1. |
- Badelek, B, et al.
(author)
-
The photon collider at TESLA
- 2004
-
In: International Journal of Modern Physics A. - 0217-751X. ; 19:30, s. 5097-5186
-
Research review (peer-reviewed)abstract
- High energy photon colliders (gammagamma,gammae) are based on e(-)e(-) linear colliders where high energy photons are produced using Compton scattering of laser light on high energy electrons just before the interaction point. This paper is a part of the Technical Design Report of the linear collider TESLA.(1) Physics program, possible parameters and some technical aspects of the photon collider at TESLA are discussed.
|
|
2. |
|
|
3. |
|
|
4. |
|
|
5. |
- Laux, M., et al.
(author)
-
Arcing at B4C-covered limiters exposed to a SOL-plasma
- 2003
-
In: Journal of Nuclear Materials. - 0022-3115 .- 1873-4820. ; 313, s. 62-66
-
Journal article (peer-reviewed)abstract
- Plasma sprayed B4C-layers considered as wall coatings for the W7X stellarator have been studied during and after exposure to TEXTOR and after arcing experiments in vacuum. Arcing through the B4C layer occurred favoured by high power fluxes and not restricted to less stable phases. But this arcing implies an especially noisy scrape-off layer (SOL). Instead of moving retrograde in the external magnetic field, the arc spot on the B4C-layer sticks to the same location for its whole lifetime. Consequently, the arc erodes the entire B4C layer, finally burning down to the Cu substrate. In the neighbourhood of craters the surface contains Cu originating from those craters. This material, hauled to the surface by the arc, is subject to subsequent erosion, transport, and redeposition by the SOL-plasma. The behaviour of arcs on B4C is Most probably caused by the peculiar temperature dependences of the electrical and heat conductivity of B4C.
|
|
6. |
|
|
7. |
|
|
8. |
|
|
9. |
|
|
10. |
|
|