| 1. |
- Abdel, Naseem S., et al.
(författare)
-
Characterizations of new Delta E detectors for single-ion hit facility
- 2014
-
Ingår i: Nuclear Instruments & Methods in Physics Research. Section B: Beam Interactions with Materials and Atoms. - : Elsevier BV. - 0168-583X. ; 318, s. 281-286
-
Tidskriftsartikel (refereegranskat)abstract
- This paper describes the performance evaluation of new Delta E detectors to be used as pre-cell hit detectors in living cell irradiation experiments at the Lund Ion Beam Analysis facility (LIBAF). Using these detectors with a thickness down to 4.15 mu m fabricated at Lund University, an experiment was setup in which Delta E-detectors were used together with a stop E-detector in a telescope system under coincidence measurements. The characteristics of Delta E detectors were based on the optimal detection of the passage of 2.55 MeV protons. The results of these tests demonstrate that the detector telescope clearly separates the protons, this due to high signal-to-noise ratio and good energy resolution of the Delta E-detectors. The best performing detector was shown to have a detection efficiency of 95% at thickness of 9.7 mu m. This type of high-performing detector is suitable for the planned role of the Delta E-detector in the future cell irradiation experiments. (C) 2013 Elsevier B.V. All rights reserved.
|
|
| 2. |
- Adlmann, Franz, et al.
(författare)
-
Normalization of stroboscopic neutron scattering experiments
- 2018
-
Ingår i: Nuclear Instruments and Methods in Physics Research Section B. - : Elsevier BV. - 0168-583X .- 1872-9584. ; 434, s. 61-65
-
Tidskriftsartikel (refereegranskat)abstract
- Neutron scattering studies of kinetic processes are often flux limited. For processes which can be repeated many times, this can be mitigated by stroboscopic reintegration. The recorded scattering events are assigned to different time slices of the process and corresponding slices from all repetitions are summed up. The normalization of such data with respect to the incident beam spectrum can be challenging since the incident neutron flux may not necessarily be evenly distributed over all time slices. In this paper, we discuss how this can result in misleading information and we expand on a technique to amend these issues.
|
|
| 3. |
- Aldahan, Ala Adin, et al.
(författare)
-
10Be in rhodochrosite nodules from Neogene sediments along the Galapagos Ridge, equatorial Pacific
- 2010
-
Ingår i: Nuclear Instruments and Methods in Physics Research Section B. - : Elsevier BV. - 0168-583X .- 1872-9584. ; 268:7-8, s. 1253-1256
-
Tidskriftsartikel (refereegranskat)abstract
- Microcrystalline, calcian rhodochrosite occurs as nodules around burrows in late Neogene pelagic sediments from the Galapagos Ridge in the Guatemala Basin, eastern equatorial Pacific (DSDP Leg 68; Site 503). Be-10 isotope revealed that the rhodochrosite nodules have formed under growth conditions much faster than those reported for Fe-Mn nodules. The overall REE patterns of the nodules and host pelagic sediments indicate element derivation mainly from marine pore water. However, variations in the shale normalised Eu values suggest influx of hydrothermal fluids into mounds area at Galapagos, which is also evidenced by the similar minor and major element contents in the nodules and host sediments.
|
|
| 4. |
- Alemon, B., et al.
(författare)
-
Ion beam analysis, corrosion resistance and nanomechanical properties of TiAlCN/CNx multilayer grown by reactive magnetron sputtering
- 2014
-
Ingår i: Nuclear Instruments and Methods in Physics Research Section B. - : Elsevier. - 0168-583X .- 1872-9584. ; 331, s. 134-139
-
Tidskriftsartikel (refereegranskat)abstract
- A novel TiAlCN/CNx, multilayer coating, consisting of nine TiAlCN/CNx periods with a top layer 0.5 mu m of CNx, was designed to enhance the corrosion resistance of CoCrMo biomedical alloy. The multilayers were deposited by dc and RF reactive magnetron sputtering from Ti0.5Al0.5 and C targets respectively in a N-2/Ar plasma. The corrosion resistance and mechanical properties of the multilayer coatings were analyzed and compared to CoCrMo bulk alloy. Ion beam analysis (IBA) and X-ray diffraction tests were used to measure the element composition profiles and crystalline structure of the films. Corrosion resistance was evaluated by means of potentiodynamic polarization measurements using simulated body fluid (SBF) at typical body temperature and the nanomechanical properties of the multilayer evaluated by nanoindentation tests were analyzed and compared to CoCrMo bulk alloy. It was found that the multilayer hardness and the elastic recovery are higher than the substrate of CoCrMo. Furthermore the coated substrate shows a better general corrosion resistance than that of the CoCrMo alloy alone with no observation of pitting corrosion.
|
|
| 5. |
- Alfimov, Vasily, et al.
