| 1. |
- Adloff, C, et al.
(author)
-
A measurement of the t dependence of the helicity structure of diffractive rho meson electroproduction at HERA
- 2002
-
In: Physics Letters. Section B: Nuclear, Elementary Particle and High-Energy Physics. - 0370-2693. ; 539:1-2, s. 25-39
-
Journal article (peer-reviewed)abstract
- The helicity structure of the diffractive electroproduction of rho mesons, e + p --> e + rho + Y, is studied in a previously unexplored region of large four-momentum transfer squared at the proton vertex, t: 0 < t' < 3 GeV2, where t' = - min. The data used are collected with the HI detector at HERA in the kinematic domain 2.5 < Q(2) < 60 GeV2, 40 < W < 120 GeV No t dependence of the r(00)(04) spin density matrix element is found. A significant t dependent helicity non-conservation from the virtual photon to the rho meson is observed for the spin density matrix element combinations r(00)(5) + 2r(11)(5) and r(00)(1) + 2r(11)(1). These t dependences are consistently described by a perturbative QCD model based on the exchange of two gluons.
|
|
| 2. |
- Adloff, C, et al.
(author)
-
Energy flow and rapidity gaps between jets in photoproduction at HERA
- 2002
-
In: European Physical Journal C. Particles and Fields. - : Springer Science and Business Media LLC. - 1434-6044. ; 24:4, s. 517-527
-
Journal article (peer-reviewed)abstract
- Dijet events in photon-proton collisions in which there is a large pseudorapidity separation, Deltaeta > 2.5 between the two highest E-T jets are studied with the H1 detector at HERA. The inclusive dijet cross sections are measured as functions of the longitudinal momentum fractions of the proton and photon which participate in the production of the jets, x(p)(jets) and x(gamma)(jets) respectively, Deltaeta, the pseudorapidity P separation between the two highest E-T jets, and E-T(gap), the total summed transverse energy between the jets. Rapidity gap events are defined as events in which E-T(gap) is less than E-T(cut), for E-T(cut) varied between jets 0.5 and 2.0 GeV. The fraction of dijet events with a rapidity gap is measured differentially in Deltaeta, x(p)(jets) and x(gamma)(jets). An excess of events with rapidity gaps at low values of E-T(cut) is observed above the expectation from standard photoproduction processes. This excess can be explained by the exchange of a strongly interacting colour singlet object between the jets.
|
|
| 3. |
- Adloff, C, et al.
(author)
-
Measurement of D*(+/-) meson production and F-2(c) in deep-inelastic scattering at HERA
- 2002
-
In: Physics Letters. Section B: Nuclear, Elementary Particle and High-Energy Physics. - 0370-2693. ; 528:3-4, s. 199-214
-
Journal article (peer-reviewed)abstract
- The inclusive production of D*+/-(2010) mesons in deep-inelastic scattering is studied with the HI detector at HERA. In the kinematic region 1 < Q(2) < 100 GeV2 and 0.05 < y < 0.7 an e(+) p cross section for inclusive D*+/- meson production of 8.50 +/- 0.42(stat.)(-100)(+1.21)(syst.) nb is measured in the visible range p(tD*) > 1.5 GeV and eta(D*) < 1.5. Single and double differential inclusive D*+/- meson cross sections are compared to perturbative QCD calculations in two different evolution schemes, The charm contribution to the proton structure, F-c(2)(x, Q(2)), is determined by extrapolating the visible charm cross section to the full phase space. This contribution is found to rise from about 10% at Q(2) = 1.5 GeV2 to more than 25% at Q(2) = 60 GeV2 corresponding to x values ranging from 5 x 10(-5) to 3 x 10(-3). (C) 2002 Elsevier Science B.V. All rights reserved.
|
|
| 4. |
- Adloff, C, et al.
(author)
-
Measurement of dijet electroproduction at small jet separation
- 2002
-
In: European Physical Journal C. Particles and Fields. - : Springer Science and Business Media LLC. - 1434-6044. ; 24:1, s. 33-41
-
Journal article (peer-reviewed)abstract
- Deep-inelastic scattering data in the range 150 < Q(2) < 35000 GeV2 are used to investigate the minimum jet separation necessary to allow accurate description of the rate of dijet production using next-to-leading order perturbative QCD calculations. The required jet separation is found to be small, allowing about 1/3 of DIS data to be classified as dijet, as opposed to approximately 1/10 with more typical jet analyses. A number of precision measurements made using this dijet sample are well described by the calculations. The data are also described by the combination of leading order matrix elements and parton showers, as implemented in the QCD based Monte Carlo model RAPGAP.
|
|
| 5. |
- Adloff, C, et al.
