| 1. |
- Diakaki, M., et al.
(författare)
-
Towards the high-accuracy determination of the 238U fission cross section at the threshold region at CERN -€“ n_TOF
- 2016
-
Ingår i: EPJ Web of Conferences. - : EDP Sciences. - 2100-014X.
-
Konferensbidrag (refereegranskat)abstract
- The U-238 fission cross section is an international standard beyond 2 MeV where the fission plateau starts. However, due to its importance in fission reactors, this cross-section should be very accurately known also in the threshold region below 2 MeV. The U-238 fission cross section has been measured relative to the U-235 fission cross section at CERN - n_TOF with different detection systems. These datasets have been collected and suitably combined to increase the counting statistics in the threshold region from about 300 keV up to 3 MeV. The results are compared with other experimental data, evaluated libraries, and the IAEA standards.
|
|
| 2. |
- Paradela, C., et al.
(författare)
-
High-accuracy determination of the 238U/235U fission cross section ratio up to ~1 GeV at n_TOF at CERN
- 2015
-
Ingår i: Physical Review C. Nuclear Physics. - 0556-2813 .- 1089-490X. ; 91, s. 024602-
-
Tidskriftsartikel (refereegranskat)abstract
- The U238 to U235 fission cross section ratio has been determined at n_TOF up to ≈1 GeV, with two different detection systems, in different geometrical configurations. A total of four datasets has been collected and compared. They are all consistent to each other within the relative systematic uncertainty of 3–4%. The data collected at n_TOF have been suitably combined to yield a unique fission cross section ratio as a function of neutron energy. The result confirms current evaluations up to 200 MeV. Good agreement is also observed with theoretical calculations based on the INCL++/Gemini++ combination up to the highest measured energy. The n_TOF results may help solve a long-standing discrepancy between the two most important experimental datasets available so far above 20 MeV, while extending the neutron energy range for the first time up to ≈1 GeV.
|
|
| 3. |
- Abbondanno, U, et al.
(författare)
-
The data acquisition system of the neutron time-of-flight facility n_TOF at CERN
- 2005
-
Ingår i: Nuclear Instruments and Methods in Physics Research Section A. - : Elsevier BV. - 0168-9002 .- 1872-9576. ; 538:1-3, s. 692-702
-
Tidskriftsartikel (refereegranskat)abstract
- The n_TOF facility at CERN has been designed for the measurement of neutron capture, fission and (n, xn) cross-sections with high accuracy. This requires a flexible and-due to the high instantaneous neutron flux-almost dead time free data acquisition system. A scalable and versatile data solution has been designed based on 8-bit flash-ADCs with sampling rates up to 2 GHz and 8 Mbyte memory buffer. The software is written in C and C++ and is running on PCs equipped with RedHat Linux.
|
|
| 4. |
- Paradela, C., et al.
(författare)
-
High accuracy 235U(n,f) data in the resonance energy region
- 2016
-
Ingår i: EPJ Web of Conferences. - : EDP Sciences. - 2100-014X.
-
Konferensbidrag (refereegranskat)abstract
- The U-235 neutron-induced cross section is widely used as reference cross section for measuring other fission cross sections, but in the resonance region it is not considered as an IAEA standard because of the scarce experimental data covering the full region. In this work, we deal with a new analysis of the experimental data obtained with a detection setup based on parallel plate ionization chambers (PPACs) at the CERN n_TOF facility in the range from 1 eV to 10 keV. The relative cross section has been normalised to the IAEA value in the region between 7.8 and 11 eV, which is claimed as well-known. Comparison with the ENDF/B-VII evaluation and the IAEA reference file from 100 eV to 10 keV are provided.
|
|
| 5. |
- Bécares-Palacios, V., et al.
