1. |
|
|
2. |
- Abazov, V. M., et al.
(author)
-
The upgraded DO detector
- 2006
-
In: Nuclear Instruments and Methods in Physics Research Section A. - : Elsevier BV. - 0168-9002 .- 1872-9576. ; 565:2, s. 463-537
-
Journal article (peer-reviewed)abstract
- The DO experiment enjoyed a very successful data-collection run at the Fermilab Tevatron collider between 1992 and 1996. Since then, the detector has been upgraded to take advantage of improvements to the Tevatron and to enhance its physics capabilities. We describe the new elements of the detector, including the silicon microstrip tracker, central fiber tracker, solenoidal magnet, preshower detectors, forward muon detector, and forward proton detector. The uranium/liquid -argon calorimeters and central muon detector, remaining from Run 1, are discussed briefly. We also present the associated electronics, triggering, and data acquisition systems, along with the design and implementation of software specific to DO.
|
|
3. |
- Bullock, A, et al.
(author)
-
International standards for programmes of training in intensive care medicine in Europe
- 2011
-
In: Intensive Care Medicine. - : Springer Science and Business Media LLC. - 0342-4642 .- 1432-1238. ; 37:3, s. 385-393
-
Journal article (peer-reviewed)abstract
- PURPOSE:To develop internationally harmonised standards for programmes of training in intensive care medicine (ICM).METHODS:Standards were developed by using consensus techniques. A nine-member nominal group of European intensive care experts developed a preliminary set of standards. These were revised and refined through a modified Delphi process involving 28 European national coordinators representing national training organisations using a combination of moderated discussion meetings, email, and a Web-based tool for determining the level of agreement with each proposed standard, and whether the standard could be achieved in the respondent's country.RESULTS:The nominal group developed an initial set of 52 possible standards which underwent four iterations to achieve maximal consensus. All national coordinators approved a final set of 29 standards in four domains: training centres, training programmes, selection of trainees, and trainers' profiles. Only three standards were considered immediately achievable by all countries, demonstrating a willingness to aspire to quality rather than merely setting a minimum level. Nine proposed standards which did not achieve full consensus were identified as potential candidates for future review.CONCLUSIONS:This preliminary set of clearly defined and agreed standards provides a transparent framework for assuring the quality of training programmes, and a foundation for international harmonisation and quality improvement of training in ICM.
|
|
4. |
- Chen, X., et al.
(author)
-
Experimental investigations of polymer hollow fibre integrated evaporative cooling system with the fibre bundles in a spindle shape
- 2017
-
In: Energy and Buildings. - : Elsevier BV. - 0378-7788 .- 1872-6178. ; 154, s. 166-174
-
Journal article (peer-reviewed)abstract
- Due to the advantages of light weight, corrosion resistant and low cost, hollow fibres have been studied as the substitute for metallic materials. A novel hollow fibre integrated evaporative cooling system, in which the hollow fibre module constitutes as the humidifier and the evaporative cooler, is proposed. This novel hollow fibre integrated evaporative cooling system will provide a comfortable indoor environment for hot and dry area. Moreover, the water vapour can permeate through the hollow fibre effectively, and the liquid water droplets will be prevented from mixing with the processed air. In order to avoid the flow channelling or shielding of adjacent fibres, the fibres inside each bundle were made into a spindle shape to allow maximum contact between the air stream and the fibre. The cooling performances of the proposed novel polymer hollow fibre integrated evaporative cooling system were experimentally investigated under the incoming air temperature in the range of 26 °C to 32 °C and relative humidity of 25%–35%. The effects of air velocities on the cooling effectiveness, heat and mass transfer coefficients, specific water consumption and pressure drop across the polymer hollow fibre module were analysed. Two sets of experimentally derived non-dimensional heat and mass transfer correlations were summarized, which could be favourable for the future design of polymer hollow fibre integrated evaporative cooling system.
|
|
5. |
|
|
6. |
- Jung, Christian, et al.