(författare)
-
Water masses and I-129 distribution in the Nordic Seas
- 2013
-
Ingår i: Nuclear Instruments and Methods in Physics Research Section B. - : Elsevier BV. - 0168-583X .- 1872-9584. ; 294, s. 542-546
-
Tidskriftsartikel (refereegranskat)abstract
- The application of the radioactive isotope iodine-129 as a tracer of water circulation in the oceans has provided interesting information with respect to sources and mixing of different water masses. We here present results of I-129 distribution in water profiles located in the Nordic Seas and use the isotope to fingerprint water masses in the region. The samples were collected by the US research vessel Knorr in May-June 2002. I-129 signatures along the Norwegian Sea reflect a mixing of I-129-rich surface water along the Scandinavian continental slope and I-129-poor North Atlantic surface water. These two water masses become less segregated along the Fram Strait where apparent I-129 enrichment penetrates the return Arctic flow into the East Greenland Current. The I-129 data further suggest existence of a water mass that is not entirely labeled with respect to origin at the Denmark Strait bottom water. This water parcel probably originates from the Iceland Sea. I-129 data also shed light on the major deep water outflow from the Nordic Seas located at the Faeroe Bank Channel.
|
|
| 6. |
- Audren, A., et al.
(författare)
-
Damage recovery in the oxygen sublattice of ZnO by post-implantation annealing
- 2012
-
Ingår i: Nuclear Instruments and Methods in Physics Research Section B. - : Elsevier BV. - 0168-583X .- 1872-9584. ; 272, s. 418-421
-
Tidskriftsartikel (refereegranskat)abstract
- Hydrothermally grown zinc oxide bulk samples were implanted with 200 key-Co ions with a fluence of 4.5 x 10(16) cm(-2) and then annealed in air during 30 min at different temperatures up to 900 degrees C. After the implantation and each annealing step, the samples were analyzed using the nuclear reaction O-16(alpha,alpha)O-16 at 3.045 MeV He in random and channeling directions to follow the annealing of the disorder profile in the O sublattice. For comparison, the disorder in the Zn sublattice was also observed by Rutherford backscattering spectrometry (RBS) in random and channeling directions. The results reveal that the disorder created during the Co implantation is slightly higher in the O sublattice than in the Zn sublattice. The disorder recovery induced by the thermal treatments, starts at 500 degrees C in the O sublattice and at 700 degrees C in the Zn sublattice. Although, the most part of the disorder recovery occurs between 700 and 800 degrees C in both sublattices.
|
|
| 7. |
- Audren, A., et al.
(författare)
-
Damage recovery in ZnO by post-implantation annealing
- 2010
-
Ingår i: Nuclear Instruments and Methods in Physics Research Section B. - : Elsevier BV. - 0168-583X .- 1872-9584. ; 268:11-12, s. 1842-1846
-
Tidskriftsartikel (övrigt vetenskapligt/konstnärligt)abstract
- ZnO bulk samples were implanted with 200 key-Co ions at room temperature with two fluences, 1 x 10(16) and 8 x 10(16) cm(-2), and then annealed in air for 30 min at different temperatures up to 900 degrees C. After the implantation and each annealing step, the samples were analyzed by Rutherford backscattering spectrometry (RBS) in random and channeling directions to follow the evolution of the disorder profile. The RBS spectra reveal that disorder is created during implantation in proportion to the Co fluence. The thermal treatments induce a disorder recovery, which is however, not complete after annealing at 900 degrees C, where about 15% of the damage remains. To study the Co profile evolution during annealing, the samples were, in addition to RBS, characterized by secondary ion mass spectrometry (SIMS). The results show that Co diffusion starts at 800 degrees C, but also that a very different behavior is seen for Co concentrations below and above the solubility limit. (C) 2010 Elsevier B.V. All rights reserved.
|
|
| 8. |
- Azarov, A. Yu., et al.
