| 1. |
- Mollén, Christopher, 1987-
(författare)
-
High-End Performance with Low-End Hardware : Analysis of Massive MIMO Base Station Transceivers
- 2017
-
Doktorsavhandling (övrigt vetenskapligt/konstnärligt)abstract
- Massive MIMO (multiple-input–multiple-output) is a multi-antenna technology for cellular wireless communication, where the base station uses a large number of individually controllable antennas to multiplex users spatially. This technology can provide a high spectral efficiency. One of its main challenges is the immense hardware complexity and cost of all the radio chains in the base station. To make massive MIMO commercially viable, inexpensive, low-complexity hardware with low linearity has to be used, which inherently leads to more signal distortion. This thesis investigates how the degenerated linearity of some of the main components—power amplifiers, analog-to-digital converters (ADCs) and low-noise amplifiers—affects the performance of the system, with respect to data rate, power consumption and out-of-band radiation. The main results are: Spatial processing can reduce PAR (peak-to-average ratio) of the transmit signals in the downlink to as low as 0B; this, however, does not necessarily reduce power consumption. In environments with isotropic fading, one-bit ADCs lead to a reduction in effective signal-to-interference-and-noise ratio (SINR) of 4dB in the uplink and four-bit ADCs give a performance close to that of an unquantized system. An analytical expression for the radiation pattern of the distortion from nonlinear power amplifiers is derived. It shows how the distortion is beamformed to some extent, that its gain never is greater than that of the desired signal, and that the gain of the distortion is reduced with a higher number of served users and a higher number of channel taps. Nonlinear low-noise amplifiers give rise to distortion that partly combines coherently and limits the possible SINR. It is concluded that spatial processing with a large number of antennas reduces the impact of hardware distortion in most cases. As long as proper attention is paid to the few sources of coherent distortion, the hardware complexity can be reduced in massive MIMO base stations to overcome the hardware challenge and make massive MIMO commercial reality.
|
|
| 2. |
- van Chien, Trinh, 1989-
(författare)
-
Resource Allocation for Max-Min Fairness in Multi-Cell Massive MIMO
- 2017
-
Licentiatavhandling (övrigt vetenskapligt/konstnärligt)abstract
- Massive MIMO (multiple-input multiple-output) is considered as an heir of the multi-user MIMO technology and it has recently gained lots of attention from both academia and industry. By equipping base stations (BSs) with hundreds of antennas, this new technology can provide very large multiplexing gains by serving many users on the same time-frequency resources and thereby bring significant improvements in spectral efficiency (SE) and energy efficiency (EE) over the current wireless networks. The transmit power, pilot training, and spatial transmission resources need to be allocated properly to the users to achieve the highest possible performance. This is called resource allocation and can be formulated as design utility optimization problems. If the resource allocation in Massive MIMO is optimized, the technology can handle the exponential growth in both wireless data traffic and number of wireless devices, which cannot be done by the current cellular network technology.In this thesis, we focus on two resource allocation aspects in Massive MIMO: The first part of the thesis studies if power control and advanced coordinated multipoint (CoMP) techniques are able to bring substantial gains to multi-cell Massive MIMO systems compared to the systems without using CoMP. More specifically, we consider a network topology with no cell boundary where the BSs can collaborate to serve the users in the considered coverage area. We focus on a downlink (DL) scenario in which each BS transmits different data signals to each user. This scenario does not require phase synchronization between BSs and therefore has the same backhaul requirements as conventional Massive MIMO systems, where each user is preassigned to only one BS. The scenario where all BSs are phase synchronized to send the same data is also included for comparison. We solve a total transmit power minimization problem in order to observe how much power Massive MIMO BSs consume to provide the requested quality of service (QoS) of each user. A max-min fairness optimization is also solved to provide every user with the same maximum QoS regardless of the propagation conditions.The second part of the thesis considers a joint pilot design and uplink (UL) power control problem in multi-cell Massive MIMO. The main motivation for this work is that the pilot assignment and pilot power allocation is momentous in Massive MIMO since the BSs are supposed to construct linear detection and precoding vectors from the channel estimates. Pilot contamination between pilot-sharing users leads to more interference during data transmission. The pilot design is more difficult if the pilot signals are reused frequently in space, as in Massive MIMO, which leads to greater pilot contamination effects. Related works have only studied either the pilot assignment or the pilot power control, but not the joint optimization. Furthermore, the pilot assignment is usually formulated as a combinatorial problem leading to prohibitive computational complexity. Therefore, in the second part of this thesis, a new pilot design is proposed to overcome such challenges by treating the pilot signals as continuous optimization variables. We use those pilot signals to solve different max-min fairness optimization problems with either ideal hardware or hardware impairments.
|
|
| 3. |
- de Carvalho, Elisabeth, et al.
(författare)
-
Random Pilot and Data Access in Massive MIMO for Machine-Type Communications
- 2017
-
Ingår i: IEEE Transactions on Wireless Communications. - : IEEE-INST ELECTRICAL ELECTRONICS ENGINEERS INC. - 1536-1276 .- 1558-2248. ; 16:12, s. 7703-7717
-
Tidskriftsartikel (refereegranskat)abstract
- A massive MIMO system, represented by a base station with hundreds of antennas, is capable of spatially multiplexing many devices and thus naturally suited to serve dense crowds of wireless devices in emerging applications, such as machine-type communications. Crowd scenarios pose new challenges in the pilot-based acquisition of channel state information and call for pilot access protocols that match the intermittent pattern of device activity. A joint pilot assignment and data transmission protocol based on random access is proposed in this paper for the uplink of a massive MIMO system. The protocol relies on the averaging across multiple transmission slots of the pilot collision events that result from the random access process. We derive new uplink sum rate expressions that take pilot collisions, intermittent device activity, and interference into account. Simplified bounds are obtained and used to optimize the device activation probability and pilot length. A performance analysis indicates how performance scales as a function of the number of antennas and the transmission slot duration.
|
|
| 4. |
- Do, Tan Tai, et al.
(författare)
-
Jamming Resistant Receivers For Massive MIMO
- 2017
-
Ingår i: 2017 IEEE INTERNATIONAL CONFERENCE ON ACOUSTICS, SPEECH AND SIGNAL PROCESSING (ICASSP). - : IEEE. - 9781509041176 - 9781509041183 ; , s. 3619-3623
-
Konferensbidrag (refereegranskat)abstract
- We design jamming resistant receivers to enhance the robustness of a massive MIMO uplink channel against jamming. In the pilot phase, we estimate not only the desired channel, but also the jamming channel by exploiting purposely unused pilot sequences. The jamming channel estimate is used to construct the linear receive filter to reduce impact that jamming has on the achievable rates. The performance of the proposed scheme is analytically and numerically evaluated. These results show that the proposed scheme greatly improves the rates, as compared to conventional receivers. Moreover, the proposed schemes still work well with stronger jamming power.
|
|