(author)
-
A comparison of very old patients admitted to intensive care unit after acute versus elective surgery or intervention
- 2019
-
In: Journal of critical care. - : W B SAUNDERS CO-ELSEVIER INC. - 0883-9441 .- 1557-8615. ; 52, s. 141-148
-
Journal article (peer-reviewed)abstract
- Background: We aimed to evaluate differences in outcome between patients admitted to intensive care unit (ICU) after elective versus acute surgery in a multinational cohort of very old patients (80 years; VIP). Predictors of mortality, with special emphasis on frailty, were assessed.Methods: In total, 5063 VIPs were induded in this analysis, 922 were admitted after elective surgery or intervention, 4141 acutely, with 402 after acute surgery. Differences were calculated using Mann-Whitney-U test and Wilcoxon test. Univariate and multivariable logistic regression were used to assess associations with mortality.Results: Compared patients admitted after acute surgery, patients admitted after elective surgery suffered less often from frailty as defined as CFS (28% vs 46%; p < 0.001), evidenced lower SOFA scores (4 +/- 5 vs 7 +/- 7; p < 0.001). Presence of frailty (CFS >4) was associated with significantly increased mortality both in elective surgery patients (7% vs 12%; p = 0.01), in acute surgery (7% vs 12%; p = 0.02).Conclusions: VIPs admitted to ICU after elective surgery evidenced favorable outcome over patients after acute surgery even after correction for relevant confounders. Frailty might be used to guide clinicians in risk stratification in both patients admitted after elective and acute surgery.
|
|
7. |
- Rees, R. M., et al.
(author)
-
Nitrous oxide emissions from European agriculture; an analysis of variability and drivers of emissions from field experiments
- 2012
-
In: Biogeosciences Discussions. - : Copernicus GmbH. - 1810-6277. ; 9:7, s. 9259-9288
-
Journal article (peer-reviewed)abstract
- Nitrous oxide emissions from a network of agricultural experiments in Europe and Zimbabwe were used to explore the relative importance of site and management controls of emissions. At each site, a selection of management interventions were compared 5 within replicated experimental designs in plot based experiments. Arable experiments were conducted at Beano in Italy, El Encin in Spain, Foulum in Denmark, Logården in Sweden, Maulde in Belgium, Paulinenaue in Germany, Harare in Zimbabwe and Tulloch in the UK. Grassland experiments were conducted at Crichton, Nafferton and Peaknaze in the UK, Gödöllö in Hungary, Rzecin in Poland, Zarnekow in Germany and 10 Theix in France. Nitrous oxide emissions were measured at each site over a period of at least two years using static chambers. Emissions varied widely between sites and as a result of manipulation treatments. Average site emissions (throughout the study period) varied between 0.04 and 21.21 kg N2O-N ha−1 yr−1, with the largest fluxes and variability associated with the grassland sites. Total nitrogen addition was found to be 15 the single most important determinant of emissions, accounting for 15% of the variance (using linear regression) in the data from the arable sites (p < 0.0001), and 77% in the grassland sites. The annual emissions from arable sites were significantly greater than those that would be predicted by IPCC default emission factors. Variability in N2O within sites that occurred as a result of manipulation treatments was greater than that 20 resulting from site to site and year to year variation, highlighting the importance of management interventions in contributing to greenhouse gas mitigation.
|
|
8. |
- Rees, R. M., et al.
(author)
-
Nitrous oxide emissions from European agriculture - an analysis of variability and drivers of emissions from field experiments
- 2013
-
In: Biogeosciences. - : Copernicus GmbH. - 1726-4170 .- 1726-4189. ; 10:4, s. 2671-2682
-
Journal article (peer-reviewed)abstract
- Nitrous oxide emissions from a network of agricultural experiments in Europe and Zimbabwe were used to explore the relative importance of site and management controls of emissions. At each site, a selection of management interventions were compared within replicated experimental designs in plot based experiments. Arable experiments were conducted at Beano in Italy, El Encin in Spain, Foulum in Denmark, Logården in Sweden, Maulde in Belgium, Paulinenaue in Germany, Harare in Zimbabwe and Tulloch in the UK. Grassland experiments were conducted at Crichton, Nafferton and Peaknaze in the UK, Gödöllö in Hungary, Rzecin in Poland, Zarnekow in Germany and Theix in France. Nitrous oxide emissions were measured at each site over a period of at least two years using static chambers. Emissions varied widely between sites and as a result of manipulation treatments. Average site emissions (throughout the study period) varied between 0.04 and 21.21 kg N2O-N ha−1 yr−1, with the largest fluxes and variability associated with the grassland sites. Total nitrogen addition was found to be the single most important determinant of emissions, accounting for 15% of the variance (using linear regression) in the data from the arable sites (p < 0.0001), and 77% in the grassland sites. The annual emissions from arable sites were significantly greater than those that would be predicted by IPCC default emission factors. Variability in N2O within sites that occurred as a result of manipulation treatments was greater than that resulting from site to site and year to year variation, highlighting the importance of management interventions in contributing to greenhouse gas mitigation.
|
|