| 1. |
- Dahlin, Mats, et al.
(författare)
-
Internet-delivered acceptance-based behaviour therapy for generalized anxiety disorder : A randomized controlled trial
- 2016
-
Ingår i: Behaviour Research and Therapy. - : Elsevier BV. - 0005-7967 .- 1873-622X. ; 77, s. 86-95
-
Tidskriftsartikel (refereegranskat)abstract
- Generalized anxiety disorder (GAD) is a disabling condition which can be treated with cognitive behaviour therapy (CBT). The present study tested the effects of therapist-guided internet-delivered acceptance-based behaviour therapy on symptoms of GAD and quality of life. An audio CD with acceptance and mindfulness exercises and a separate workbook were also included in the treatment. Participants diagnosed with GAD (N = 103) were randomly allocated to immediate therapist-guided internet-delivered acceptance-based behaviour therapy or to a waiting-list control condition. A six month follow-up was also included. Results using hierarchical linear modelling showed moderate to large effects on symptoms of GAD (Cohen's d = 0.70 to 0.98), moderate effects on depressive symptoms (Cohen's d = 0.51 to 0.56), and no effect on quality of life. Follow-up data showed maintained effects. While there was a 20% dropout rate, sensitivity analyses showed that dropouts did not differ in their degree of change during treatment. To conclude, our study suggests that internet-delivered acceptance-based behaviour therapy can be effective in reducing the symptoms of GAD.
|
|
| 2. |
- Englund, Johanna, 1988, et al.
(författare)
-
Deactivation of a Pd/Pt Bimetallic Oxidation Catalyst Used in a Biogas-Powered Euro VI Heavy-Duty Engine Installation
- 2019
-
Ingår i: Catalysts. - : MDPI. - 2073-4344. ; 9:12
-
Tidskriftsartikel (refereegranskat)abstract
- The reduction of anthropogenic greenhouse gas emissions is crucial to avoid further warming of the planet. We investigated how effluent gases from a biogas powered Euro VI heavy-duty engine impact the performance of a bimetallic (palladium and platinum) oxidation catalyst. Using synthetic gas mixtures, the oxidation of NO, CO, and CH4 before and after exposure to biogas exhaust for 900 h was studied. The catalyst lost most of its activity for methane oxidation, and the activity loss was most severe for the inlet part of the aged catalyst. Here, a clear sintering of Pt and Pd was observed, and higher concentrations of catalyst poisons such as sulfur and phosphorus were detected. The sintering and poisoning resulted in less available active sites and hence lower activity for methane oxidation.
|
|
| 3. |
- Englund, Johanna, 1988, et al.
(författare)
-
Deactivation of a Vanadium-Based SCR Catalyst Used in a Biogas-Powered Euro VI Heavy-Duty Engine Installation
- 2020
-
Ingår i: Catalysts. - : MDPI AG. - 2073-4344. ; 10:5
-
Tidskriftsartikel (refereegranskat)abstract
- We have investigated how the exhaust gases from a heavy-duty Euro VI engine, powered with biogas impact a vanadium-based selective catalytic reduction (SCR) catalyst in terms of performance. A full Euro VI emission control system was used and the accumulation of catalyst poisons from the combustion was investigated for the up-stream particulate filter as well as the SCR catalyst. The NO(x)reduction performance in terms of standard, fast and NO2-rich SCR was evaluated before and after exposure to exhaust from a biogas-powered engine for 900 h. The SCR catalyst retains a significant part of its activity towards NO(x)reduction after exposure to biogas exhaust, likely due to capture of catalyst poisons on the up-stream components where the deactivation of the oxidation catalyst is especially profound. At lower temperatures some deactivation of the first part of the SCR catalyst was observed which could be explained by a considerably higher surface V4+/V(5+)ratio for this sample compared to the other samples. The higher value indicates that the reoxidation of V(4+)to V(5+)is partially hindered, blocking the redox cycle for parts of the active sites.
|
|
| 4. |
- Pettersson Dahlin, Andreas, et al.
(författare)
-
Capillary electrophoresis coupled to mass spectrometry from a polymer modified poly(dimethylsiloxane) microchip with an integrated graphite electrospray tip
- 2005
-
Ingår i: The Analyst. - : Royal Society of Chemistry (RSC). - 0003-2654 .- 1364-5528. ; 130:2, s. 193-199
-
Tidskriftsartikel (refereegranskat)abstract
- Hybrid capillary-poly(dimethysiloxane) (PDMS) microchips with integrated electrospray ionization (ESI) tips were directly fabricated by casting PDMS in a mould. The shapes of the emitter tips were drilled into the mould, which produced highly reproducible three-dimensional tips. Due to the fabrication method of the microfluidic devices, no sealing was necessary and it was possible to produce a perfect channel modified by PolyE-323, an aliphatic polyamine coating agent. A variety of different coating procedures were also evaluated for the outside of the emitter tip. Dusting graphite on a thin unpolymerised PDMS layer followed by polymerisation was proven to be the most suitable procedure. The emitter tips showed excellent electrochemical properties and durabilities. The coating of the emitter was eventually passivated, but not lost, and could be regenerated by electrochemical means. The excellent electrochemical stability was further confirmed in long term electrospray experiments, in which the emitter sprayed continuously for more than 180 h. The PolyE-323 was found suitable for systems that integrate rigid fused silica and soft PDMS technology, since it simply could be applied successfully to both materials. The spray stability was confirmed from the recording of a total ion chromatogram in which the electrospray current exhibited a relative standard deviation of 3.9% for a 30 min run. CE-ESI-MS separations of peptides were carried out within 2 min using the hybrid PDMS chip resulting in similar efficiencies as for fused silica capillaries of the same length and thus with no measurable band broadening effects, originating from the PDMS emitter.
|
|