(author)
-
Search for excited neutrinos at HERA
- 2002
-
In: Physics Letters. Section B: Nuclear, Elementary Particle and High-Energy Physics. - 0370-2693. ; 525:1-2, s. 9-16
-
Journal article (peer-reviewed)abstract
- We present a search for excited neutrinos using e(-) p data taken by the H1 experiment at HERA at a center-of-mass energy of 318 GeV with an integrated luminosity of 15 pb(-1). No evidence for excited neutrino production is found. Mass dependent exclusion limits are determined for the ratio of the coupling to the compositeness scale, f/Lambda, independently of the relative couplings to the SU(2) and U(1) gauge bosons. These limits extend the excluded region to higher masses than has been possible in previous searches at other colliders.
|
|
| 6. |
- Adloff, C, et al.
(author)
-
Search for odderon-induced contributions to exclusive pi(0) photoproduction at HERA
- 2002
-
In: Physics Letters. Section B: Nuclear, Elementary Particle and High-Energy Physics. - 0370-2693. ; 544:1-2, s. 35-43
-
Journal article (peer-reviewed)abstract
- A search for contributions to the reaction ep --> epi(0)N* from photon-odderon fusion in the photoproduction regime at HERA is reported, at an average photon-proton centre-of-mass energy = 215 GeV. The measurement proceeds via detection of the pi(0) decay photons, a leading neutron from the N* decay, and the scattered electron. No pi(0) signal is observed and an upper limit on the cross section for the photon-odderon fusion process of sigma(gammap --> pi(0)N*) < 49 nb at the 95% confidence level is derived, integrated over the experimentally accessible range of the squared four-momentum transfer at the nucleon vertex 0.02 < < 0.3 GeV2. This excludes a recent prediction from a calculation based on a non-perturbative QCD model of a photon-odderon fusion cross section above 200 nb. (C) 2002 Elsevier Science B.V. All rights reserved.
|
|
| 7. |
- Godfrey, Marjorie M., et al.
(author)
-
Microsystems in health care : Part 3. Planning patient-centered services.
- 2003
-
In: Joint Commission journal on quality and safety. - 1549-3741. ; 29:4, s. 159-170
-
Journal article (peer-reviewed)abstract
- BACKGROUND: Strategic focus on the clinical microsystems--the small, functional, frontline units that provide most health care to most people--is essential to designing the most efficient, population-based services. The starting place for designing or redesigning of clinical microsystems is to evaluate the four P's: the patient subpopulations that are served by the microsystem, the people who work together in the microsystem, the processes the microsystem uses to provide services, and the patterns that characterize the microsystem's functioning.GETTING STARTED: DIAGNOSING AND TREATING A CLINICAL MICROSYSTEM: Methods and tools have been developed for microsystem leaders and staff to use to evaluate the four P's--to assess their microsystem and design tests of change for improvement and innovation.PUTTING IT ALL TOGETHER: Based on its assessment--or diagnosis--a microsystem can help itself improve the things that need to be done better. Planning services is designed to decrease unnecessary variation, facilitate informed decision making, promote efficiency by continuously removing waste and rework, create processes and systems that support staff, and design smooth, effective, and safe patient care services that lead to measurably improved patient outcomes.CONCLUSION: The design of services leads to critical analysis of the resources needed for the right person to deliver the right care, in the right way, at the right time.
|
|
| 8. |
- Huber, Thomas P., et al.
(author)
-
Microsystems in health care : Part 8. Developing people and improving work life
- 2003
-
In: Joint Commission journal on quality and safety. - 1549-3741. ; 29:10, s. 512-22
-
Journal article (peer-reviewed)abstract
- BACKGROUND: The articles in the Microsystems in Health Care series have focused on the success characteristics of high-performing clinical microsystems. Realization is growing about the importance of attracting, selecting, developing, and engaging staff. By optimizing the work of all staff members and by promoting a culture where everyone matters, the microsystem can attain levels of performance not previously experienced.CASE STUDY: At Massachusetts General Hospital Downtown Associates (Boston), a primary care practice, the human resource processes are specified and predictable, from a candidate's initial contact through each staff member's orientation, performance management, and professional development. Early on, the new employee receives materials about the practice, including a practice overview, his or her typical responsibilities, the performance evaluation program, and continuous quality improvement. Ongoing training and education are supported with skill labs, special education nights, and cross-training. The performance evaluation program, used to evaluate the performance of all employees, is completed during the 90-day orientation and training, quarterly for one year, and annually.CONCLUSION: Some health care settings enjoy high morale, high quality, and high productivity, but all too often this is not the case. The case study offers an example of a microsystem that has motivated its staff and created a positive and dynamic workplace.
|
|