(författare)
-
Reactivity monitoring with imposed beam trips and pulsed mode detectors in the subcritical experiment YALINA-Booster
- 2009
-
Ingår i: Proceedings of International Topical Meeting on Nuclear Research Applications and Utilization of Accelerators. - : International Atomic Energy Agency. - 9789201504104
-
Konferensbidrag (refereegranskat)abstract
- Reactivity monitoring is one of the urgent problems that require a solution in order to achieve a license for a future full-scale ADS. As a part of the EUROTRANS experiments at the YALINA-Booster facility, presented in this conference, a set of measurements with imposed beam-trips has been performed. Traditionally, the source jerk method has been used in subcritical systems to obtain the reactivity by comparing the total neutron flux before the neutron source removal to the semi-stable delayed neutron flux after the source removal. The deuterium-tritium neutron source of the YALINA-Booster facility can, in addition to pulsed mode operation, operate with continuous beam with short imposed millisecond-scale interruptions, thus providing the possibility to monitor the reactivity at each beam trip in the source jerk manner. In order to test the validity of the beam-trip reactivity values determined by using detectors operating in current-mode (also presented in this conference), the reactivity values of the YALINA-Booster assembly obtained through the beam-trip technique using pulsed-mode detectors is presented in this work. In these experiments, a beam-trip frequency of 1 Hz and an interruption time of ∼20 ms have been chosen and two different core loadings with effective multiplication factor around 0.95 have been investigated. These two different loadings with close to equal reactivity but different source multiplication characteristics make it possible to explore the effect of the different source multiplications. In addition, the response of the imposed beam-trip reactivity monitoring technique to reactivity insertions and removals has been studied through control rod movements. Experimental data from fission chambers have been acquired from all three zones of the core: the fast booster zone, the thermal zone and the reflector.
|
|
| 6. |
- Becares, V., et al.
(författare)
-
Evaluation of the criticality constant from Pulsed Neutron Source measurements in the Yalina-Booster subcritical assembly
- 2013
-
Ingår i: Annals of Nuclear Energy. - : Elsevier BV. - 0306-4549 .- 1873-2100. ; 53, s. 40-49
-
Tidskriftsartikel (refereegranskat)abstract
- The prompt decay constant method and the area-ratio (Sjostrand) method constitute the reference techniques for measuring the reactivity of a subcritical system using Pulsed Neutron Source experiments (PNS). However, different experiments have shown that in many cases it is necessary to apply corrections to the experimental results in order to take into account spectral and spatial effects. In these cases, the approach usually followed is to develop different specific correction procedures for each method. In this work we discuss the validity of prompt decay constant method and the area-ratio method in the Yalina-Booster subcritical assembly and propose a general correction procedure based on Monte Carlo simulations.
|
|
| 7. |
|
|
| 8. |
|
|
| 9. |
- Becares, V., et al.
(författare)
-
Validation of ADS reactivity monitoring techniques in the Yalina-Booster subcritical assembly
- 2013
-
Ingår i: Annals of Nuclear Energy. - : Elsevier BV. - 0306-4549 .- 1873-2100. ; 53, s. 331-341
-
Tidskriftsartikel (refereegranskat)abstract
- The development of a reactivity monitoring system for subcritical reactors is a major task prior to industrial scale accelerator driven system (ADS) construction. Within the 6th European Framework Program, the IP-EUROTRANS project has performed a series of experiments at the Yalina-Booster subcritical assembly located at the Joint Institute for Power and Nuclear Research (JIPNR) of the National Academy of Sciences of Belarus, using a continuous (D, T) (fusion) neutron source in pulsed and continuous mode with short interruptions (beam trips). In this paper, the implementation and results of three different monitoring techniques intended to operate with continuous neutron sources will be presented, namely the source-jerk technique, the prompt decay constant technique and the current-to-flux technique. The results will be compared with the values of the reactivity obtained using the pulsed source in PNS experiments, discussed in detail in another paper.
|
|
| 10. |
- Berglöf, Carl, et al.
(författare)
-
Auto-correlation and variance-to-mean measurements in a subcritical core obeying multiple alpha-modes
- 2011
-
Ingår i: Annals of Nuclear Energy. - : Elsevier BV. - 0306-4549 .- 1873-2100. ; 38:2-3, s. 194-202
-
Tidskriftsartikel (refereegranskat)abstract
- Neutron noise measurements based on the Rossi-alpha and Feynman-alpha methodologies have been performed in a heterogeneous subcritical system. It is shown that the traditional single alpha-mode formulations of the Rossi-alpha and Feynman-alpha methods are not applicable due to the presence of higher alpha-modes. Formalisms taking into account multiple alpha-modes are applied resulting in satisfactory results. Three alpha-modes could be identified using the Rossi-alpha method, whereas only two could be obtained using the Feynman-alpha method. In the Feynman-alpha case, the possibility to obtain the fastest decaying alpha-mode was diminished due to detector dead time effects. It was found that the slowest decaying alpha-mode does not exactly correspond to the prompt decay found in pulsed neutron source measurements, which confirms the results of previous studies. Strengths and weaknesses of the multiple alpha-mode Rossi-alpha and Feynman-alpha methods observed in this study are pointed out.
|
|