(författare)
-
Damage accumulation and annealing behavior in high fluence implanted MgZnO
- 2012
-
Ingår i: Nuclear Instruments and Methods in Physics Research Section B. - : Elsevier BV. - 0168-583X .- 1872-9584. ; 272, s. 426-429
-
Tidskriftsartikel (refereegranskat)abstract
- Molecular beam epitaxy grown MgxZn1-xO (x <= 0.3) layers were implanted at room temperature with 150 keV Er-166(+) ions in a fluence range of 5 x 10(15-)3 x 10(16) cm(-2). Evolution of ion-induced damage and structural changes were studied by a combination of Rutherford backscattering spectrometry, nuclear reaction analysis and time-of-flight elastic recoil detection analysis. Results show that damage production enhances in both Zn- and O-sublattices with increasing the Mg content in the MgZnO. However, MgZnO as well as pure ZnO exhibits a high degree of dynamic annealing and MgZnO can not be amorphized even at the highest ion fluence used. Annealing of heavily damaged ZnO leads to a strong surface erosion and thinning of the film. Increasing the Mg content suppresses the surface evaporation in high fluence implanted MgZnO but leads to a strong surface decomposition accompanied with a Mg-rich surface layer formation during post-implantation annealing.
|
|
| 9. |
- Battistoni, Giuseppe, et al.
(författare)
-
Applications of FLUKA Monte Carlo code for nuclear and accelerator physics
- 2011
-
Ingår i: Nuclear Instruments and Methods in Physics Research Section B. - : Elsevier BV. - 0168-583X .- 1872-9584. ; 269:24, s. 2850-2856
-
Tidskriftsartikel (refereegranskat)abstract
- FLUKA is a general purpose Monte Carlo code capable of handling all radiation components from thermal energies (for neutrons) or 1 keV (for all other particles) to cosmic ray energies and can be applied in many different fields. Presently the code is maintained on Linux. The validity of the physical models implemented in FLUKA has been benchmarked against a variety of experimental data over a wide energy range, from accelerator data to cosmic ray showers in the Earth atmosphere. FLUKA is widely used for studies related both to basic research and to applications in particle accelerators, radiation protection and dosimetry, including the specific issue of radiation damage in space missions, radiobiology (including radiotherapy) and cosmic ray calculations.After a short description of the main features that make FLUKA valuable for these topics, the present paper summarizes some of the recent applications of the FLUKA Monte Carlo code in the nuclear as well high energy physics. In particular it addresses such topics as accelerator related applications.
|
|
| 10. |
- Berggren, Ann-Marie, 1969-, et al.
(författare)
-
Enhanced beam currents with co-precipitated niobium as a matrix for AMS measurements of 10Be
- 2010
-
Ingår i: Nuclear Instruments and Methods in Physics Research Section B. - : Elsevier BV. - 0168-583X .- 1872-9584. ; 268:7-8, s. 795-798
-
Tidskriftsartikel (refereegranskat)abstract
- When dealing with small amounts of 10Be, it is challenging to achieve the good performance in the ion source that is needed to enable a reliable AMS measurement. We have co-precipitated beryllium with dissolved NbCl5, using a range of mixing ratios, to establish an optimal and practical procedure. 9Be16O‑ beam currents for co-precipitated samples of 9Be-Nb are often higher, but show a slower rise than for samples either co-precipitated or mixed with silver. However, while the Ag sample currents soon deteriorate, Nb sample currents stay high for an extended time, leading to higher measuring performance and better statistics. Although co-precipitated Be-Nb mixtures do not reach such high beam currents as BeO mechanically mixed with Nb powder, we prefer co-precipitation as it provides enough material for handling and an additional mixing step is avoided. We recommend use of NbCl5 as an alternative to AgNO3 on account of the much lower boron association of niobium compared to silver. No critical limit in the matrix:Be mixing ratio was observed, but we note a steady decline of maximum currents reached with increasing mixing ratio.
|
|
