed EU regulation requires the automotive industry to develop technologies that will substantially decrease the risk for Vulnerable Road Users when hit by a vehicle. Automatic Brake Assist systems, activated by a suitable sensor, will reduce the speed of the vehicle before the impact, independent of any driver interaction. Long Wavelength Infrared technology is an ideal candidate for such sensors, but requires a significant cost reduction. The target necessary for automotive serial applications are well below the cost of systems available today. Uncooled bolometer arrays are the most mature technology for Long Wave Infrared with low-cost potential. Analyses show that sensor size and production yield along with vacuum packaging and the optical components are the main cost drivers. A project has been started to design a new Long Wave Infrared system with a ten times cost reduction potential, optimized for the pedestrian protection requirement. It will take advantage of the progress in Micro Electro-Mechanical Systems and Long Wave Infrared optics to keep the cost down. Deployable and pre-impact braking systems can become effective alternatives to passive impact protection systems solutions fulfilling the EU pedestrian protection regulation. Low-cost Long Wave Infrared sensors will be an important enabler to make such systems cost competitive, allowing high market penetration.
|
|
| 4. |
|
|
| 5. |
- Balmes, Olivier, et al.
(författare)
-
Imaging atomic structure in metal nanoparticles using high-resolution cryo-TEM
- 2006
-
Ingår i: Microscopy and Microanalysis. - 1435-8115. ; 12:2, s. 145-150
-
Tidskriftsartikel (refereegranskat)abstract
- It has been shown, by imaging gold (200) planes, that it is possible to achieve better than 0.20-nm structural resolution in cryo-transmission electron microscopy (cryo-TEM). This has been done using commercially available cryo equipment and using a 300-kV field emission gun (FEG) TEM. The images of 15-nm gold particles embedded in amorphous frozen water clearly show the (111) planes (separated by 0.235 nm) in gold. Fourier transform demonstrates the presence of (200) planes in the image, proving a resolution of better than 0.20 nm. The experimental results are Supported by image simulations using the multislice method. These simulations suggest that it should be possible to achieve the same resolution even in smaller particles and particles of lighter elements. The crucial experimental problem to overcome is keeping the thickness of the amorphous film low and to work at low electron dose conditions.
|
|
| 6. |
- Bäckström, Daniel, 1985, et al.
(författare)
-
Particle composition and size distribution in coal flames - The influence on radiative heat transfer
- 2015
-
Ingår i: Experimental Thermal and Fluid Science. - : Elsevier BV. - 0894-1777 .- 1879-2286. ; 64, s. 70-80
-
Tidskriftsartikel (refereegranskat)abstract
- Radiative heat transfer in a 77 kWth swirling lignite flame has been studied. The aim is to characterize different particle types present in a coal flame and to determine their influence on the radiative heat transfer. The study combines extractive particle measurements, radiative intensity measurements and detailed radiation modelling. The size distribution of the extracted particles was measured with a low pressure impactor and some of the size fractions were analysed with SEM–EDX. The measured total radiative intensity is compared with the modelled intensity based on the particle measurements in the same cross-section of the flame. The particle properties were calculated with Mie theory and the gas properties with a statistical narrow-band model. The results show that the contribution of coal/char particles dominates the radiative heat transfer in the investigated cross-section of the flame. The methodology applied in this work shows promising results for characterization of particle radiation in flames of practical size.
|
|
| 7. |
- Folkeson, Nicklas, 1981, et al.
(författare)
-
Fireside corrosion of stainless and low alloyed steels in a waste-fired CFB boiler; The effect of adding sulphur to the fuel
- 2008
-
Ingår i: Materials Science Forum. ; 595-598, s. 289-297
-
Tidskriftsartikel (refereegranskat)abstract
- Corrosion field tests have been carried out in the superheater region of a commercial waste-fired 75MW CFBC boiler using air cooled probes. Exposure time was 24 and 1000 hours. The effect of adding sulphur to the fuel on the corrosion of two high alloyed steels and a low alloyed steel was studied. The fuel consisted of 50% household waste and 50% industrial waste. The exposed samples were analyzed by ESEM/EDX and XRD. Metal loss was determined after 1000 hours. Both materials suffered significant corrosion in the absence of sulphur addition and the addition of sulphur to the fuel reduced corrosion significantly. The rapid corrosion of the high alloyed steel in the absence of sulphur addition is caused by the destruction of the chromium-containing protective oxide by formation of calcium chromate. Adding sulphur to the fuel inhibited chromate formation and increased the sulphate/chloride ratio in the deposit. Iron(II) chloride formed on the low alloyed steel regardless of whether sulphur was added or not.
|
|
| 8. |
|
|
| 9. |
|
|
| 10. |
- Jonsson, Torbjörn, 1970, et al.
(författare)
-
The influence of KCl on the corrosion of an austenitic stainless steel (304L) in oxidizing humid conditions at 600 ºC: A microstructural study
- 2009
-
Ingår i: Oxidation of Metals. - : Springer Science and Business Media LLC. - 1573-4889 .- 0030-770X. ; 72:3, s. 213-239
-
Tidskriftsartikel (refereegranskat)abstract
- The effect of KCl on the corrosion behavior of the austenitic stainless steel 304L was studied at 600 A degrees C in 5% O(2) + 40% H(2)O + N(2). The breakdown of the protective oxide was investigated. This was done through a detailed microstructural characterization of the oxide scales formed after 1, 24 and 168 h. The oxidized samples were investigated by SEM/EDX, FIB and STEM/EDX. The presence of KCl(s) causes a breakdown of most of the protective scale, even though it is not in direct contact with KCl(s) particles, starting after just 1 h exposure. A fast growing porous oxide formed in direct contact with (former) KCl(s) particles and an about 2 mu m thick scale covered most of the surface. Only some regions were covered by a thin scale. K(2)CrO(4) particles were randomly distributed all over the scale after 1 h exposure. The particles are situated above the oxide scale and are not in direct contact with the subjacent metal. The thin scale contains lower Cr levels than has been observed in corresponding scales formed in the absence of KCl. The breakdown of the protective scale is suggested to be caused primarily by the formation of K(2)CrO(4), depleting the protective oxide in chromium. In addition, chromia evaporation contributes to chromia depletion and breakdown of the protective scale. Very little or no transition metal chlorides were found after breakaway oxidation. Cl is suggested to play a minor role in the initial breakdown of the protective scale. The presence of KCl particles caused local rapid oxidation, which results in an outward growing Fe and Fe-Cr rich porous oxide.
|
|
